+First find the bdf of the C62x device::
+
+ lspci -d:37c8
+
+You should see output similar to::
+
+ 1a:00.0 Co-processor: Intel Corporation Device 37c8
+ 3d:00.0 Co-processor: Intel Corporation Device 37c8
+ 3f:00.0 Co-processor: Intel Corporation Device 37c8
+
+For each c62x device there are 3 PFs.
+Using the sysfs, for each PF, enable the 16 VFs::
+
+ echo 16 > /sys/bus/pci/drivers/c6xx/0000\:1a\:00.0/sriov_numvfs
+
+If you get an error, it's likely you're using a QAT kernel driver earlier than kernel 4.5.
+
+To verify that the VFs are available for use - use ``lspci -d:37c9`` to confirm
+the bdf of the 48 VF devices are available per ``C62x`` device.
+
+To complete the installation - follow instructions in `Binding the available VFs to the DPDK UIO driver`_.
+
+For **Intel QuickAssist Technology C3xxx**:
+Assuming you are running on at least a 4.5 kernel, you can use the stock kernel.org QAT
+driver to start the QAT hardware.
+
+The steps below assume you are:
+
+* Running DPDK on a platform with one ``C3xxx`` device.
+* On a kernel at least version 4.5.
+
+In BIOS ensure that SRIOV is enabled and either
+a) disable VT-d or
+b) enable VT-d and set ``"intel_iommu=on iommu=pt"`` in the grub file.
+
+Ensure the QAT driver is loaded on your system, by executing::
+
+ lsmod | grep qat
+
+You should see the following output::
+
+ qat_c3xxx 16384 0
+ intel_qat 122880 1 qat_c3xxx
+
+Next, you need to expose the Virtual Functions (VFs) using the sysfs file system.
+
+First find the bdf of the physical function (PF) of the C3xxx device
+
+ lspci -d:19e2
+
+You should see output similar to::
+
+ 01:00.0 Co-processor: Intel Corporation Device 19e2
+
+For c3xxx device there is 1 PFs.
+Using the sysfs, enable the 16 VFs::
+
+ echo 16 > /sys/bus/pci/drivers/c3xxx/0000\:01\:00.0/sriov_numvfs
+
+If you get an error, it's likely you're using a QAT kernel driver earlier than kernel 4.5.
+
+To verify that the VFs are available for use - use ``lspci -d:19e3`` to confirm
+the bdf of the 16 VF devices are available per ``C3xxx`` device.
+To complete the installation - follow instructions in `Binding the available VFs to the DPDK UIO driver`_.