+- ``rxq_cqe_comp_en`` parameter [int]
+
+ A nonzero value enables the compression of CQE on RX side. This feature
+ allows to save PCI bandwidth and improve performance at the cost of a
+ slightly higher CPU usage. Enabled by default.
+
+ Supported on:
+
+ - x86_64 with ConnectX4 and ConnectX4 LX
+ - Power8 with ConnectX4 LX
+
+- ``txq_inline`` parameter [int]
+
+ Amount of data to be inlined during TX operations. Improves latency.
+ Can improve PPS performance when PCI back pressure is detected and may be
+ useful for scenarios involving heavy traffic on many queues.
+
+ It is not enabled by default (set to 0) since the additional software
+ logic necessary to handle this mode can lower performance when back
+ pressure is not expected.
+
+- ``txqs_min_inline`` parameter [int]
+
+ Enable inline send only when the number of TX queues is greater or equal
+ to this value.
+
+ This option should be used in combination with ``txq_inline`` above.
+
+- ``txq_mpw_en`` parameter [int]
+
+ A nonzero value enables multi-packet send (MPS) for ConnectX-4 Lx and
+ enhanced multi-packet send (Enhanced MPS) for ConnectX-5. MPS allows the
+ TX burst function to pack up multiple packets in a single descriptor
+ session in order to save PCI bandwidth and improve performance at the
+ cost of a slightly higher CPU usage. When ``txq_inline`` is set along
+ with ``txq_mpw_en``, TX burst function tries to copy entire packet data
+ on to TX descriptor instead of including pointer of packet only if there
+ is enough room remained in the descriptor. ``txq_inline`` sets
+ per-descriptor space for either pointers or inlined packets. In addition,
+ Enhanced MPS supports hybrid mode - mixing inlined packets and pointers
+ in the same descriptor.
+
+ This option cannot be used in conjunction with ``tso`` below. When ``tso``
+ is set, ``txq_mpw_en`` is disabled.
+
+ It is currently only supported on the ConnectX-4 Lx and ConnectX-5
+ families of adapters. Enabled by default.
+
+- ``txq_mpw_hdr_dseg_en`` parameter [int]
+
+ A nonzero value enables including two pointers in the first block of TX
+ descriptor. This can be used to lessen CPU load for memory copy.
+
+ Effective only when Enhanced MPS is supported. Disabled by default.
+
+- ``txq_max_inline_len`` parameter [int]
+
+ Maximum size of packet to be inlined. This limits the size of packet to
+ be inlined. If the size of a packet is larger than configured value, the
+ packet isn't inlined even though there's enough space remained in the
+ descriptor. Instead, the packet is included with pointer.
+
+ Effective only when Enhanced MPS is supported. The default value is 256.
+
+- ``tso`` parameter [int]
+
+ A nonzero value enables hardware TSO.
+ When hardware TSO is enabled, packets marked with TCP segmentation
+ offload will be divided into segments by the hardware.
+
+ Disabled by default.
+