| Test Setup | Setup all DUTs before test
| Test Teardown | Run Keywords | Remove startup configuration of VPP from all DUTs
| ... | AND | Show vpp trace dump on all DUTs
-| Documentation | *Reference NDR throughput L2XC verify test cases*
+| Documentation | *Reference NDR throughput L2XC with 802.1q verify test cases*
| ...
| ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology
| ... | with single links between nodes.
-| ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for L2 switching of IPv4. Dot1q
+| ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for L2 cross connect. 802.1q
| ... | tagging is applied on link between DUT1 and DUT2.
| ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with L2 cross-
| ... | connect. DUT1 and DUT2 tested with 2p10GE NIC X520 Niantic by Intel.
| ... | DUTs' throughput at ref-NDR (reference Non Drop Rate) with zero packet
| ... | loss tolerance. Ref-NDR value is periodically updated acording to
| ... | formula: ref-NDR = 0.9x NDR, where NDR is found in RFC2544 long
-| ... | performance tests for the same DUT confiiguration. Test packets are
+| ... | performance tests for the same DUT configuration. Test packets are
| ... | generated by TG on links to DUTs. TG traffic profile contains two L3
| ... | flow-groups (flow-group per direction, 253 flows per flow-group) with
| ... | all packets containing Ethernet header, IPv4 header with IP protocol=61
-| ... | and generated payload.
+| ... | and generated payload. MAC addresses are matching MAC addresses of the
+| ... | TG node interfaces.
| ... | *[Ref] Applicable standard specifications:* RFC2544.
*** Variables ***
| ${tag_rewrite}= | pop-1
*** Test Cases ***
-| TC01: Verify 64B ref-NDR at 2x 2.9Mpps - DUT dot1q - 1thread 1core 1rxq
+| TC01: Verify 64B ref-NDR at 2x 2.9Mpps - DUT 802.1q - 1thread 1core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 1 thread, 1 phy core, \
| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 64 Byte
| | And Add all PCI devices to all DUTs
| | And Add No Multi Seg to all DUTs
| | And Apply startup configuration on all VPP DUTs
-| | And VPP interfaces in path are up
+| | And VPP interfaces in path are up in a 3-node circular topology
| | When VLAN dot1q subinterfaces initialized on 3-node topology
| | ... | ${dut1} | ${dut1_if2} | ${dut2} | ${dut2_if1} | ${subid}
| | And L2 tag rewrite method setup on interfaces
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC02: Verify 1518B ref-NDR at 2x 720kpps - DUT dot1q - 1thread 1core 1rxq
+| TC02: Verify 1518B ref-NDR at 2x 720kpps - DUT 802.1q - 1thread 1core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 1 thread, 1 phy core, \
| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 1518 Byte
| | And Add all PCI devices to all DUTs
| | And Add No Multi Seg to all DUTs
| | And Apply startup configuration on all VPP DUTs
-| | And VPP interfaces in path are up
+| | And VPP interfaces in path are up in a 3-node circular topology
| | When VLAN dot1q subinterfaces initialized on 3-node topology
| | ... | ${dut1} | ${dut1_if2} | ${dut2} | ${dut2_if1} | ${subid}
| | And L2 tag rewrite method setup on interfaces
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC03: Verify 9000B ref-NDR at 2x 120kpps - DUT dot1q - 1thread 1core 1rxq
+| TC03: Verify 9000B ref-NDR at 2x 120kpps - DUT 802.1q - 1thread 1core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 1 thread, 1 phy core, \
| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 9000 Byte
| | Given Add '1' worker threads and rxqueues '1' without HTT to all DUTs
| | And Add all PCI devices to all DUTs
| | And Apply startup configuration on all VPP DUTs
-| | And VPP interfaces in path are up
+| | And VPP interfaces in path are up in a 3-node circular topology
| | When VLAN dot1q subinterfaces initialized on 3-node topology
| | ... | ${dut1} | ${dut1_if2} | ${dut2} | ${dut2_if1} | ${subid}
| | And L2 tag rewrite method setup on interfaces
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC04: Verify 64B ref-NDR at 2x 7Mpps - DUT dot1q - 2thread 2core 1rxq
+| TC04: Verify 64B ref-NDR at 2x 7Mpps - DUT 802.1q - 2thread 2core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 2 threads, 2 phy cores, \
| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 64 Byte
| | And Add all PCI devices to all DUTs
| | And Add No Multi Seg to all DUTs
| | And Apply startup configuration on all VPP DUTs
-| | And VPP interfaces in path are up
+| | And VPP interfaces in path are up in a 3-node circular topology
| | When VLAN dot1q subinterfaces initialized on 3-node topology
| | ... | ${dut1} | ${dut1_if2} | ${dut2} | ${dut2_if1} | ${subid}
| | And L2 tag rewrite method setup on interfaces
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC05: Verify 1518B ref-NDR at 2x 720kpps - DUT dot1q - 2thread 2core 1rxq
+| TC05: Verify 1518B ref-NDR at 2x 720kpps - DUT 802.1q - 2thread 2core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 2 threads, 2 phy cores, \
| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 1518 Byte
| | And Add all PCI devices to all DUTs
| | And Add No Multi Seg to all DUTs
| | And Apply startup configuration on all VPP DUTs
-| | And VPP interfaces in path are up
+| | And VPP interfaces in path are up in a 3-node circular topology
| | When VLAN dot1q subinterfaces initialized on 3-node topology
| | ... | ${dut1} | ${dut1_if2} | ${dut2} | ${dut2_if1} | ${subid}
| | And L2 tag rewrite method setup on interfaces
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC06: Verify 9000B ref-NDR at 2x 120kpps - DUT dot1q - 2thread 2core 1rxq
+| TC06: Verify 9000B ref-NDR at 2x 120kpps - DUT 802.1q - 2thread 2core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 2 threads, 2 phy cores, \
| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 9000 Byte
| | Given Add '2' worker threads and rxqueues '1' without HTT to all DUTs
| | And Add all PCI devices to all DUTs
| | And Apply startup configuration on all VPP DUTs
-| | And VPP interfaces in path are up
+| | And VPP interfaces in path are up in a 3-node circular topology
| | When VLAN dot1q subinterfaces initialized on 3-node topology
| | ... | ${dut1} | ${dut1_if2} | ${dut2} | ${dut2_if1} | ${subid}
| | And L2 tag rewrite method setup on interfaces
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC07: Verify 64B ref-NDR at 2x 11Mpps - DUT dot1q - 4thread 4core 2rxq
+| TC07: Verify 64B ref-NDR at 2x 11Mpps - DUT 802.1q - 4thread 4core 2rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 4 threads, 4 phy cores, \
| | ... | 2 receive queues per NIC port. [Ver] Verify ref-NDR for 64 Byte
| | And Add all PCI devices to all DUTs
| | And Add No Multi Seg to all DUTs
| | And Apply startup configuration on all VPP DUTs
-| | And VPP interfaces in path are up
+| | And VPP interfaces in path are up in a 3-node circular topology
| | When VLAN dot1q subinterfaces initialized on 3-node topology
| | ... | ${dut1} | ${dut1_if2} | ${dut2} | ${dut2_if1} | ${subid}
| | And L2 tag rewrite method setup on interfaces
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC08: Verify 1518B ref-NDR at 2x 720kpps - DUT dot1q - 4thread 4core 2rxq
+| TC08: Verify 1518B ref-NDR at 2x 720kpps - DUT 802.1q - 4thread 4core 2rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 4 threads, 4 phy cores, \
| | ... | 2 receive queues per NIC port. [Ver] Verify ref-NDR for 1518 Byte
| | And Add all PCI devices to all DUTs
| | And Add No Multi Seg to all DUTs
| | And Apply startup configuration on all VPP DUTs
-| | And VPP interfaces in path are up
+| | And VPP interfaces in path are up in a 3-node circular topology
| | When VLAN dot1q subinterfaces initialized on 3-node topology
| | ... | ${dut1} | ${dut1_if2} | ${dut2} | ${dut2_if1} | ${subid}
| | And L2 tag rewrite method setup on interfaces
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC09: Verify 9000B ref-NDR at 2x 120kpps - DUT dot1q - 4thread 4core 2rxq
+| TC09: Verify 9000B ref-NDR at 2x 120kpps - DUT 802.1q - 4thread 4core 2rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 4 threads, 4 phy cores, \
| | ... | 2 receive queues per NIC port. [Ver] Verify ref-NDR for 9000 Byte
| | Given Add '4' worker threads and rxqueues '2' without HTT to all DUTs
| | And Add all PCI devices to all DUTs
| | And Apply startup configuration on all VPP DUTs
-| | And VPP interfaces in path are up
+| | And VPP interfaces in path are up in a 3-node circular topology
| | When VLAN dot1q subinterfaces initialized on 3-node topology
| | ... | ${dut1} | ${dut1_if2} | ${dut2} | ${dut2_if1} | ${subid}
| | And L2 tag rewrite method setup on interfaces