- @param sw_if_index - software index of the new vlan's parent interface
- @param vrf_id - fib table /vrf associated with the route
- @param lookup_in_vrf -
- @param classify_table_index -
- @param create_vrf_if_needed -
- @param is_add - 1 if adding the route, 0 if deleting
- @param is_drop - Drop the packet
- @param is_unreach - Drop the packet and rate limit send ICMP unreachable
- @param is_prohibit - Drop the packet and rate limit send ICMP prohibited
- @param is_ipv6 - 0 if an ip4 route, else ip6
- @param is_local -
- @param is_classify -
- @param is_multipath - Set to 1 if this is a multipath route, else 0
- @param not_last - Is last or not last msg in group of multiple add/del msgs
- @param next_hop_weight -
- @param dst_address_length -
- @param dst_address[16] -
- @param next_hop_address[16] -
- @param next_hop_n_out_labels - the number of labels in the label stack
- @param next_hop_out_label_stack - the next-hop output label stack, outer most first
- @param next_hop_via_label - The next-hop is a resolved via a local label
+ @param is_ip6 - 1 if source address type is IPv6
+ @param is_add - 1 if add, 0 if delete
+ @param ip - prefix to match
+ @param number_of_ranges - length of low_port and high_port arrays (must match)
+ @param low_ports[32] - up to 32 low end of port range entries (must have corresponding high_ports entry)
+ @param high_ports[32] - up to 32 high end of port range entries (must have corresponding low_ports entry)
+ @param vrf_id - fib table/vrf id to associate the source and port-range check with
+ @note To specify a single port set low_port and high_port entry the same