dpdk: xstats vecor stuck at 0 elements
[vpp.git] / src / vnet / span / span_doc.rst
1 .. _span_doc:
2
3 Switched Port Analyzer
4 ======================
5
6 This is a memo intended to contain documentation of the VPP SPAN
7 implementation. Everything that is not directly obvious should come
8 here.
9
10 Port mirroring is used on a network switch to send a copy of network
11 packets seen on one switch port to a network monitoring connection on
12 another switch port. Can be used by network engineers or administrators
13 to measure performance, analyze and debug data or diagnose errors on a
14 network.
15
16 RX traffic node
17 ~~~~~~~~~~~~~~~
18
19 There is one static node to mirror incoming packets. \* span-input:
20 Creates a copy of incoming buffer due to incoming buffers can be reused
21 internally.
22
23 Chaining: dpdk-input -> span-input -> \* original buffer is sent to
24 ethernet-input for processing \* buffer copy is sent to interface-output
25
26 Configuration
27 ~~~~~~~~~~~~~
28
29 SPAN supports the following CLI configuration commands:
30
31 Enable/Disable SPAN (CLI)
32 ^^^^^^^^^^^^^^^^^^^^^^^^^
33
34 ::
35
36    set interface span <if-name> [disable | destination <if-name>]
37
38 : mirrored interface name destination : monitoring interface name
39 disable: delete mirroring
40
41 Enable/Disable SPAN (API)
42 ^^^^^^^^^^^^^^^^^^^^^^^^^
43
44 SPAN supports the following API configuration command:
45 sw_interface_span_enable_disable src GigabitEthernet0/8/0 dst
46 GigabitEthernet0/9/0 sw_interface_span_enable_disable src_sw_if_index 1
47 dst_sw_if_index 2
48
49 src/src_sw_if_index: mirrored interface name dst/dst_sw_if_index:
50 monitoring interface name
51
52 Remove SPAN entry (API)
53 ^^^^^^^^^^^^^^^^^^^^^^^
54
55 SPAN supports the following API configuration command:
56 sw_interface_span_enable_disable src_sw_if_index 1 dst_sw_if_index 2
57 disable
58
59 src_sw_if_index: mirrored interface name dst_sw_if_index: monitoring
60 interface name
61
62 Configuration example
63 ~~~~~~~~~~~~~~~~~~~~~
64
65 Mirror all packets on interface GigabitEthernet0/10/0 to interface
66 GigabitEthernet0/11/0.
67
68 Configure IPv4 addresses on mirrored interface: set interface ip address
69 GigabitEthernet0/10/0 192.168.1.13/24 set interface state
70 GigabitEthernet0/10/0 up
71
72 Configure IPv4 addresses on monitoring interface: set interface ip
73 address GigabitEthernet0/11/0 192.168.2.13/24 set interface state
74 GigabitEthernet0/11/0 up
75
76 Configure SPAN set span src GigabitEthernet0/10/0 dst
77 GigabitEthernet0/11/0
78
79 Operational data
80 ~~~~~~~~~~~~~~~~
81
82 Active SPAN mirroring CLI show command: show interfaces span
83
84 Active SPAN mirroring API dump command: sw_interface_span_dump