c474555e6749c11c2443695fdb40eed27326667d
[csit.git] / tests / vpp / perf / container_memif / 2n1l-10ge2p1x710-ethip4-ip4base-eth-2memif-1dcr-ndrpdr.robot
1 # Copyright (c) 2020 Cisco and/or its affiliates.
2 # Licensed under the Apache License, Version 2.0 (the "License");
3 # you may not use this file except in compliance with the License.
4 # You may obtain a copy of the License at:
5 #
6 #     http://www.apache.org/licenses/LICENSE-2.0
7 #
8 # Unless required by applicable law or agreed to in writing, software
9 # distributed under the License is distributed on an "AS IS" BASIS,
10 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
11 # See the License for the specific language governing permissions and
12 # limitations under the License.
13
14 *** Settings ***
15 | Resource | resources/libraries/robot/shared/default.robot
16 |
17 | Force Tags | 2_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | NDRPDR
18 | ... | NIC_Intel-X710 | ETH | IP4FWD | BASE | MEMIF | DOCKER
19 | ... | DRV_VFIO_PCI
20 | ... | RXQ_SIZE_0 | TXQ_SIZE_0
21 | ... | ethip4-ip4base-eth-2memif-1dcr
22 |
23 | Suite Setup | Setup suite topology interfaces | performance
24 | Suite Teardown | Tear down suite | performance
25 | Test Setup | Setup test | performance
26 | Test Teardown | Tear down test | performance | container
27 |
28 | Test Template | Local Template
29 |
30 | Documentation | *RFC2544: Pkt throughput IPv4 routing test cases*
31 |
32 | ... | *[Top] Network Topologies:* TG-DUT1-TG 2-node circular topology with
33 | ... | single links between nodes.
34 | ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for IPv4 routing.
35 | ... | *[Cfg] DUT configuration:* DUT1 is configured with IPv4 routing with
36 | ... | two FIB tables and two static IPv4 /24 route entries per FIB table.
37 | ... | Container is connected to VPP via Memif interface. Container is running
38 | ... | same VPP version as running on DUT. Container is limited via cgroup to
39 | ... | use cores allocated from pool of isolated CPUs. There are no memory
40 | ... | contraints. DUT1 is tested with ${nic_name}.\
41 | ... | *[Ver] TG verification:* TG finds and reports throughput NDR (Non Drop\
42 | ... | Rate) with zero packet loss tolerance and throughput PDR (Partial Drop\
43 | ... | Rate) with non-zero packet loss tolerance (LT) expressed in percentage\
44 | ... | of packets transmitted. NDR and PDR are discovered for different\
45 | ... | Ethernet L2 frame sizes using MLRsearch library.\
46 | ... | Test packets are generated by TG on links to DUT1. TG traffic profile
47 | ... | contains two L3 flow-groups (flow-group per direction, 254 flows per
48 | ... | flow-group) with all packets containing Ethernet header, IPv4 header
49 | ... | with IP protocol=61 and static payload. MAC addresses are matching MAC
50 | ... | addresses of the TG node interfaces.
51
52 *** Variables ***
53 | @{plugins_to_enable}= | dpdk_plugin.so | memif_plugin.so
54 | ${crypto_type}= | ${None}
55 | ${nic_name}= | Intel-X710
56 | ${nic_driver}= | vfio-pci
57 | ${nic_rxq_size}= | 0
58 | ${nic_txq_size}= | 0
59 | ${nic_pfs}= | 2
60 | ${nic_vfs}= | 0
61 | ${osi_layer}= | L3
62 | ${overhead}= | ${0}
63 # Traffic profile:
64 | ${traffic_profile}= | trex-stl-2n-ethip4-ip4src254
65 # Container
66 | ${container_engine}= | Docker
67 | ${container_chain_topology}= | chain
68
69 *** Keywords ***
70 | Local Template
71 | | [Documentation]
72 | | ... | [Cfg] DUT runs IPv4 routing config.
73 | | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
74 | | ... | [Ver] Measure NDR and PDR values using MLRsearch algorithm.\
75 | |
76 | | ... | *Arguments:*
77 | | ... | - frame_size - Framesize in Bytes in integer or string (IMIX_v4_1).
78 | | ... | Type: integer, string
79 | | ... | - phy_cores - Number of physical cores. Type: integer
80 | | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
81 | |
82 | | [Arguments] | ${frame_size} | ${phy_cores} | ${rxq}=${None}
83 | |
84 | | Set Test Variable | \${frame_size}
85 | |
86 | | Given Set Max Rate And Jumbo
87 | | And Add worker threads to all DUTs | ${phy_cores} | ${rxq}
88 | | And Pre-initialize layer driver | ${nic_driver}
89 | | And Apply startup configuration on all VPP DUTs
90 | | When Initialize layer driver | ${nic_driver}
91 | | And Initialize layer interface
92 | | And Start containers for test
93 | | And Initialize IPv4 routing with memif pairs
94 | | Then Find NDR and PDR intervals using optimized search
95
96 *** Test Cases ***
97 | 64B-1c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
98 | | [Tags] | 64B | 1C
99 | | frame_size=${64} | phy_cores=${1}
100
101 | 64B-2c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
102 | | [Tags] | 64B | 2C
103 | | frame_size=${64} | phy_cores=${2}
104
105 | 64B-4c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
106 | | [Tags] | 64B | 4C
107 | | frame_size=${64} | phy_cores=${4}
108
109 | 1518B-1c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
110 | | [Tags] | 1518B | 1C
111 | | frame_size=${1518} | phy_cores=${1}
112
113 | 1518B-2c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
114 | | [Tags] | 1518B | 2C
115 | | frame_size=${1518} | phy_cores=${2}
116
117 | 1518B-4c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
118 | | [Tags] | 1518B | 4C
119 | | frame_size=${1518} | phy_cores=${4}
120
121 | 9000B-1c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
122 | | [Tags] | 9000B | 1C
123 | | frame_size=${9000} | phy_cores=${1}
124
125 | 9000B-2c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
126 | | [Tags] | 9000B | 2C
127 | | frame_size=${9000} | phy_cores=${2}
128
129 | 9000B-4c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
130 | | [Tags] | 9000B | 4C
131 | | frame_size=${9000} | phy_cores=${4}
132
133 | IMIX-1c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
134 | | [Tags] | IMIX | 1C
135 | | frame_size=IMIX_v4_1 | phy_cores=${1}
136
137 | IMIX-2c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
138 | | [Tags] | IMIX | 2C
139 | | frame_size=IMIX_v4_1 | phy_cores=${2}
140
141 | IMIX-4c-ethip4-ip4base-eth-2memif-1dcr-ndrpdr
142 | | [Tags] | IMIX | 4C
143 | | frame_size=IMIX_v4_1 | phy_cores=${4}