-
-Set Interface Mac Address
-=========================
-The '*set interface mac address* ' command allows to set MAC address of
-given interface. In case of NIC interfaces the one has to support MAC
-address change. A side effect of MAC address change are changes of MAC
-addresses in FIB tables (ipv4 and ipv6).
-
-
-Summary/Usage
--------------
-
-.. code-block:: shell
-
- set interface mac address <interface> <mac-address>.
-
-Examples
---------
-
-Examples of how to change MAC Address of interface:
-
-.. code-block:: console
-
- vpp# set interface mac address GigabitEthernet0/8/0 aa:bb:cc:dd:ee:01
- vpp# set interface mac address host-vpp0 aa:bb:cc:dd:ee:02
- vpp# set interface mac address tap-0 aa:bb:cc:dd:ee:03
- vpp# set interface mac address pg0 aa:bb:cc:dd:ee:04
-
-Set Interface Mtu
-=================
-
-.. toctree::
-
-Summary/Usage
--------------
-
-.. code-block:: shell
-
- set interface mtu [packet|ip4|ip6|mpls] <value> <interface>.
-
-Set Interface Promiscuous
-=========================
-
-Summary/Usage
--------------
-
-.. code-block:: shell
-
- set interface promiscuous [on|off] <interface>.
-
-.. _setintstate:
-
-Set Interface State
-===================
-This command is used to change the admin state (up/down) of an
-interface.
-
-If an interface is down, the optional '*punt*' flag can also be set. The
-'*punt*' flag implies the interface is disabled for forwarding but punt
-all traffic to slow-path. Use the '*enable*' flag to clear '*punt*' flag
-(interface is still down).
-
-Summary/Usage
--------------
-
-.. code-block:: shell
-
- set interface state <interface> [up|down|punt|enable].
-
-Examples
---------
-
-Example of how to configure the admin state of an interface to **up**:
-
-.. code-block:: console
-
- vpp# set interface state GigabitEthernet2/0/0 up
-
-Example of how to configure the admin state of an interface to **down**:
-
-.. code-block:: console
-
- vpp# set interface state GigabitEthernet2/0/0 down