Clean: Various libraries
[csit.git] / tests / vpp / perf / ip4 / 10ge2p1x710-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr.robot
1 # Copyright (c) 2019 Cisco and/or its affiliates.
2 # Licensed under the Apache License, Version 2.0 (the "License");
3 # you may not use this file except in compliance with the License.
4 # You may obtain a copy of the License at:
5 #
6 #     http://www.apache.org/licenses/LICENSE-2.0
7 #
8 # Unless required by applicable law or agreed to in writing, software
9 # distributed under the License is distributed on an "AS IS" BASIS,
10 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
11 # See the License for the specific language governing permissions and
12 # limitations under the License.
13
14 *** Settings ***
15 | Resource | resources/libraries/robot/shared/default.robot
16 | ...
17 | Force Tags | 3_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | NDRPDR
18 | ... | NIC_Intel-X710 | ETH | IP4FWD | FEATURE | ACL | ACL_STATELESS
19 | ... | IACL | ACL50 | 100K_FLOWS
20 | ...
21 | Suite Setup | Setup suite single link | performance
22 | Suite Teardown | Tear down suite | performance
23 | Test Setup | Setup test
24 | Test Teardown | Tear down test | performance | acl
25 | ...
26 | Test Template | Local Template
27 | ...
28 | Documentation | *RFC2544: Packet throughput IPv4 test cases with ACL*
29 | ...
30 | ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology\
31 | ... | with single links between nodes.
32 | ... | *[Enc] Packet Encapsulations:* Eth-IPv4-UDP for IPv4 routing.
33 | ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with IPv4\
34 | ... | routing and one static IPv4 /24 route entries. Required ACL rules are\
35 | ... | applied to input paths of both DUT1 intefaces. DUT1 and DUT2 are tested\
36 | ... | with ${nic_name}.\
37 | ... | *[Ver] TG verification:* TG finds and reports throughput NDR (Non Drop\
38 | ... | Rate) with zero packet loss tolerance and throughput PDR (Partial Drop\
39 | ... | Rate) with non-zero packet loss tolerance (LT) expressed in percentage\
40 | ... | of packets transmitted. NDR and PDR are discovered for different\
41 | ... | Ethernet L2 frame sizes using MLRsearch library.\
42 | ... | Test packets are generated by TG on links to DUTs. TG traffic profile\
43 | ... | contains two L3 flow-groups (flow-group per direction, ${flows_per_dir}\
44 | ... | flows per flow-group) with all packets containing Ethernet header, IPv4\
45 | ... | header with IP protocol=61 and static payload. MAC addresses are\
46 | ... | matching MAC addresses of the TG node interfaces.
47 | ... | *[Ref] Applicable standard specifications:* RFC2544.
48
49 *** Variables ***
50 | @{plugins_to_enable}= | dpdk_plugin.so | acl_plugin.so
51 | ${osi_layer}= | L3
52 | ${nic_name}= | Intel-X710
53 | ${overhead}= | ${0}
54 # ACL test setup
55 | ${acl_action}= | permit
56 | ${acl_apply_type}= | input
57 | ${no_hit_aces_number}= | 50
58 | ${flows_per_dir}= | 100k
59 | ${ip_nr}= | ${100}
60 # starting points for non-hitting ACLs
61 | ${src_ip_start}= | 30.30.30.1
62 | ${dst_ip_start}= | 40.40.40.1
63 | ${ip_step}= | ${1}
64 | ${sport_start}= | ${1000}
65 | ${dport_start}= | ${1000}
66 | ${port_step}= | ${1}
67 | ${trex_stream1_subnet}= | 10.10.10.0/24
68 | ${trex_stream2_subnet}= | 20.20.20.0/24
69 | ${traffic_profile}= | trex-sl-3n-ethip4udp-100u1000p-conc
70
71 *** Keywords ***
72 | Local Template
73 | | [Documentation] | FIXME.
74 | | ... | [Cfg] DUT runs IPv4 routing config.
75 | | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
76 | | ... | [Ver] Measure NDR and PDR values using MLRsearch algorithm.\
77 | | ...
78 | | ... | *Arguments:*
79 | | ... | - frame_size - Framesize in Bytes in integer or string (IMIX_v4_1).
80 | | ... | Type: integer, string
81 | | ... | - phy_cores - Number of physical cores. Type: integer
82 | | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
83 | | ...
84 | | [Arguments] | ${frame_size} | ${phy_cores} | ${rxq}=${None}
85 | | ...
86 | | Set Test Variable | \${frame_size}
87 | | ...
88 | | Given Add worker threads and rxqueues to all DUTs | ${phy_cores} | ${rxq}
89 | | And Add PCI devices to all DUTs
90 | | And Set Max Rate And Jumbo And Handle Multi Seg
91 | | And Apply startup configuration on all VPP DUTs
92 | | When Initialize IPv4 routing with IPv4 ACLs on DUT1 in circular topology
93 | | ... | ${ip_nr}
94 | | Then Find NDR and PDR intervals using optimized search
95
96 *** Test Cases ***
97 | tc01-64B-1c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
98 | | [Tags] | 64B | 1C
99 | | frame_size=${64} | phy_cores=${1}
100
101 | tc02-64B-2c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
102 | | [Tags] | 64B | 2C
103 | | frame_size=${64} | phy_cores=${2}
104
105 | tc03-64B-4c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
106 | | [Tags] | 64B | 4C
107 | | frame_size=${64} | phy_cores=${4}
108
109 | tc04-1518B-1c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
110 | | [Tags] | 1518B | 1C
111 | | frame_size=${1518} | phy_cores=${1}
112
113 | tc05-1518B-2c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
114 | | [Tags] | 1518B | 2C
115 | | frame_size=${1518} | phy_cores=${2}
116
117 | tc06-1518B-4c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
118 | | [Tags] | 1518B | 4C
119 | | frame_size=${1518} | phy_cores=${4}
120
121 | tc07-9000B-1c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
122 | | [Tags] | 9000B | 1C
123 | | frame_size=${9000} | phy_cores=${1}
124
125 | tc08-9000B-2c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
126 | | [Tags] | 9000B | 2C
127 | | frame_size=${9000} | phy_cores=${2}
128
129 | tc09-9000B-4c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
130 | | [Tags] | 9000B | 4C
131 | | frame_size=${9000} | phy_cores=${4}
132
133 | tc10-IMIX-1c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
134 | | [Tags] | IMIX | 1C
135 | | frame_size=IMIX_v4_1 | phy_cores=${1}
136
137 | tc11-IMIX-2c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
138 | | [Tags] | IMIX | 2C
139 | | frame_size=IMIX_v4_1 | phy_cores=${2}
140
141 | tc12-IMIX-4c-ethip4udp-ip4base-iacl50sl-100kflows-ndrpdr
142 | | [Tags] | IMIX | 4C
143 | | frame_size=IMIX_v4_1 | phy_cores=${4}