-CSIT Release Notes\r
-==================\r
-\r
-Changes in CSIT |release|\r
--------------------------\r
-\r
-#. **VPP performance tests**\r
-\r
- - *MRR tests* - New Maximum Receive Rate tests measure the packet\r
- forwarding rate under the maximum load offered by traffic\r
- generator over a set trial duration, regardless of packet loss.\r
- MRR tests are used for continuous performance trending and for\r
- comparison between releases.\r
-\r
- - *Service Chaining with SRv6* - New SRv6 (Segment Routing IPv6) proxy\r
- tests measure performance of SRv6 Endpoint fronting SR-unaware\r
- appliance via masquerading (End.AM), dynamic proxy (End.AD) or\r
- static proxy (End.AS) SR functions.\r
-\r
-#. **Presentation and Analytics Layer**\r
-\r
- - *Performance trending* - Added continuous performance trending and\r
- analysis. New Performance Trending and Performance Analysis jobs\r
- executed regular throughput tests, with results being subsequently\r
- analysed and trend and anomalies summarized and presented in VPP\r
- Performance Dashboard and trendline graphs.\r
-\r
-#. **Test Framework Optimizations**\r
-\r
- - *Performance tests efficiency* - Qemu build/install optimizations,\r
- warmup phase handling, vpp restart handling. Resulted in improved\r
- stability and reduced total execution time by 30% for single pkt\r
- size e.g. 64B/78B.\r
-\r
- - *General code housekeeping* - ongoing RF keywords optimizations,\r
- removal of redundant RF keywords.\r
-\r
-Performance Changes\r
--------------------\r
-\r
-Relative performance changes in measured packet throughput in CSIT\r
-|release| are calculated against the results from CSIT |release-1|\r
-report. Listed mean and standard deviation values are computed based on\r
-a series of the same tests executed against respective VPP releases to\r
-verify test results repeatibility, with percentage change calculated for\r
-mean values. Note that the standard deviation is quite high for a small\r
-number of packet throughput tests, what indicates poor test results\r
-repeatability and makes the relative change of mean throughput value not\r
-fully representative for these tests. The root causes behind poor\r
-results repeatibility vary between the test cases.\r
-\r
-NDR Changes\r
-~~~~~~~~~~~\r
-\r
-NDR small packet throughput changes between releases are available in a\r
-CSV and pretty ASCII formats:\r
-\r
- - `csv format for 1t1c <../_static/vpp/performance-changes-ndr-1t1c-full.csv>`_,\r
- - `csv format for 2t2c <../_static/vpp/performance-changes-ndr-2t2c-full.csv>`_,\r
- - `pretty ASCII format for 1t1c <../_static/vpp/performance-changes-ndr-1t1c-full.txt>`_,\r
- - `pretty ASCII format for 2t2c <../_static/vpp/performance-changes-ndr-2t2c-full.txt>`_.\r
-\r
-.. note::\r
-\r
- Test results have been generated by\r
- `FD.io test executor vpp performance jobs`_ with Robot Framework result\r
- files csit-vpp-perf-|srelease|-\*.zip `archived here <../../_static/archive/>`_.\r
-\r
-PDR Changes\r
-~~~~~~~~~~~\r
-\r
-NDR small packet throughput changes between releases are available in a\r
-CSV and pretty ASCII formats:\r
-\r
- - `csv format for 1t1c <../_static/vpp/performance-changes-pdr-1t1c-full.csv>`_,\r
- - `csv format for 2t2c <../_static/vpp/performance-changes-pdr-2t2c-full.csv>`_,\r
- - `pretty ASCII format for 1t1c <../_static/vpp/performance-changes-pdr-1t1c-full.txt>`_,\r
- - `pretty ASCII format for 2t2c <../_static/vpp/performance-changes-pdr-2t2c-full.txt>`_.\r
-\r
-.. note::\r
-\r
- Test results have been generated by\r
- `FD.io test executor vpp performance jobs`_ with Robot Framework result\r
- files csit-vpp-perf-|srelease|-\*.zip `archived here <../../_static/archive/>`_.\r
-\r
-MRR Changes\r
-~~~~~~~~~~~\r
-\r
-MRR small packet throughput changes between releases are available in a\r
-CSV and pretty ASCII formats:\r
-\r
- - `csv format for 1t1c <../_static/vpp/performance-changes-mrr-1t1c-full.csv>`_,\r
- - `csv format for 2t2c <../_static/vpp/performance-changes-mrr-2t2c-full.csv>`_,\r
- - `csv format for 4t4c <../_static/vpp/performance-changes-mrr-4t4c-full.csv>`_,\r
- - `pretty ASCII format for 1t1c <../_static/vpp/performance-changes-mrr-1t1c-full.txt>`_,\r
- - `pretty ASCII format for 2t2c <../_static/vpp/performance-changes-mrr-2t2c-full.txt>`_,\r
- - `pretty ASCII format for 4t4c <../_static/vpp/performance-changes-mrr-4t4c-full.txt>`_.\r
-\r
-.. note::\r
-\r
- Test results have been generated by\r
- `FD.io test executor vpp mrr jobs <https://jenkins.fd.io/view/csit/job/csit-vpp-perf-mrr-daily-master/>`_\r
- with Robot Framework result files csit-vpp-perf-mrr-daily-master__*__output.xml.gz\r
- `archived here <https://docs.fd.io/csit/master/trending/_static/archive/>`_.\r
-\r
-Throughput Trending\r
--------------------\r
-\r
-In addition to reporting throughput changes between VPP releases, CSIT\r
-provides continuous performance trending for VPP master branch:\r
-\r
-#. `VPP Performance Dashboard <https://docs.fd.io/csit/master/trending/introduction/index.html>`_\r
- - per VPP test case throughput trend, trend compliance and summary of\r
- detected anomalies.\r
-\r
-#. `Trending Methodology <https://docs.fd.io/csit/master/trending/methodology/index.html>`_\r
- - throughput test metrics, trend calculations and anomaly\r
- classification (progression, regression, outlier).\r
-\r
-#. `Trendline Graphs <https://docs.fd.io/csit/master/trending/trending/index.html>`_\r
- - per VPP build MRR throughput measurements against the trendline\r
- with anomaly highlights, with associated CSIT test jobs.\r
-\r
-Known Issues\r
-------------\r
-\r
-List of known issues in CSIT |release| for VPP performance tests:\r
-\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
-| # | Issue | Jira ID | Description |\r
-+===+=================================================+============+=================================================================+\r
-| 1 | Sporadic (1 in 200) NDR discovery test failures | CSIT-570 | DPDK reporting rx-errors, indicating L1 issue. Suspected issue |\r
-| | on x520. | | with HW combination of X710-X520 in LF testbeds. Not observed |\r
-| | | | outside of LF testbeds. |\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
-| 2 | Lower than expected NDR throughput of DPDK | CSIT-571 | Suspected NIC firmware or DPDK driver issue affecting NDR and |\r
-| | testpmd and VPP L2 path NDR throughput with | | PDR throughput on XL710 and X710 NICs. |\r
-| | xl710 and x710 NICs, compared to x520 NICs. | | |\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
-| 3 | Tagged Ethernet dot1q and dot1ad L2 path | CSIT-1066 | Tagged Ethernet dot1q and dot1ad L2 path throughput regression: |\r
-| | throughput regression. | | NDR -2%..-5%, PDR -2%..-6%, MRR. Affects l2xc and l2bd |\r
-| | | | performance tests. |\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
-| 4 | IPSec (software, no QAT HW) throughput | CSIT-1064 | IPSec throughput regression: NDR -3%..-8%, PDR -2%..-8%, MRR |\r
-| | regression. | | -3%..-7%. Affects IPSec SW tests, QAT HW tests not affected. |\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
-| 5 | High failure rate of creating working container | CSIT-1065 | About 20% of orchestrated container topology tests failing data |\r
-| | topologies with K8s/Ligato orchestration. | | plane verification indicating configuration issue. Suspected |\r
-| | | | issue with Ligato vpp-agent. |\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
+Release Notes
+=============
+
+Changes in |csit-release|
+-------------------------
+
+#. VPP PERFORMANCE TESTS
+
+ - **Service density 2n-skx tests**: Added higher NF density tests with
+ 802.1q (vlan) and 802.1ad (vxlan) encapsulation from Traffic Generator.
+
+ - **GBP tests**: Added GBP routing test cases with 802.1q (vlan) external
+ traffic.
+
+ - **AVF IPv4 scale tests**: Increased coverage of AVF IPv4 base and scale
+ test cases.
+
+ - **2n-skx tests**: Increased coverage of selected (COP, iACL, Policer)
+ test cases.
+
+ - **IPsec scale tests**: Added IPsec interface mode scale tests with
+ 1, 40, 400, 1000, 5000, 10000, 20000, 40000, 60000 tunnels. Removed DPDK
+ backend dependency.
+
+#. TEST FRAMEWORK
+
+ - **CSIT PAPI Support**: Finished conversion of CSIT VAT L1 keywords to
+ PAPI L1 KWs in CSIT using VPP Python bindings. Redesign of key components
+ of PAPI Executor and PAPI history. Currently the only exception is
+ usage of VAT command for scale configuration.
+
+ - **General Code Housekeeping**: Ongoing RF keywords optimizations,
+ removal of redundant RF keywords and aligning of suite/test
+ setup/teardowns.
+
+
+#. PRESENTATION AND ANALYTICS LAYER
+
+ - **Graphs Layout Improvements**: Improved performance graphs layout
+ for better readibility and maintenance: test grouping, axis
+ labels, descriptions, other informative decoration.
+
+.. raw:: latex
+
+ \clearpage
+
+.. _vpp_known_issues:
+
+Known Issues
+------------
+
+List of known issues in |csit-release| for VPP performance tests:
+
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
+| # | JiraID | Issue Description |
++====+=========================================+==========================================================================================================+
+| 1 | `CSIT-570 | Sporadic (1 in 200) NDR discovery test failures on x520. DPDK reporting rx-errors, indicating L1 issue. |
+| | <https://jira.fd.io/browse/CSIT-570>`_ | Suspected issue with HW combination of X710-X520 in LF testbeds. Not observed outside of LF testbeds. |
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
+| 2 | `CSIT-1503 | [`TRex-519 <https://trex-tgn.cisco.com/youtrack/issue/trex-519>`_] XL710/XXV710 with FW 6.0.1 will have |
+| | <https://jira.fd.io/browse/CSIT-1503>`_ | Rx drop rate of 27MPPS. |
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
+| 3 | `CSIT-1499 | AVF tests are sporadically failing on initialization of AVF interface. |
+| | <https://jira.fd.io/browse/CSIT-1499>`_ | |
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+