Imported Upstream version 16.07-rc4

[deb_dpdk.git] / doc / guides / sample_app_ug / tep_termination.rst

diff --git a/doc/guides/sample_app_ug/tep_termination.rst b/doc/guides/sample_app_ug/tep_termination.rst
index 2d86a03..c3d1e97 100644 (file)
--- a/doc/guides/sample_app_ug/tep_termination.rst
+++ b/doc/guides/sample_app_ug/tep_termination.rst
@@ -59,8 +59,8 @@ This allows network isolation, QOS, etc to be provided on a per client basis.
 In a typical setup, the network overlay tunnel is terminated at the Virtual/Tunnel End Point (VEP/TEP).
 The TEP is normally located at the physical host level ideally in the software switch.
 Due to processing constraints and the inevitable bottleneck that the switch
 In a typical setup, the network overlay tunnel is terminated at the Virtual/Tunnel End Point (VEP/TEP).
 The TEP is normally located at the physical host level ideally in the software switch.
 Due to processing constraints and the inevitable bottleneck that the switch

-becomes the ability to offload overlay support features becomes an important requirement.
-Intel® XL710 10/40 G Ethernet network card provides hardware filtering
+becomes, the ability to offload overlay support features becomes an important requirement.
+Intel® XL710 10/40 Gigabit Ethernet network card provides hardware filtering

 and offload capabilities to support overlay networks implementations such as MAC in UDP and MAC in GRE.
 
 Sample Code Overview
 and offload capabilities to support overlay networks implementations such as MAC in UDP and MAC in GRE.
 
 Sample Code Overview


@@ -131,14 +131,14 @@ Compiling the Sample Code
 
     .. code-block:: console
 
 
     .. code-block:: console
 

-        CONFIG_RTE_LIBRTE_VHOST=n
+        CONFIG_RTE_LIBRTE_VHOST=y

 
     vhost user is turned on by default in the configure file config/common_linuxapp.
     To enable vhost cuse, disable vhost user.
 
     .. code-block:: console
 
 
     vhost user is turned on by default in the configure file config/common_linuxapp.
     To enable vhost cuse, disable vhost user.
 
     .. code-block:: console
 

-        CONFIG_RTE_LIBRTE_VHOST_USER=y
+        CONFIG_RTE_LIBRTE_VHOST_USER=n

 
      After vhost is enabled and the implementation is selected, build the vhost library.
 
 
      After vhost is enabled and the implementation is selected, build the vhost library.