VPPD: Cop, iACL, Policer
[csit.git] / tests / vpp / perf / ip4 / 10ge2p1x710-ethip4-ip4base-copwhtlistbase-ndrpdr.robot
1 # Copyright (c) 2019 Cisco and/or its affiliates.
2 # Licensed under the Apache License, Version 2.0 (the "License");
3 # you may not use this file except in compliance with the License.
4 # You may obtain a copy of the License at:
5 #
6 #     http://www.apache.org/licenses/LICENSE-2.0
7 #
8 # Unless required by applicable law or agreed to in writing, software
9 # distributed under the License is distributed on an "AS IS" BASIS,
10 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
11 # See the License for the specific language governing permissions and
12 # limitations under the License.
13
14 *** Settings ***
15 | Resource | resources/libraries/robot/shared/default.robot
16 | ...
17 | Force Tags | 3_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | NDRPDR
18 | ... | NIC_Intel-X710 | ETH | IP4FWD | FEATURE | COPWHLIST
19 | ...
20 | Suite Setup | Setup suite single link | performance
21 | Suite Teardown | Tear down suite | performance
22 | Test Setup | Setup test
23 | Test Teardown | Tear down test | performance
24 | ...
25 | Test Template | Local Template
26 | ...
27 | Documentation | *RFC2544: Pkt throughput IPv4 whitelist test cases*
28 | ...
29 | ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology
30 | ... | with single links between nodes.
31 | ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for IPv4 routing.
32 | ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with IPv4
33 | ... | routing, two static IPv4 /24 routes and IPv4 COP security whitelist
34 | ... | ingress /24 filter entries applied on links TG - DUT1 and DUT2 - TG.
35 | ... | DUT1 and DUT2 tested with ${nic_name}.\
36 | ... | *[Ver] TG verification:* TG finds and reports throughput NDR (Non Drop\
37 | ... | Rate) with zero packet loss tolerance and throughput PDR (Partial Drop\
38 | ... | Rate) with non-zero packet loss tolerance (LT) expressed in percentage\
39 | ... | of packets transmitted. NDR and PDR are discovered for different\
40 | ... | Ethernet L2 frame sizes using MLRsearch library.\
41 | ... | Test packets are generated by TG on links to DUTs. TG traffic profile
42 | ... | contains two L3 flow-groups (flow-group per direction, 253 flows per
43 | ... | flow-group) with all packets containing Ethernet header, IPv4 header
44 | ... | with IP protocol=61 and static payload. MAC addresses are matching MAC
45 | ... | addresses of the TG node interfaces.
46 | ... | *[Ref] Applicable standard specifications:* RFC2544.
47
48 *** Variables ***
49 | @{plugins_to_enable}= | dpdk_plugin.so
50 | ${osi_layer}= | L3
51 | ${nic_name}= | Intel-X710
52 | ${overhead}= | ${0}
53 # Traffic profile:
54 | ${traffic_profile}= | trex-sl-3n-ethip4-ip4src253
55
56 *** Keywords ***
57 | Local Template
58 | | [Documentation]
59 | | ... | [Cfg] DUT runs IPv4 routing config. \
60 | | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
61 | | ... | [Ver] Measure NDR and PDR values using MLRsearch algorithm.\
62 | | ...
63 | | ... | *Arguments:*
64 | | ... | - frame_size - Framesize in Bytes in integer or string (IMIX_v4_1).
65 | | ... | Type: integer, string
66 | | ... | - phy_cores - Number of physical cores. Type: integer
67 | | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
68 | | ...
69 | | [Arguments] | ${frame_size} | ${phy_cores} | ${rxq}=${None}
70 | | ...
71 | | Set Test Variable | \${frame_size}
72 | | ...
73 | | Given Add worker threads and rxqueues to all DUTs | ${phy_cores} | ${rxq}
74 | | And Add PCI devices to all DUTs
75 | | And Set Max Rate And Jumbo And Handle Multi Seg
76 | | And Apply startup configuration on all VPP DUTs
77 | | When Initialize IPv4 forwarding in circular topology
78 | | And Add Fib Table | ${dut1} | 1
79 | | And Vpp Route Add | ${dut1} | 10.10.10.0 | 24 | vrf=1 | local=${TRUE}
80 | | And Add Fib Table | ${dut2} | 1
81 | | And Vpp Route Add | ${dut2} | 20.20.20.0 | 24 | vrf=1 | local=${TRUE}
82 | | And COP Add whitelist Entry | ${dut1} | ${dut1_if1} | ip4 | 1
83 | | And COP Add whitelist Entry | ${dut2} | ${dut2_if2} | ip4 | 1
84 | | And COP interface enable or disable | ${dut1} | ${dut1_if1} | enable
85 | | And COP interface enable or disable | ${dut2} | ${dut2_if2} | enable
86 | | Then Find NDR and PDR intervals using optimized search
87
88 *** Test Cases ***
89 | tc01-64B-1c-ethip4-ip4base-copwhtlistbase-ndrpdr
90 | | [Tags] | 64B | 1C
91 | | frame_size=${64} | phy_cores=${1}
92
93 | tc02-64B-2c-ethip4-ip4base-copwhtlistbase-ndrpdr
94 | | [Tags] | 64B | 2C
95 | | frame_size=${64} | phy_cores=${2}
96
97 | tc03-64B-4c-ethip4-ip4base-copwhtlistbase-ndrpdr
98 | | [Tags] | 64B | 4C
99 | | frame_size=${64} | phy_cores=${4}
100
101 | tc04-1518B-1c-ethip4-ip4base-copwhtlistbase-ndrpdr
102 | | [Tags] | 1518B | 1C
103 | | frame_size=${1518} | phy_cores=${1}
104
105 | tc05-1518B-2c-ethip4-ip4base-copwhtlistbase-ndrpdr
106 | | [Tags] | 1518B | 2C
107 | | frame_size=${1518} | phy_cores=${2}
108
109 | tc06-1518B-4c-ethip4-ip4base-copwhtlistbase-ndrpdr
110 | | [Tags] | 1518B | 4C
111 | | frame_size=${1518} | phy_cores=${4}
112
113 | tc07-9000B-1c-ethip4-ip4base-copwhtlistbase-ndrpdr
114 | | [Tags] | 9000B | 1C
115 | | frame_size=${9000} | phy_cores=${1}
116
117 | tc08-9000B-2c-ethip4-ip4base-copwhtlistbase-ndrpdr
118 | | [Tags] | 9000B | 2C
119 | | frame_size=${9000} | phy_cores=${2}
120
121 | tc09-9000B-4c-ethip4-ip4base-copwhtlistbase-ndrpdr
122 | | [Tags] | 9000B | 4C
123 | | frame_size=${9000} | phy_cores=${4}
124
125 | tc10-IMIX-1c-ethip4-ip4base-copwhtlistbase-ndrpdr
126 | | [Tags] | IMIX | 1C
127 | | frame_size=IMIX_v4_1 | phy_cores=${1}
128
129 | tc11-IMIX-2c-ethip4-ip4base-copwhtlistbase-ndrpdr
130 | | [Tags] | IMIX | 2C
131 | | frame_size=IMIX_v4_1 | phy_cores=${2}
132
133 | tc12-IMIX-4c-ethip4-ip4base-copwhtlistbase-ndrpdr
134 | | [Tags] | IMIX | 4C
135 | | frame_size=IMIX_v4_1 | phy_cores=${4}