IPsec: add 2n crypto udir perf tests
[csit.git] / tests / vpp / perf / crypto / 2n1l-10ge2p1x710-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr.robot
1 # Copyright (c) 2021 Intel and/or its affiliates.
2 # Copyright (c) 2021 Cisco and/or its affiliates.
3 # Licensed under the Apache License, Version 2.0 (the "License");
4 # you may not use this file except in compliance with the License.
5 # You may obtain a copy of the License at:
6 #
7 #     http://www.apache.org/licenses/LICENSE-2.0
8 #
9 # Unless required by applicable law or agreed to in writing, software
10 # distributed under the License is distributed on an "AS IS" BASIS,
11 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
12 # See the License for the specific language governing permissions and
13 # limitations under the License.
14
15 *** Settings ***
16 | Resource | resources/libraries/robot/shared/default.robot
17 | Resource | resources/libraries/robot/crypto/ipsec.robot
18 |
19 | Force Tags | 2_NODE_SINGLE_LINK_TOPO | UDIR | PERFTEST | HW_ENV | NDRPDR
20 | ... | IP4FWD | IPSEC | IPSECSW | ASYNC | IPSECINT | NIC_Intel-X710 | SCALE
21 | ... | SCHEDULER | AES_128_GCM | AES | DRV_VFIO_PCI
22 | ... | RXQ_SIZE_0 | TXQ_SIZE_0 | TNL_8
23 | ... | ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir
24 |
25 | Suite Setup | Setup suite topology interfaces | performance
26 | Suite Teardown | Tear down suite | performance
27 | Test Setup | Setup test | performance
28 | Test Teardown | Tear down test | performance | ipsec_sa
29 |
30 | Test Template | Local Template
31 |
32 | Documentation | *RFC2544: Pkt throughput IPv4 IPsec tunnel mode.*
33 |
34 | ... | *[Top] Network Topologies:* TG-DUT1-TG 2-node circular topology
35 | ... | with single links between nodes.
36 | ... | *[Enc] Packet Encapsulations:* Eth-IPv4 on TG-DUT1,
37 | ... | Eth-IPv4-IPSec on DUT1-TG
38 | ... | *[Cfg] DUT configuration:* DUT1 is configured with multiple IPsec\
39 | ... | tunnels between it and TG, run with IPsec async mode and use crypto
40 | ... | sw scheduler engine to schedule crypto work to crypto cores. DUT gets
41 | ... | IPv4 traffic from TG, encrypts it and sends back to TG.
42 | ... | *[Ver] TG verification:* TG finds and reports throughput NDR (Non Drop\
43 | ... | Rate) with zero packet loss tolerance and throughput PDR (Partial Drop\
44 | ... | Rate) with non-zero packet loss tolerance (LT) expressed in percentage\
45 | ... | of packets transmitted. NDR and PDR are discovered for different\
46 | ... | Ethernet L2 frame sizes using MLRsearch library.\
47 | ... | Test packets are generated by TG on links to DUTs.
48 | ... | TG traffic profile contains one L3 flow-groups (number of flows
49 | ... | per flow-group equals to number of IPSec tunnels) with all packets
50 | ... | containing Ethernet header, IPv4 header with IP protocol=61 and
51 | ... | static payload. MAC addresses are matching MAC addresses of the TG
52 | ... | node interfaces. Incrementing of IP.dst (IPv4 destination address) field
53 | ... | is applied to the stream.
54 | ... | *[Ref] Applicable standard specifications:* RFC4303 and RFC2544.
55
56 *** Variables ***
57 | @{plugins_to_enable}= | dpdk_plugin.so | crypto_native_plugin.so
58 | ... | crypto_ipsecmb_plugin.so | crypto_sw_scheduler_plugin.so
59 | ... | crypto_openssl_plugin.so
60 | ${crypto_type}= | ${None}
61 | ${nic_name}= | Intel-X710
62 | ${nic_driver}= | vfio-pci
63 | ${nic_rxq_size}= | 0
64 | ${nic_txq_size}= | 0
65 | ${nic_pfs}= | 2
66 | ${nic_vfs}= | 0
67 | ${osi_layer}= | L3
68 | ${overhead}= | ${54}
69 | ${tg_if1_ip4}= | 192.168.10.2
70 | ${dut1_if1_ip4}= | 192.168.10.1
71 | ${tun_if1_ip4}= | 100.0.0.1
72 | ${tun_if2_ip4}= | 200.0.0.2
73 | ${raddr_ip4}= | 20.0.0.0
74 | ${laddr_ip4}= | 10.0.0.0
75 | ${addr_range}= | ${24}
76 | ${n_tunnels}= | ${8}
77 | ${dp_cores}= | ${1}
78 # Traffic profile:
79 | ${traffic_profile}= | trex-stl-2n-ethip4-ip4dst${n_tunnels}-udir
80 | ${traffic_directions}= | ${1}
81
82 *** Keywords ***
83 | Local Template
84 | | [Documentation]
85 | | ... | [Cfg] DUT runs IPSec tunneling AES_128_GCM config.\
86 | | ... | Each DUT uses one physical core for data plane workers
87 | | ... | and rest of ${phy_cores} physical core(s) for crypto workers.
88 | | ... | [Ver] Measure NDR and PDR values using MLRsearch algorithm.\
89 | |
90 | | ... | *Arguments:*
91 | | ... | - frame_size - Framesize in Bytes in integer or string (IMIX_v4_1).
92 | | ... | Type: integer, string
93 | | ... | - phy_cores - Total number of physical cores. Type: integer
94 | | ... | - rxq - Number of RX queues, default value: ${1}. Type: integer
95 | |
96 | | [Arguments] | ${frame_size} | ${phy_cores} | ${rxq}=${1}
97 | |
98 | | Set Test Variable | \${frame_size}
99 | |
100 | | # These are enums (not strings) so they cannot be in Variables table.
101 | | ${encr_alg}= | Crypto Alg AES GCM 128
102 | | ${auth_alg}= | Set Variable | ${NONE}
103 | |
104 | | Given Set Max Rate And Jumbo
105 | | And Add worker threads to all DUTs | ${phy_cores} | ${rxq}
106 | | And Pre-initialize layer driver | ${nic_driver}
107 | | And Apply startup configuration on all VPP DUTs
108 | | When Initialize layer driver | ${nic_driver}
109 | | And Initialize layer interface
110 | | And Enable IPSec Async Mode on all VPP DUTs
111 | | And Disable Crypto Work of VPP Worker Threads on all VPP DUTs | ${dp_cores}
112 | | And Initialize IPSec in 2-node circular topology
113 | | And VPP IPsec Create Tunnel Interfaces
114 | | ... | ${nodes} | ${tun_if1_ip4} | ${tun_if2_ip4} | ${DUT1_${int}2}[0]
115 | | ... | ${TG_pf2}[0] | ${n_tunnels} | ${encr_alg} | ${auth_alg}
116 | | ... | ${laddr_ip4} | ${raddr_ip4} | ${addr_range}
117 | | Then Find NDR and PDR intervals using optimized search
118
119 *** Test Cases ***
120 | 64B-2c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
121 | | [Tags] | 64B | 2C
122 | | frame_size=${64} | phy_cores=${2}
123
124 | 64B-3c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
125 | | [Tags] | 64B | 3C
126 | | frame_size=${64} | phy_cores=${3}
127
128 | 64B-4c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
129 | | [Tags] | 64B | 4C
130 | | frame_size=${64} | phy_cores=${4}
131
132 | 1518B-2c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
133 | | [Tags] | 1518B | 2C
134 | | frame_size=${1518} | phy_cores=${2}
135
136 | 1518B-3c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
137 | | [Tags] | 1518B | 3C
138 | | frame_size=${1518} | phy_cores=${3}
139
140 | 1518B-4c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
141 | | [Tags] | 1518B | 4C
142 | | frame_size=${1518} | phy_cores=${4}
143
144 | 9000B-2c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
145 | | [Tags] | 9000B | 2C
146 | | frame_size=${9000} | phy_cores=${2}
147
148 | 9000B-3c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
149 | | [Tags] | 9000B | 3C
150 | | frame_size=${9000} | phy_cores=${3}
151
152 | 9000B-4c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
153 | | [Tags] | 9000B | 4C
154 | | frame_size=${9000} | phy_cores=${4}
155
156 | IMIX-2c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
157 | | [Tags] | IMIX | 2C
158 | | frame_size=IMIX_v4_1 | phy_cores=${2}
159
160 | IMIX-3c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
161 | | [Tags] | IMIX | 3C
162 | | frame_size=IMIX_v4_1 | phy_cores=${3}
163
164 | IMIX-4c-ethip4ipsec8tnlswasync-scheduler-ip4base-int-aes128gcm-udir-ndrpdr
165 | | [Tags] | IMIX | 4C
166 | | frame_size=IMIX_v4_1 | phy_cores=${4}