check_adj_port_range_x1 (const protocol_port_range_dpo_t * ppr_dpo,
u16 dst_port, u32 next)
{
+#ifdef CLIB_HAVE_VEC128
u16x8 key = u16x8_splat (dst_port);
+#endif
int i;
if (NULL == ppr_dpo || dst_port == 0)
for (i = 0; i < ppr_dpo->n_used_blocks; i++)
- if (!u16x8_is_all_zero ((ppr_dpo->blocks[i].low.as_u16x8 >= key) &
- (ppr_dpo->blocks[i].hi.as_u16x8 <= key)))
+#ifdef CLIB_HAVE_VEC128
+ if (!u16x8_is_all_zero ((ppr_dpo->blocks[i].low.as_u16x8 <= key) &
+ (ppr_dpo->blocks[i].hi.as_u16x8 >= key)))
return next;
+#else
+ {
+ for (int j = 0; j < 8; j++)
+ {
+ if ((ppr_dpo->blocks[i].low.as_u16[j] <= dst_port) &&
+ (ppr_dpo->blocks[i].hi.as_u16[j] >= dst_port))
+ return next;
+ }
+ };
+#endif
return IP4_SOURCE_AND_PORT_RANGE_CHECK_NEXT_DROP;
}
* @cliexend
*
* Example of how to enable range checking on TX:
- * @cliexcmd{set interface ip source-and-port-range-check GigabitEthernet2/0/0 udp-in-vrf 7}
+ * @cliexcmd{set interface ip source-and-port-range-check GigabitEthernet2/0/0
+ * udp-in-vrf 7}
*
* Example of graph node after range checking is enabled:
* @cliexstart{show vlib graph ip4-source-and-port-range-check-tx}
* interface-output [1]
* @cliexend
*
- * Example of how to display the features enabed on an interface:
+ * Example of how to display the features enabled on an interface:
* @cliexstart{show ip interface features GigabitEthernet2/0/0}
* IP feature paths configured on GigabitEthernet2/0/0...
*
* @cliexstart{show ip source-and-port-range-check vrf 7 172.16.2.0}
* 172.16.2.0: 23 - 101
* @cliexend
- * Example of how to test to determine of a given Pv4 address and port
+ * Example of how to test to determine of a given iPv4 address and port
* are being validated:
* @cliexstart{show ip source-and-port-range-check vrf 7 172.16.2.2 port 23}
* 172.16.2.2 port 23 PASS