CSIT-1097: Migrate ip4 to NDRPDR and edit MRR
[csit.git] / tests / vpp / perf / ip4 / 10ge2p1x520-ethip4-ip4base-iacldstbase-mrr.robot
1 # Copyright (c) 2018 Cisco and/or its affiliates.
2 # Licensed under the Apache License, Version 2.0 (the "License");
3 # you may not use this file except in compliance with the License.
4 # You may obtain a copy of the License at:
5 #
6 #     http://www.apache.org/licenses/LICENSE-2.0
7 #
8 # Unless required by applicable law or agreed to in writing, software
9 # distributed under the License is distributed on an "AS IS" BASIS,
10 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
11 # See the License for the specific language governing permissions and
12 # limitations under the License.
13
14 *** Settings ***
15 | Resource | resources/libraries/robot/performance/performance_setup.robot
16 | ...
17 | Force Tags | 3_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | MRR
18 | ... | NIC_Intel-X520-DA2 | ETH | IP4FWD | FEATURE | IACLDST
19 | ...
20 | Suite Setup | Set up 3-node performance topology with DUT's NIC model
21 | ... | L3 | Intel-X520-DA2
22 | Suite Teardown | Tear down 3-node performance topology
23 | ...
24 | Test Setup | Set up performance test
25 | ...
26 | Test Teardown | Tear down performance mrr test
27 | ...
28 | Test Template | Local Template
29 | ...
30 | Documentation | *Raw results IPv4 iAcl whitelist test cases*
31 | ...
32 | ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology
33 | ... | with single links between nodes.
34 | ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for IPv4 routing.
35 | ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with IPv4
36 | ... | routing, two static IPv4 /24 routes and IPv4 iAcl security whitelist
37 | ... | ingress /24 filter entries applied on links TG - DUT1 and DUT2 - TG.
38 | ... | DUT1 and DUT2 tested with 2p10GE NIC X520 Niantic by Intel.
39 | ... | *[Ver] TG verification:* In MaxReceivedRate tests TG sends traffic\
40 | ... | at line rate and reports total received/sent packets over trial period.\
41 | ... | Test packets are generated by TG on links to DUTs. TG traffic profile
42 | ... | contains two L3 flow-groups (flow-group per direction, 253 flows per
43 | ... | flow-group) with all packets containing Ethernet header, IPv6 header
44 | ... | and generated payload. MAC addresses are matching MAC addresses
45 | ... | of the TG node interfaces.
46 | ... | *[Ref] Applicable standard specifications:* RFC2544.
47
48 *** Variables ***
49 # X520-DA2 bandwidth limit
50 | ${s_limit}= | ${10000000000}
51 # Traffic profile:
52 | ${traffic_profile}= | trex-sl-3n-ethip4-ip4src253
53
54 *** Keywords ***
55 | Local Template
56 | | [Documentation]
57 | | ... | [Cfg] DUT runs IPv4 routing config.
58 | | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
59 | | ... | [Ver] Measure MaxReceivedRate for ${framesize}B frames using single\
60 | | ... | trial throughput test.
61 | | ...
62 | | ... | *Arguments:*
63 | | ... | - framesize - Framesize in Bytes in integer or string (IMIX_v4_1).
64 | | ... | Type: integer, string
65 | | ... | - phy_cores - Number of physical cores. Type: integer
66 | | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
67 | | ...
68 | | [Arguments] | ${framesize} | ${phy_cores} | ${rxq}=${None}
69 | | ...
70 | | Given Add worker threads and rxqueues to all DUTs | ${phy_cores} | ${rxq}
71 | | And Add PCI devices to all DUTs
72 | | ${max_rate} | ${jumbo} = | Get Max Rate And Jumbo And Handle Multi Seg
73 | | ... | ${s_limit} | ${framesize}
74 | | And Apply startup configuration on all VPP DUTs
75 | | When Initialize IPv4 forwarding in 3-node circular topology
76 | | ${table_idx} | ${skip_n} | ${match_n}= | And Vpp Creates Classify Table L3
77 | | ... | ${dut1} | ip4 | dst
78 | | And Vpp Configures Classify Session L3
79 | | ... | ${dut1} | permit | ${table_idx} | ${skip_n} | ${match_n}
80 | | ... | ip4 | dst | 20.20.20.2
81 | | And Vpp Enable Input Acl Interface
82 | | ... | ${dut1} | ${dut1_if1} | ip4 | ${table_idx}
83 | | ${table_idx} | ${skip_n} | ${match_n}= | And Vpp Creates Classify Table L3
84 | | ... | ${dut2} | ip4 | dst
85 | | And Vpp Configures Classify Session L3
86 | | ... | ${dut2} | permit | ${table_idx} | ${skip_n} | ${match_n}
87 | | ... | ip4 | dst | 10.10.10.2
88 | | And Vpp Enable Input Acl Interface
89 | | ... | ${dut2} | ${dut2_if2} | ip4 | ${table_idx}
90 | | Then Traffic should pass with maximum rate
91 | | ... | ${max_rate}pps | ${framesize} | ${traffic_profile}
92
93 *** Test Cases ***
94 | tc01-64B-1c-ethip4-ip4base-iacldstbase-mrr
95 | | [Tags] | 64B | 1C
96 | | framesize=${64} | phy_cores=${1}
97
98 | tc02-64B-2c-ethip4-ip4base-iacldstbase-mrr
99 | | [Tags] | 64B | 2C
100 | | framesize=${64} | phy_cores=${2}
101
102 | tc03-64B-4c-ethip4-ip4base-iacldstbase-mrr
103 | | [Tags] | 64B | 4C
104 | | framesize=${64} | phy_cores=${4}
105
106 | tc04-1518B-1c-ethip4-ip4base-iacldstbase-mrr
107 | | [Tags] | 1518B | 1C
108 | | framesize=${1518} | phy_cores=${1}
109
110 | tc05-1518B-2c-ethip4-ip4base-iacldstbase-mrr
111 | | [Tags] | 1518B | 2C
112 | | framesize=${1518} | phy_cores=${2}
113
114 | tc06-1518B-4c-ethip4-ip4base-iacldstbase-mrr
115 | | [Tags] | 1518B | 4C
116 | | framesize=${1518} | phy_cores=${4}
117
118 | tc07-9000B-1c-ethip4-ip4base-iacldstbase-mrr
119 | | [Tags] | 9000B | 1C
120 | | framesize=${9000} | phy_cores=${1}
121
122 | tc08-9000B-2c-ethip4-ip4base-iacldstbase-mrr
123 | | [Tags] | 9000B | 2C
124 | | framesize=${9000} | phy_cores=${2}
125
126 | tc09-9000B-4c-ethip4-ip4base-iacldstbase-mrr
127 | | [Tags] | 9000B | 4C
128 | | framesize=${9000} | phy_cores=${4}
129
130 | tc10-IMIX-1c-ethip4-ip4base-iacldstbase-mrr
131 | | [Tags] | IMIX | 1C
132 | | framesize=IMIX_v4_1 | phy_cores=${1}
133
134 | tc11-IMIX-2c-ethip4-ip4base-iacldstbase-mrr
135 | | [Tags] | IMIX | 2C
136 | | framesize=IMIX_v4_1 | phy_cores=${2}
137
138 | tc12-IMIX-4c-ethip4-ip4base-iacldstbase-mrr
139 | | [Tags] | IMIX | 4C
140 | | framesize=IMIX_v4_1 | phy_cores=${4}