add 2-node ipsec hwasync cases
[csit.git] / tests / vpp / perf / crypto / 2n1l-10ge2p1x710-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr.robot
1 # Copyright (c) 2021 Cisco and/or its affiliates.
2 # Licensed under the Apache License, Version 2.0 (the "License");
3 # you may not use this file except in compliance with the License.
4 # You may obtain a copy of the License at:
5 #
6 #     http://www.apache.org/licenses/LICENSE-2.0
7 #
8 # Unless required by applicable law or agreed to in writing, software
9 # distributed under the License is distributed on an "AS IS" BASIS,
10 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
11 # See the License for the specific language governing permissions and
12 # limitations under the License.
13
14 *** Settings ***
15 | Resource | resources/libraries/robot/shared/default.robot
16 | Resource | resources/libraries/robot/crypto/ipsec.robot
17 |
18 | Force Tags | 2_NODE_SINGLE_LINK_TOPO | UDIR | PERFTEST | HW_ENV | NDRPDR
19 | ... | IP4FWD | IPSEC | IPSECHW | IPSECTUN | NIC_Intel-X710 | BASE | TNL_1
20 | ... | AES_256_GCM | AES | DRV_VFIO_PCI
21 | ... | RXQ_SIZE_0 | TXQ_SIZE_0
22 | ... | ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir
23 |
24 | Suite Setup | Setup suite topology interfaces | performance
25 | Suite Teardown | Tear down suite | performance
26 | Test Setup | Setup test | performance
27 | Test Teardown | Tear down test | performance | ipsec_sa
28 |
29 | Test Template | Local Template
30 |
31 | Documentation | **RFC2544: Pkt throughput IPv4 IPsec tunnel mode.**
32 | ... |
33 | ... | - **[Top] Network Topologies:** TG-DUT1-TG 2-node circular topology \
34 | ... | with single links between nodes.
35 | ... |
36 | ... | - **[Enc] Packet Encapsulations:** Eth-IPv4 on TG-DUT1, \
37 | ... | Eth-IPv4-IPSec on DUT1-TG.
38 | ... |
39 | ... | - **[Cfg] DUT configuration:** DUT1 is configured with multiple IPsec \
40 | ... | tunnels between it and TG. DUT gets IPv4 traffic from TG, encrypts it \
41 | ... | and sends back to TG.
42 | ... |
43 | ... | - **[Ver] TG verification:** TG finds and reports throughput NDR (Non \
44 | ... | Drop Rate) with zero packet loss tolerance and throughput PDR \
45 | ... | (Partial Drop Rate) with non-zero packet loss tolerance (LT) \
46 | ... | expressed in percentage of packets transmitted. NDR and PDR are \
47 | ... | discovered for different Ethernet L2 frame sizes using MLRsearch \
48 | ... | library.
49 | ... | Test packets are generated by TG on links to DUTs. \
50 | ... | TG traffic profile contains one L3 flow-groups (number of flows \
51 | ... | per flow-group equals to number of IPSec tunnels) with all packets \
52 | ... | containing Ethernet header, IPv4 header with IP protocol=61 and \
53 | ... | static payload. MAC addresses are matching MAC addresses of the TG \
54 | ... | node interfaces. Incrementing of IP.dst (IPv4 destination address) \
55 | ... | field is applied to the stream.
56 | ... |
57 | ... | - **[Ref] Applicable standard specifications:** RFC4303 and RFC2544.
58
59 *** Variables ***
60 | @{plugins_to_enable}= | dpdk_plugin.so | perfmon_plugin.so
61 | ... | crypto_native_plugin.so
62 | ... | crypto_ipsecmb_plugin.so | crypto_openssl_plugin.so
63 | ${crypto_type}= | HW_DH895xcc
64 | ${nic_name}= | Intel-X710
65 | ${nic_driver}= | vfio-pci
66 | ${nic_rxq_size}= | 0
67 | ${nic_txq_size}= | 0
68 | ${nic_pfs}= | 2
69 | ${nic_vfs}= | 0
70 | ${osi_layer}= | L3
71 | ${overhead}= | ${54}
72 | ${tg_if1_ip4}= | 192.168.10.2
73 | ${dut1_if1_ip4}= | 192.168.10.1
74 | ${tun_if1_ip4}= | 100.0.0.1
75 | ${tun_if2_ip4}= | 100.0.0.2
76 | ${raddr_ip4}= | 20.0.0.0
77 | ${laddr_ip4}= | 10.0.0.0
78 | ${addr_range}= | ${24}
79 | ${n_tunnels}= | ${1}
80 # Traffic profile:
81 | ${traffic_profile}= | trex-stl-2n-ethip4-ip4dst${n_tunnels}-udir
82 | ${traffic_directions}= | ${1}
83
84 *** Keywords ***
85 | Local Template
86 | | [Documentation]
87 | | ... | - **[Cfg]** DUT runs IPSec tunneling AES_256_GCM config. \
88 | | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
89 | | ... | - **[Ver]** Measure NDR and PDR values using MLRsearch algorithm.
90 | |
91 | | ... | *Arguments:*
92 | | ... | - frame_size - Framesize in Bytes in integer or string (IMIX_v4_1).
93 | | ... | Type: integer, string
94 | | ... | - phy_cores - Number of physical cores. Type: integer
95 | | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
96 | |
97 | | [Arguments] | ${frame_size} | ${phy_cores} | ${rxq}=${None}
98 | |
99 | | Set Test Variable | \${frame_size}
100 | |
101 | | # These are enums (not strings) so they cannot be in Variables table.
102 | | ${encr_alg}= | Crypto Alg AES GCM 256
103 | | ${auth_alg}= | Set Variable | ${NONE}
104 | | ${ipsec_proto}= | IPsec Proto ESP
105 | |
106 | | Given Set Max Rate And Jumbo
107 | | And Add worker threads to all DUTs | ${phy_cores} | ${rxq}
108 | | And Pre-initialize layer driver | ${nic_driver}
109 | | And Apply startup configuration on all VPP DUTs
110 | | When Initialize layer driver | ${nic_driver}
111 | | And Initialize layer interface
112 | | And Enable IPSec Async Mode on all VPP DUTs
113 | | And Initialize IPSec in 2-node circular topology
114 | | And VPP IPsec Add Multiple Tunnels
115 | | ... | ${nodes} | ${DUT1_${int}2}[0] | ${TG_pf2}[0] | ${n_tunnels}
116 | | ... | ${encr_alg} | ${auth_alg} | ${tun_if1_ip4} | ${tun_if2_ip4}
117 | | ... | ${laddr_ip4} | ${raddr_ip4} | ${addr_range}
118 | | Then Find NDR and PDR intervals using optimized search
119
120 *** Test Cases ***
121 | 64B-1c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
122 | | [Tags] | 64B | 1C
123 | | frame_size=${64} | phy_cores=${1}
124
125 | 64B-2c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
126 | | [Tags] | 64B | 2C
127 | | frame_size=${64} | phy_cores=${2}
128
129 | 64B-4c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
130 | | [Tags] | 64B | 4C
131 | | frame_size=${64} | phy_cores=${4}
132
133 | 1518B-1c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
134 | | [Tags] | 1518B | 1C
135 | | frame_size=${1518} | phy_cores=${1}
136
137 | 1518B-2c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
138 | | [Tags] | 1518B | 2C
139 | | frame_size=${1518} | phy_cores=${2}
140
141 | 1518B-4c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
142 | | [Tags] | 1518B | 4C
143 | | frame_size=${1518} | phy_cores=${4}
144
145 | 9000B-1c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
146 | | [Tags] | 9000B | 1C
147 | | frame_size=${9000} | phy_cores=${1}
148
149 | 9000B-2c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
150 | | [Tags] | 9000B | 2C
151 | | frame_size=${9000} | phy_cores=${2}
152
153 | 9000B-4c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
154 | | [Tags] | 9000B | 4C
155 | | frame_size=${9000} | phy_cores=${4}
156
157 | IMIX-1c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
158 | | [Tags] | IMIX | 1C
159 | | frame_size=IMIX_v4_1 | phy_cores=${1}
160
161 | IMIX-2c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
162 | | [Tags] | IMIX | 2C
163 | | frame_size=IMIX_v4_1 | phy_cores=${2}
164
165 | IMIX-4c-ethip4ipsec1tnlhwasync-ip4base-policy-aes256gcm-udir-ndrpdr
166 | | [Tags] | IMIX | 4C
167 | | frame_size=IMIX_v4_1 | phy_cores=${4}