-static clib_error_t *
-add_del_interface_table (vlib_main_t * vm,
- unformat_input_t * input, vlib_cli_command_t * cmd)
-{
- vnet_main_t *vnm = vnet_get_main ();
- clib_error_t *error = 0;
- u32 sw_if_index, table_id;
-
- sw_if_index = ~0;
-
- if (!unformat_user (input, unformat_vnet_sw_interface, vnm, &sw_if_index))
- {
- error = clib_error_return (0, "unknown interface `%U'",
- format_unformat_error, input);
- goto done;
- }
-
- if (unformat (input, "%d", &table_id))
- ;
- else
- {
- error = clib_error_return (0, "expected table id `%U'",
- format_unformat_error, input);
- goto done;
- }
-
- {
- ip4_main_t *im = &ip4_main;
- u32 fib_index;
-
- fib_index = fib_table_find_or_create_and_lock (FIB_PROTOCOL_IP4,
- table_id);
-
- //
- // FIXME-LATER
- // changing an interface's table has consequences for any connecteds
- // and adj-fibs already installed.
- //
- vec_validate (im->fib_index_by_sw_if_index, sw_if_index);
- im->fib_index_by_sw_if_index[sw_if_index] = fib_index;
-
- fib_index = mfib_table_find_or_create_and_lock (FIB_PROTOCOL_IP4,
- table_id);
- vec_validate (im->mfib_index_by_sw_if_index, sw_if_index);
- im->mfib_index_by_sw_if_index[sw_if_index] = fib_index;
- }
-
-done:
- return error;
-}
-
-/*?
- * Place the indicated interface into the supplied IPv4 FIB table (also known
- * as a VRF). If the FIB table does not exist, this command creates it. To
- * display the current IPv4 FIB table, use the command '<em>show ip fib</em>'.
- * FIB table will only be displayed if a route has been added to the table, or
- * an IP Address is assigned to an interface in the table (which adds a route
- * automatically).
- *
- * @note IP addresses added after setting the interface IP table end up in
- * the indicated FIB table. If the IP address is added prior to adding the
- * interface to the FIB table, it will NOT be part of the FIB table. Predictable
- * but potentially counter-intuitive results occur if you provision interface
- * addresses in multiple FIBs. Upon RX, packets will be processed in the last
- * IP table ID provisioned. It might be marginally useful to evade source RPF
- * drops to put an interface address into multiple FIBs.
- *
- * @cliexpar
- * Example of how to add an interface to an IPv4 FIB table (where 2 is the table-id):
- * @cliexcmd{set interface ip table GigabitEthernet2/0/0 2}
- ?*/
-/* *INDENT-OFF* */
-VLIB_CLI_COMMAND (set_interface_ip_table_command, static) =
-{
- .path = "set interface ip table",
- .function = add_del_interface_table,
- .short_help = "set interface ip table <interface> <table-id>",
-};
-/* *INDENT-ON* */
-