- # dpdk {
- ## Change default settings for all intefaces
- # dev default {
- ## Number of receive queues, enables RSS
- ## Default is 1
- # num-rx-queues 3
-
- ## Number of transmit queues, Default is equal
- ## to number of worker threads or 1 if no workers treads
- # num-tx-queues 3
-
- ## Number of descriptors in transmit and receive rings
- ## increasing or reducing number can impact performance
- ## Default is 1024 for both rx and tx
- # num-rx-desc 512
- # num-tx-desc 512
-
- ## VLAN strip offload mode for interface
- ## Default is off
- # vlan-strip-offload on
- # }
-
- ## Whitelist specific interface by specifying PCI address
- # dev 0000:02:00.0
-
- ## Whitelist specific interface by specifying PCI address and in
- ## addition specify custom parameters for this interface
- # dev 0000:02:00.1 {
- # num-rx-queues 2
- # }
-
- ## Specify bonded interface and its slaves via PCI addresses
- ##
- ## Bonded interface in XOR load balance mode (mode 2) with L3 and L4 headers
- # vdev eth_bond0,mode=2,slave=0000:02:00.0,slave=0000:03:00.0,xmit_policy=l34
- # vdev eth_bond1,mode=2,slave=0000:02:00.1,slave=0000:03:00.1,xmit_policy=l34
- ##
- ## Bonded interface in Active-Back up mode (mode 1)
- # vdev eth_bond0,mode=1,slave=0000:02:00.0,slave=0000:03:00.0
- # vdev eth_bond1,mode=1,slave=0000:02:00.1,slave=0000:03:00.1
-
- ## Change UIO driver used by VPP, Options are: igb_uio, vfio-pci,
- ## uio_pci_generic or auto (default)
- # uio-driver vfio-pci
-
- ## Disable mutli-segment buffers, improves performance but
- ## disables Jumbo MTU support
- # no-multi-seg
-
- ## Increase number of buffers allocated, needed only in scenarios with
- ## large number of interfaces and worker threads. Value is per CPU socket.
- ## Default is 16384
- # num-mbufs 128000
-
- ## Change hugepages allocation per-socket, needed only if there is need for
- ## larger number of mbufs. Default is 256M on each detected CPU socket
- # socket-mem 2048,2048
-
- ## Disables UDP / TCP TX checksum offload. Typically needed for use
- ## faster vector PMDs (together with no-multi-seg)
- # no-tx-checksum-offload
- # }
-
-
- # plugins {
- ## Adjusting the plugin path depending on where the VPP plugins are
- # path /home/bms/vpp/build-root/install-vpp-native/vpp/lib64/vpp_plugins
-
- ## Disable all plugins by default and then selectively enable specific plugins
- # plugin default { disable }
- # plugin dpdk_plugin.so { enable }
- # plugin acl_plugin.so { enable }
-
- ## Enable all plugins by default and then selectively disable specific plugins
- # plugin dpdk_plugin.so { disable }
- # plugin acl_plugin.so { disable }
- # }
-
- ## Alternate syntax to choose plugin path
- # plugin_path /home/bms/vpp/build-root/install-vpp-native/vpp/lib64/vpp_plugins
-
-**SW Crypto Device**