X-Git-Url: https://gerrit.fd.io/r/gitweb?a=blobdiff_plain;f=tests%2Fvpp%2Fperf%2Fip4%2F10ge2p1x520-ethip4-ip4base-iacldstbase-ndrchk.robot;fp=tests%2Fvpp%2Fperf%2Fip4%2F10ge2p1x520-ethip4-ip4base-iacldstbase-ndrchk.robot;h=0000000000000000000000000000000000000000;hb=2d15316360dbf0b57318801b51decbbf842a8660;hp=d061928f36fddaa6978e880db7411c296b5e1abd;hpb=39cc1ccaacb7599130bb99ea781b8cc41a7c1f8b;p=csit.git

diff --git a/tests/vpp/perf/ip4/10ge2p1x520-ethip4-ip4base-iacldstbase-ndrchk.robot b/tests/vpp/perf/ip4/10ge2p1x520-ethip4-ip4base-iacldstbase-ndrchk.robot
deleted file mode 100644
index d061928f36..0000000000
--- a/tests/vpp/perf/ip4/10ge2p1x520-ethip4-ip4base-iacldstbase-ndrchk.robot
+++ /dev/null
@@ -1,188 +0,0 @@
-# Copyright (c) 2017 Cisco and/or its affiliates.
-# Licensed under the Apache License, Version 2.0 (the "License");
-# you may not use this file except in compliance with the License.
-# You may obtain a copy of the License at:
-#
-#     http://www.apache.org/licenses/LICENSE-2.0
-#
-# Unless required by applicable law or agreed to in writing, software
-# distributed under the License is distributed on an "AS IS" BASIS,
-# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
-# See the License for the specific language governing permissions and
-# limitations under the License.
-
-*** Settings ***
-| Resource | resources/libraries/robot/performance/performance_setup.robot
-| ...
-| Force Tags | 3_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | NDRCHK
-| ... | NIC_Intel-X520-DA2 | ETH | IP4FWD | FEATURE | IACLDST
-| ...
-| Suite Setup | Set up 3-node performance topology with DUT's NIC model
-| ... | L3 | Intel-X520-DA2
-| Suite Teardown | Tear down 3-node performance topology
-| ...
-| Test Setup | Set up performance test
-| Test Teardown | Tear down performance ndrchk test
-| ...
-| Documentation | *Reference NDR throughput IPv4 whitelist verify test cases*
-| ...
-| ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology
-| ... | with single links between nodes.
-| ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for IPv4 routing.
-| ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with IPv4
-| ... | routing, two static IPv4 /24 routes and IPv4 iAcl security whitelist
-| ... | ingress /24 filter entries applied on links TG - DUT1 and DUT2 - TG.
-| ... | DUT1 and DUT2 tested with 2p10GE NIC X520 Niantic by Intel.
-| ... | *[Ver] TG verification:* In short performance tests, TG verifies
-| ... | DUTs' throughput at ref-NDR (reference Non Drop Rate) with zero packet
-| ... | loss tolerance. Ref-NDR value is periodically updated acording to
-| ... | formula: ref-NDR = 0.9x NDR, where NDR is found in RFC2544 long
-| ... | performance tests for the same DUT configuration. Test packets are
-| ... | generated by TG on links to DUTs. TG traffic profile contains two L3
-| ... | flow-groups (flow-group per direction, 253 flows per flow-group) with
-| ... | all packets containing Ethernet header, IPv4 header with IP protocol=61
-| ... | and static payload. MAC addresses are matching MAC addresses of the
-| ... | TG node interfaces.
-| ... | *[Ref] Applicable standard specifications:* RFC2544.
-
-*** Variables ***
-# Traffic profile:
-| ${traffic_profile} | trex-sl-3n-ethip4-ip4src253
-
-*** Keywords ***
-| Check NDR for ethip4-ip4base-iacldstbase
-| | [Documentation]
-| | ... | [Cfg] DUT runs IPv4 routing config with ${wt} thread(s), ${wt}\
-| | ... | phy core(s), ${rxq} receive queue(s) per NIC port.
-| | ... | [Ver] Verify ref-NDR for ${framesize} frames using single trial\
-| | ... | throughput test at 2x ${rate}.
-| | ...
-| | [Arguments] | ${framesize} | ${rate} | ${wt} | ${rxq}
-| | ...
-| | # Test Variables required for test teardown
-| | Set Test Variable | ${framesize}
-| | Set Test Variable | ${rate}
-| | ${get_framesize}= | Get Frame Size | ${framesize}
-| | ...
-| | Given Add '${wt}' worker threads and '${rxq}' rxqueues in 3-node single-link circular topology
-| | And Add PCI devices to DUTs in 3-node single link topology
-| | And Run Keyword If | ${get_framesize} < ${1522}
-| | ... | Add no multi seg to all DUTs
-| | And Apply startup configuration on all VPP DUTs
-| | When Initialize IPv4 forwarding in 3-node circular topology
-| | ${table_idx} | ${skip_n} | ${match_n}= | And Vpp Creates Classify Table L3
-| | ... | ${dut1} | ip4 | dst
-| | And Vpp Configures Classify Session L3
-| | ... | ${dut1} | permit | ${table_idx} | ${skip_n} | ${match_n}
-| | ... | ip4 | dst | 20.20.20.2
-| | And Vpp Enable Input Acl Interface
-| | ... | ${dut1} | ${dut1_if1} | ip4 | ${table_idx}
-| | ${table_idx} | ${skip_n} | ${match_n}= | And Vpp Creates Classify Table L3
-| | ... | ${dut2} | ip4 | dst
-| | And Vpp Configures Classify Session L3
-| | ... | ${dut2} | permit | ${table_idx} | ${skip_n} | ${match_n}
-| | ... | ip4 | dst | 10.10.10.2
-| | And Vpp Enable Input Acl Interface
-| | ... | ${dut2} | ${dut2_if2} | ip4 | ${table_idx}
-| | Then Traffic should pass with no loss | ${perf_trial_duration}
-| | ... | ${rate} | ${framesize} | ${traffic_profile}
-
-*** Test Cases ***
-| tc01-64B-1t1c-ethip4-ip4base-iacldstbase-ndrchk
-| | [Documentation]
-| | ... | [Cfg] DUT runs IPv4 routing and whitelist filters config with \
-| | ... | 1 thread, 1 phy core, 1 receive queue per NIC port. [Ver] Verify
-| | ... | ref-NDR for 64 Byte frames using single trial throughput test
-| | ... | at 2x 3.6mpps.
-| | [Tags] | 64B | 1T1C | STHREAD
-| | ...
-| | [Template] | Check NDR for ethip4-ip4base-iacldstbase
-| | framesize=${64} | rate=3.6mpps | wt=1 | rxq=1
-
-| tc02-1518B-1t1c-ethip4-ip4base-iacldstbase-ndrchk
-| | [Documentation]
-| | ... | [Cfg] DUT runs IPv4 routing and whitelist filters config with \
-| | ... | 1 thread, 1 phy core, 1 receive queue per NIC port. [Ver] Verify
-| | ... | ref-NDR for 1518 Byte frames using single trial throughput test
-| | ... | at 2x 812743pps.
-| | [Tags] | 1518B | 1T1C | STHREAD
-| | ...
-| | [Template] | Check NDR for ethip4-ip4base-iacldstbase
-| | framesize=${1518} | rate=812743pps | wt=1 | rxq=1
-
-| tc03-9000B-1t1c-ethip4-ip4base-iacldstbase-ndrchk
-| | [Documentation]
-| | ... | [Cfg] DUT runs IPv4 routing and whitelist filters config with \
-| | ... | 1 thread, 1 phy core, 1 receive queue per NIC port. [Ver] Verify
-| | ... | ref-NDR for 9000 Byte frames using single trial throughput test
-| | ... | at 2x 138580pps.
-| | [Tags] | 9000B | 1T1C | STHREAD
-| | ...
-| | [Template] | Check NDR for ethip4-ip4base-iacldstbase
-| | framesize=${9000} | rate=138580pps | wt=1 | rxq=1
-
-| tc04-64B-2t2c-ethip4-ip4base-iacldstbase-ndrchk
-| | [Documentation]
-| | ... | [Cfg] DUT runs IPv4 routing and whitelist filters config with \
-| | ... | 2 threads, 2 phy cores, 1 receive queue per NIC port. [Ver] Verify
-| | ... | ref-NDR for 64 Byte frames using single trial throughput test
-| | ... | at 2x 6.3mpps.
-| | [Tags] | 64B | 2T2C | MTHREAD
-| | ...
-| | [Template] | Check NDR for ethip4-ip4base-iacldstbase
-| | framesize=${64} | rate=6.3mpps | wt=2 | rxq=1
-
-| tc05-1518B-2t2c-ethip4-ip4base-iacldstbase-ndrchk
-| | [Documentation]
-| | ... | [Cfg] DUT runs IPv4 routing and whitelist filters config with \
-| | ... | 2 threads, 2 phy cores, 1 receive queue per NIC port. [Ver] Verify
-| | ... | ref-NDR for 1518 Byte frames using single trial throughput test
-| | ... | at 2x 812743pps.
-| | [Tags] | 1518B | 2T2C | MTHREAD
-| | ...
-| | [Template] | Check NDR for ethip4-ip4base-iacldstbase
-| | framesize=${1518} | rate=812743pps | wt=2 | rxq=1
-
-| tc06-9000B-2t2c-ethip4-ip4base-iacldstbase-ndrchk
-| | [Documentation]
-| | ... | [Cfg] DUT runs IPv4 routing and whitelist filters config with \
-| | ... | 2 threads, 2 phy cores, 1 receive queue per NIC port. [Ver] Verify
-| | ... | ref-NDR for 9000 Byte frames using single trial throughput test
-| | ... | at 2x 138580pps.
-| | [Tags] | 9000B | 2T2C | MTHREAD
-| | ...
-| | [Template] | Check NDR for ethip4-ip4base-iacldstbase
-| | framesize=${9000} | rate=138580pps | wt=2 | rxq=1
-
-| tc07-64B-4t4c-ethip4-ip4base-iacldstbase-ndrchk
-| | [Documentation]
-| | ... | [Cfg] DUT runs IPv4 routing and whitelist filters config with \
-| | ... | 4 thread, 4 phy core, 2 receive queue per NIC port. [Ver] Verify
-| | ... | ref-NDR for 64 Byte frames using single trial throughput test
-| | ... | at 2x 9.7mpps.
-| | [Tags] | 64B | 4T4C | MTHREAD
-| | ...
-| | [Template] | Check NDR for ethip4-ip4base-iacldstbase
-| | framesize=${64} | rate=9.7mpps | wt=4 | rxq=2
-
-| tc08-1518B-4t4c-ethip4-ip4base-iacldstbase-ndrchk
-| | [Documentation]
-| | ... | [Cfg] DUT runs IPv4 routing and whitelist filters config with \
-| | ... | 4 thread, 4 phy core, 2 receive queue per NIC port. [Ver] Verify
-| | ... | ref-NDR for 1518 Byte frames using single trial throughput test
-| | ... | at 2x 812743pps.
-| | [Tags] | 1518B | 4T4C | MTHREAD
-| | ...
-| | [Template] | Check NDR for ethip4-ip4base-iacldstbase
-| | framesize=${1518} | rate=812743pps | wt=4 | rxq=2
-
-| tc09-9000B-4t4c-ethip4-ip4base-iacldstbase-ndrchk
-| | [Documentation]
-| | ... | [Cfg] DUT runs IPv4 routing and whitelist filters config with \
-| | ... | 4 thread, 4 phy core, 2 receive queue per NIC port. [Ver] Verify
-| | ... | ref-NDR for 9000 Byte frames using single trial throughput test
-| | ... | at 2x 138580pps.
-| | [Tags] | 9000B | 4T4C | MTHREAD
-| | ...
-| | [Template] | Check NDR for ethip4-ip4base-iacldstbase
-| | framesize=${9000} | rate=138580pps | wt=4 | rxq=2