1 # Copyright (c) 2018 Cisco and/or its affiliates.
2 # Licensed under the Apache License, Version 2.0 (the "License");
3 # you may not use this file except in compliance with the License.
4 # You may obtain a copy of the License at:
6 # http://www.apache.org/licenses/LICENSE-2.0
8 # Unless required by applicable law or agreed to in writing, software
9 # distributed under the License is distributed on an "AS IS" BASIS,
10 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
11 # See the License for the specific language governing permissions and
12 # limitations under the License.
15 | Resource | resources/libraries/robot/performance/performance_setup.robot
17 | Force Tags | 3_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | MRR
18 | ... | NIC_Intel-X520-DA2 | L2XCFWD | ENCAP | VXLAN | L2OVRLAY | IP4UNRLAY
20 | Suite Setup | Set up 3-node performance topology with DUT's NIC model
21 | ... | L2 | Intel-X520-DA2
22 | Suite Teardown | Tear down 3-node performance topology
24 | Test Setup | Set up performance test
26 | Test Teardown | Tear down performance mrr test
28 | Documentation | *Raw results L2XC with VXLANoIPv4 test cases*
30 | ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology
31 | ... | with single links between nodes.
32 | ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for L2 cross-connect on TG-DUTn.
33 | ... | Eth-IPv4-VXLAN-Eth-IPv4 is applied on link between DUT1 and DUT2.
34 | ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with L2 cross-
35 | ... | connect. VXLAN tunnels are configured between L2XCs on DUT1 and DUT2.
36 | ... | DUT1 and DUT2 tested with 2p10GE NIC X520 Niantic by Intel.
37 | ... | *[Ver] TG verification:* In MaxReceivedRate test TG sends traffic
38 | ... | at line rate and reports total received/sent packets over trial period.
39 | ... | Test packets are generated by TG on links to DUTs. TG traffic profile
40 | ... | contains two L3 flow-groups (flow-group per direction, 253 flows per
41 | ... | flow-group) with all packets containing Ethernet header, IPv4 header
42 | ... | with IP protocol=61 and static payload. MAC addresses are matching MAC
43 | ... | addresses of the TG node interfaces.
44 | ... | *[Ref] Applicable standard specifications:* RFC2544, RFC7348.
47 # X520-DA2 bandwidth limit
48 | ${s_limit}= | ${10000000000}
49 | ${vxlan_overhead}= | ${50}
51 | ${traffic_profile}= | trex-sl-3n-ethip4-ip4src254
54 | Check RR for ethip4vxlan-l2xcbase
57 | | ... | [Cfg] DUT runs L2XC forwarding config with ${wt} thread(s), ${wt}\
58 | | ... | phy core(s), ${rxq} receive queue(s) per NIC port.
59 | | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
60 | | ... | trial throughput test.
62 | | [Arguments] | ${wt} | ${rxq} | ${framesize}
64 | | # Test Variables required for test execution and test teardown
65 | | Set Test Variable | ${framesize}
66 | | ${get_framesize}= | Get Frame Size | ${framesize}
67 | | ${max_rate}= | Calculate pps | ${s_limit}
68 | | ... | ${get_framesize + ${vxlan_overhead}}
70 | | Given Add '${wt}' worker threads and '${rxq}' rxqueues in 3-node single-link circular topology
71 | | And Add PCI devices to DUTs in 3-node single link topology
72 | | And Run Keyword If | ${get_framesize + ${vxlan_overhead}} < ${1522}
73 | | ... | Add no multi seg to all DUTs
74 | | And Apply startup configuration on all VPP DUTs
75 | | When Initialize L2 xconnect with VXLANoIPv4 in 3-node circular topology
76 | | Then Traffic should pass with maximum rate | ${perf_trial_duration}
77 | | ... | ${max_rate}pps | ${framesize} | ${traffic_profile}
80 | tc01-64B-1t1c-ethip4vxlan-l2xcbase-mrr
82 | | ... | [Cfg] DUT runs L2XC forwarding config with 1 thread, 1 phy core, \
83 | | ... | 1 receive queue per NIC port.
84 | | ... | [Ver] Measure MaxReceivedRate for 64B frames using single trial\
85 | | ... | throughput test.
87 | | [Tags] | 64B | 1T1C | STHREAD
89 | | [Template] | Check RR for ethip4vxlan-l2xcbase
90 | | wt=1 | rxq=1 | framesize=${64}
92 | tc02-1518B-1t1c-ethip4vxlan-l2xcbase-mrr
94 | | ... | [Cfg] DUT runs L2XC forwarding config with 1 thread, 1 phy core, \
95 | | ... | 1 receive queue per NIC port.
96 | | ... | [Ver] Measure MaxReceivedRate for 1518B frames using single trial\
97 | | ... | throughput test.
99 | | [Tags] | 1518B | 1T1C | STHREAD
101 | | [Template] | Check RR for ethip4vxlan-l2xcbase
102 | | wt=1 | rxq=1 | framesize=${1518}
104 | tc03-9000B-1t1c-ethip4vxlan-l2xcbase-mrr
106 | | ... | [Cfg] DUT runs L2XC forwarding config with 1 thread, 1 phy core, \
107 | | ... | 1 receive queue per NIC port.
108 | | ... | [Ver] Measure MaxReceivedRate for 9000B frames using single trial\
109 | | ... | throughput test.
111 | | [Tags] | 9000B | 1T1C | STHREAD
113 | | [Template] | Check RR for ethip4vxlan-l2xcbase
114 | | wt=1 | rxq=1 | framesize=${9000}
116 | tc04-IMIX-1t1c-ethip4vxlan-l2xcbase-mrr
118 | | ... | [Cfg] DUT runs L2XC forwarding config with 1 thread, 1 phy core,\
119 | | ... | 1 receive queue per NIC port.
120 | | ... | [Ver] Measure MaxReceivedRate for IMIX_v4_1 frames using single trial\
121 | | ... | throughput test.
122 | | ... | IMIX_v4_1 = (28x64B; 16x570B; 4x1518B)
124 | | [Tags] | IMIX | 1T1C | STHREAD
126 | | [Template] | Check RR for ethip4vxlan-l2xcbase
127 | | wt=1 | rxq=1 | framesize=IMIX_v4_1
129 | tc05-64B-2t2c-ethip4vxlan-l2xcbase-mrr
131 | | ... | [Cfg] DUT runs L2XC forwarding config with 2 threads, 2 phy cores, \
132 | | ... | 1 receive queue per NIC port.
133 | | ... | [Ver] Measure MaxReceivedRate for 64B frames using single trial\
134 | | ... | throughput test.
136 | | [Tags] | 64B | 2T2C | MTHREAD
138 | | [Template] | Check RR for ethip4vxlan-l2xcbase
139 | | wt=2 | rxq=1 | framesize=${64}
141 | tc06-1518B-2t2c-ethip4vxlan-l2xcbase-mrr
143 | | ... | [Cfg] DUT runs L2XC forwarding config with 2 threads, 2 phy cores, \
144 | | ... | 1 receive queue per NIC port.
145 | | ... | [Ver] Measure MaxReceivedRate for 1518B frames using single trial\
146 | | ... | throughput test.
148 | | [Tags] | 1518B | 2T2C | MTHREAD
150 | | [Template] | Check RR for ethip4vxlan-l2xcbase
151 | | wt=2 | rxq=1 | framesize=${1518}
153 | tc07-9000B-2t2c-ethip4vxlan-l2xcbase-mrr
155 | | ... | [Cfg] DUT runs L2XC forwarding config with 2 threads, 2 phy cores, \
156 | | ... | 1 receive queue per NIC port.
157 | | ... | [Ver] Measure MaxReceivedRate for 9000B frames using single trial\
158 | | ... | throughput test.
160 | | [Tags] | 9000B | 2T2C | MTHREAD
162 | | [Template] | Check RR for ethip4vxlan-l2xcbase
163 | | wt=2 | rxq=1 | framesize=${9000}
165 | tc08-IMIX-2t2c-ethip4vxlan-l2xcbase-mrr
167 | | ... | [Cfg] DUT runs L2XC forwarding config with 2 threads, 2 phy cores,\
168 | | ... | 1 receive queue per NIC port.
169 | | ... | [Ver] Measure MaxReceivedRate for IMIX_v4_1 frames using single trial\
170 | | ... | throughput test.
171 | | ... | IMIX_v4_1 = (28x64B; 16x570B; 4x1518B)
173 | | [Tags] | IMIX | 2T2C | MTHREAD
175 | | [Template] | Check RR for ethip4vxlan-l2xcbase
176 | | wt=2 | rxq=1 | framesize=IMIX_v4_1
178 | tc09-64B-4t4c-ethip4vxlan-l2xcbase-mrr
180 | | ... | [Cfg] DUT runs L2XC forwarding config with 4 threads, 4 phy cores, \
181 | | ... | 2 receive queues per NIC port.
182 | | ... | [Ver] Measure MaxReceivedRate for 64B frames using single trial\
183 | | ... | throughput test.
185 | | [Tags] | 64B | 4T4C | MTHREAD
187 | | [Template] | Check RR for ethip4vxlan-l2xcbase
188 | | wt=4 | rxq=2 | framesize=${64}
190 | tc10-1518B-4t4c-ethip4vxlan-l2xcbase-mrr
192 | | ... | [Cfg] DUT runs L2XC forwarding config with 4 threads, 4 phy cores, \
193 | | ... | 2 receive queues per NIC port.
194 | | ... | [Ver] Measure MaxReceivedRate for 1518B frames using single trial\
195 | | ... | throughput test.
197 | | [Tags] | 1518B | 4T4C | MTHREAD
199 | | [Template] | Check RR for ethip4vxlan-l2xcbase
200 | | wt=4 | rxq=2 | framesize=${1518}
202 | tc11-9000B-4t4c-ethip4vxlan-l2xcbase-mrr
204 | | ... | [Cfg] DUT runs L2XC forwarding config with 4 threads, 4 phy cores, \
205 | | ... | 2 receive queues per NIC port.
206 | | ... | [Ver] Measure MaxReceivedRate for 9000B frames using single trial\
207 | | ... | throughput test.
209 | | [Tags] | 9000B | 4T4C | MTHREAD
211 | | [Template] | Check RR for ethip4vxlan-l2xcbase
212 | | wt=4 | rxq=2 | framesize=${9000}
214 | tc12-IMIX-4t4c-ethip4vxlan-l2xcbase-mrr
216 | | ... | [Cfg] DUT runs L2XC forwarding config with 4 threads, 4 phy cores,\
217 | | ... | 2 receive queue per NIC port.
218 | | ... | [Ver] Measure MaxReceivedRate for IMIX_v4_1 frames using single trial\
219 | | ... | throughput test.
220 | | ... | IMIX_v4_1 = (28x64B; 16x570B; 4x1518B)
222 | | [Tags] | IMIX | 4T4C | MTHREAD
224 | | [Template] | Check RR for ethip4vxlan-l2xcbase
225 | | wt=4 | rxq=2 | framesize=IMIX_v4_1