-#. Added VPP performance tests\r
-\r
- - **Container Topologies Orchestrated by K8s with VPP memif tests**\r
-\r
- - Added tests with VPP in L2 Cross-Connect and Bridge-Domain\r
- configurations containers, with service chain topologies orchestrated by\r
- Kubernetes. Added following forwarding topologies: i) "Parallel" with\r
- packets flowing from NIC via VPP to container and back to VPP and NIC;\r
- ii) "Chained" a.k.a. "Snake" with packets flowing via VPP to container,\r
- back to VPP, to next container, back to VPP and so on until the last\r
- container in chain, then back to VPP and NIC; iii) "Horizontal" with\r
- packets flowing via VPP to container, then via "horizontal" memif to\r
- next container, and so on until the last container, then back to VPP and\r
- NIC;.\r
-\r
- - **VPP TCP/IP stack**\r
-\r
- - Added tests for VPP TCP/IP stack using VPP built-in HTTP server.\r
- WRK traffic generator is used as a client-side;\r
-\r
- - **SRv6 tests**\r
-\r
- - Initial SRv6 (Segment Routing IPv6) tests verifying performance of\r
- IPv6 and SRH (Segment Routing Header) encapsulation, decapsulation,\r
- lookups and rewrites based on configured End and End.DX6 SRv6 egress\r
- functions;\r
-\r
- - **IPSecSW tests**\r
-\r
- - SW computed IPSec encryption with AES-GCM, CBC-SHA1 ciphers, in\r
- combination with IPv4 routed-forwarding;\r
-\r
-#. Presentation and Analytics Layer\r
-\r
- - Added throughput speedup analysis for multi-core and multi-thread\r
- VPP tests into Presentation and Analytics Layer (PAL) for automated\r
- CSIT test results analysis;\r
-\r
-#. Other improvements\r
-\r
- - **Framework optimizations**\r
-\r
- - Ability to run CSIT framework on ARM architecture;\r
-\r
- - Overall stability improvements;\r
-\r
-Performance Improvements\r
-------------------------\r
-\r
-Substantial improvements in measured packet throughput have been observed in a\r
-number of CSIT |release| tests listed below, with relative increase of\r
-double-digit percentage points. Relative improvements for this release are\r
-calculated against the test results listed in CSIT |release-1| report. The\r
-comparison is calculated between the mean values based on collected and\r
-archived test results' samples for involved VPP releases. Standard deviation\r
-has been also listed for CSIT |release|. Performance numbers since release\r
-VPP-16.09 are provided for reference.\r
-\r
-NDR Throughput\r
-~~~~~~~~~~~~~~\r
-\r
-Non-Drop Rate Throughput discovery tests:\r
-\r
-.. only:: html\r
-\r
- .. csv-table::\r
- :align: center\r
- :file: performance_improvements/performance_improvements_ndr_top.csv\r
-\r
-.. only:: latex\r
-\r
- .. raw:: latex\r
-\r
- \makeatletter\r
- \csvset{\r
- perfimprovements column width/.style={after head=\csv@pretable\begin{longtable}{ m{1.5cm} m{4cm} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1}}\csv@tablehead},\r
- }\r
- \makeatother\r
-\r
- {\tiny\r
- \csvautobooklongtable[separator=comma,\r
- respect all,\r
- no check column count,\r
- perfimprovements column width=1cm,\r
- late after line={\\\hline},\r
- late after last line={\end{longtable}}\r
- ]{../_tmp/src/vpp_performance_tests/performance_improvements/performance_improvements_ndr_top.csv}\r
- }\r
-\r
-\r
-PDR Throughput\r
-~~~~~~~~~~~~~~\r
-\r
-Partial Drop Rate thoughput discovery tests with packet Loss Tolerance of 0.5%:\r
-\r
-.. only:: html\r
-\r
- .. csv-table::\r
- :align: center\r
- :file: performance_improvements/performance_improvements_pdr_top.csv\r
-\r
-.. only:: latex\r
-\r
- .. raw:: latex\r
-\r
- \makeatletter\r
- \csvset{\r
- perfimprovements column width/.style={after head=\csv@pretable\begin{longtable}{ m{1.5cm} m{4cm} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1}}\csv@tablehead},\r
- }\r
- \makeatother\r
-\r
- {\tiny\r
- \csvautobooklongtable[separator=comma,\r
- respect all,\r
- no check column count,\r
- perfimprovements column width=1cm,\r
- late after line={\\\hline},\r
- late after last line={\end{longtable}}\r
- ]{../_tmp/src/vpp_performance_tests/performance_improvements/performance_improvements_pdr_top.csv}\r
- }\r
-\r
-\r
-Measured improvements are in line with VPP code optimizations listed in\r
-`VPP-17.10 release notes\r
-<https://docs.fd.io/vpp/17.10/release_notes_1710.html>`_.\r
-\r
-Other Performance Changes\r
--------------------------\r
-\r
-Other changes in measured packet throughput, with either minor relative increase\r
-or decrease, have been observed in a number of CSIT |release| tests listed\r
-below. Relative changes are calculated against the test results listed in CSIT\r
-|release-1| report.\r
-\r
-NDR Throughput\r
-~~~~~~~~~~~~~~\r
-\r
-Non-Drop Rate Throughput discovery tests:\r
-\r
-.. only:: html\r
-\r
- .. csv-table::\r
- :align: center\r
- :file: performance_improvements/performance_improvements_ndr_low.csv\r
-\r
-.. only:: latex\r
-\r
- .. raw:: latex\r
-\r
- \makeatletter\r
- \csvset{\r
- perfimprovements column width/.style={after head=\csv@pretable\begin{longtable}{ m{1.5cm} m{4cm} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1}}\csv@tablehead},\r
- }\r
- \makeatother\r
-\r
- {\tiny\r
- \csvautobooklongtable[separator=comma,\r
- respect all,\r
- no check column count,\r
- perfimprovements column width=1cm,\r
- late after line={\\\hline},\r
- late after last line={\end{longtable}}\r
- ]{../_tmp/src/vpp_performance_tests/performance_improvements/performance_improvements_ndr_low.csv}\r
- }\r
-\r
-\r
-PDR Throughput\r
-~~~~~~~~~~~~~~\r
-\r
-Partial Drop Rate thoughput discovery tests with packet Loss Tolerance of 0.5%:\r
-\r
-.. only:: html\r
-\r
- .. csv-table::\r
- :align: center\r
- :file: performance_improvements/performance_improvements_pdr_low.csv\r
-\r
-.. only:: latex\r
-\r
- .. raw:: latex\r
-\r
- \makeatletter\r
- \csvset{\r
- perfimprovements column width/.style={after head=\csv@pretable\begin{longtable}{ m{1.5cm} m{4cm} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1}}\csv@tablehead},\r
- }\r
- \makeatother\r
-\r
- {\tiny\r
- \csvautobooklongtable[separator=comma,\r
- respect all,\r
- no check column count,\r
- perfimprovements column width=1cm,\r
- late after line={\\\hline},\r
- late after last line={\end{longtable}}\r
- ]{../_tmp/src/vpp_performance_tests/performance_improvements/performance_improvements_pdr_low.csv}\r
- }\r
-\r
+#. **Added VPP performance tests**\r
+\r
+ - **MRR tests** : New MRR tests measure the packet forwarding rate\r
+ under the maximum load offered by traffic generator over a set\r
+ trial duration, regardless of packet loss. Maximum load for\r
+ specified Ethernet frame size is set to the bi-directional link\r
+ rate. MRR tests are used for continuous performance trending and\r
+ for comparison between releases.\r
+\r
+ - **Service Chaining with SRv6** : SRv6 (Segment Routing IPv6) proxy tests\r
+ verifying performance of Endpoint to SR-unaware appliance via\r
+ masquerading (End.AM), dynamic proxy (End.AD) or static proxy (End.AS)\r
+ functions.\r
+\r
+#. **Presentation and Analytics Layer (PAL)**\r
+\r
+ - Added continuous performance measuring, trending and anomaly\r
+ detection. Includes new PAL code and Jenkins jobs for Performance\r
+ Trending (PT) and Performance Analysis (PA) producing performance\r
+ trending dashboard and trendline graphs with summary and drill-\r
+ down views across all specified tests that can be reviewed and\r
+ inspected regularly by FD.io developers and users community.\r
+\r
+#. **Test Framework Optimizations**\r
+\r
+ - **Performance tests efficiency** : Qemu build/install\r
+ optimizations, warmup phase handling, vpp restart handling.\r
+ Resulted in improved stability and reduced total execution time by\r
+ 30% for single pkt size e.g. 64B/78B.\r
+\r
+ - **General code housekeeping** : ongoing RF keywords\r
+ optimizations, removal of redundant RF keywords.\r
+\r
+Performance Changes\r
+-------------------\r
+\r
+Relative performance changes in measured packet throughput in CSIT\r
+|release| are calculated against the results from CSIT |release-1|\r
+report. Listed mean and standard deviation values are computed based on\r
+a series of the same tests executed against respective VPP releases to\r
+verify test results repeatibility, with percentage change calculated for\r
+mean values. Note that the standard deviation is quite high for a small\r
+number of packet throughput tests, what indicates poor test results\r
+repeatability and makes the relative change of mean throughput value not\r
+fully representative for these tests. The root causes behind poor\r
+results repeatibility vary between the test cases.\r
+\r
+NDR Throughput Changes\r
+~~~~~~~~~~~~~~~~~~~~~~\r
+\r
+NDR small packet throughput changes between releases are available in a CSV and\r
+pretty ASCII formats:\r
+\r
+ - `csv format for 1t1c <../_static/vpp/performance-changes-ndr-1t1c-full.csv>`_,\r
+ - `csv format for 2t2c <../_static/vpp/performance-changes-ndr-2t2c-full.csv>`_,\r
+ - `pretty ASCII format for 1t1c <../_static/vpp/performance-changes-ndr-1t1c-full.txt>`_,\r
+ - `pretty ASCII format for 2t2c <../_static/vpp/performance-changes-ndr-2t2c-full.txt>`_.\r
+\r
+PDR Throughput Changes\r
+~~~~~~~~~~~~~~~~~~~~~~\r
+\r
+NDR small packet throughput changes between releases are available in a CSV and\r
+pretty ASCII formats:\r
+\r
+ - `csv format for 1t1c <../_static/vpp/performance-changes-pdr-1t1c-full.csv>`_,\r
+ - `csv format for 2t2c <../_static/vpp/performance-changes-pdr-2t2c-full.csv>`_,\r
+ - `pretty ASCII format for 1t1c <../_static/vpp/performance-changes-pdr-1t1c-full.txt>`_,\r
+ - `pretty ASCII format for 2t2c <../_static/vpp/performance-changes-pdr-2t2c-full.txt>`_.\r
+\r
+MRR Throughput Changes\r
+~~~~~~~~~~~~~~~~~~~~~~\r
+\r
+MRR changes between releases are available in a CSV and\r
+pretty ASCII formats:\r
+\r
+ - `csv format for 1t1c <../_static/vpp/performance-changes-mrr-1t1c-full.csv>`_,\r
+ - `csv format for 2t2c <../_static/vpp/performance-changes-mrr-2t2c-full.csv>`_,\r
+ - `csv format for 4t4c <../_static/vpp/performance-changes-mrr-4t4c-full.csv>`_,\r
+ - `pretty ASCII format for 1t1c <../_static/vpp/performance-changes-mrr-1t1c-full.txt>`_,\r
+ - `pretty ASCII format for 2t2c <../_static/vpp/performance-changes-mrr-2t2c-full.txt>`_,\r
+ - `pretty ASCII format for 4t4c <../_static/vpp/performance-changes-mrr-4t4c-full.txt>`_.\r