feat(api): Use newest API messages after rls2402
[csit.git] / tests / vpp / perf / ip4 / 2n1l-10ge2p1x710-ethip4-ip4base-adlalwlistbase-ndrpdr.robot
1 # Copyright (c) 2021 Cisco and/or its affiliates.
2 # Licensed under the Apache License, Version 2.0 (the "License");
3 # you may not use this file except in compliance with the License.
4 # You may obtain a copy of the License at:
5 #
6 #     http://www.apache.org/licenses/LICENSE-2.0
7 #
8 # Unless required by applicable law or agreed to in writing, software
9 # distributed under the License is distributed on an "AS IS" BASIS,
10 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
11 # See the License for the specific language governing permissions and
12 # limitations under the License.
13
14 *** Settings ***
15 | Resource | resources/libraries/robot/shared/default.robot
16 |
17 | Force Tags | 2_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | NDRPDR
18 | ... | NIC_Intel-X710 | ETH | IP4FWD | FEATURE | ADLALWLIST | DRV_VFIO_PCI
19 | ... | RXQ_SIZE_0 | TXQ_SIZE_0
20 | ... | ethip4-ip4base-adlalwlistbase
21 |
22 | Suite Setup | Setup suite topology interfaces | performance
23 | Suite Teardown | Tear down suite | performance
24 | Test Setup | Setup test | performance
25 | Test Teardown | Tear down test | performance
26 |
27 | Test Template | Local Template
28 |
29 | Documentation | *RFC2544: Pkt throughput IPv4 allowlist test cases*
30 |
31 | ... | *[Top] Network Topologies:* TG-DUT1-TG 2-node circular topology
32 | ... | with single links between nodes.
33 | ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for IPv4 routing.
34 | ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with IPv4
35 | ... | routing, two static IPv4 /24 routes and IPv4 ADL security allowlist
36 | ... | ingress /24 filter entries applied on links TG - DUT1.
37 | ... | DUT1 tested with ${nic_name}.\
38 | ... | *[Ver] TG verification:* TG finds and reports throughput NDR (Non Drop\
39 | ... | Rate) with zero packet loss tolerance and throughput PDR (Partial Drop\
40 | ... | Rate) with non-zero packet loss tolerance (LT) expressed in percentage\
41 | ... | of packets transmitted. NDR and PDR are discovered for different\
42 | ... | Ethernet L2 frame sizes using MLRsearch library.\
43 | ... | Test packets are generated by TG on links to DUTs. TG traffic profile
44 | ... | contains two L3 flow-groups (flow-group per direction, 253 flows per
45 | ... | flow-group) with all packets containing Ethernet header, IPv4 header
46 | ... | with IP protocol=61 and static payload. MAC addresses are matching MAC
47 | ... | addresses of the TG node interfaces.
48 | ... | *[Ref] Applicable standard specifications:* RFC2544.
49
50 *** Variables ***
51 | @{plugins_to_enable}= | dpdk_plugin.so | adl_plugin.so
52 | ${crypto_type}= | ${None}
53 | ${nic_name}= | Intel-X710
54 | ${nic_driver}= | vfio-pci
55 | ${nic_rxq_size}= | 0
56 | ${nic_txq_size}= | 0
57 | ${nic_pfs}= | 2
58 | ${nic_vfs}= | 0
59 | ${osi_layer}= | L3
60 | ${overhead}= | ${0}
61 # Traffic profile
62 | ${traffic_profile}= | trex-stl-2n-ethip4-ip4src253
63
64 *** Keywords ***
65 | Local Template
66 | | [Documentation]
67 | | ... | [Cfg] DUT runs IPv4 routing config. \
68 | | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
69 | | ... | [Ver] Measure NDR and PDR values using MLRsearch algorithm.\
70 | |
71 | | ... | *Arguments:*
72 | | ... | - frame_size - Framesize in Bytes in integer or string (IMIX_v4_1).
73 | | ... | Type: integer, string
74 | | ... | - phy_cores - Number of physical cores. Type: integer
75 | | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
76 | |
77 | | [Arguments] | ${frame_size} | ${phy_cores} | ${rxq}=${None}
78 | |
79 | | Set Test Variable | \${frame_size}
80 | |
81 | | Given Set Max Rate And Jumbo
82 | | And Add worker threads to all DUTs | ${phy_cores} | ${rxq}
83 | | And Pre-initialize layer driver | ${nic_driver}
84 | | And Apply startup configuration on all VPP DUTs
85 | | When Initialize layer driver | ${nic_driver}
86 | | And Initialize layer interface
87 | | And Initialize IPv4 forwarding in circular topology
88 | | And Add Fib Table | ${dut1} | 1
89 | | And Vpp Route Add | ${dut1} | 10.10.10.0 | 24 | vrf=1 | local=${TRUE}
90 | | And ADL Add allowlist Entry | ${dut1} | ${DUT1_${int}1}[0] | ip4 | 1
91 | | And ADL interface enable or disable | ${dut1} | ${DUT1_${int}1}[0] | enable
92 | | Then Find NDR and PDR intervals using optimized search
93
94 *** Test Cases ***
95 | 64B-1c-ethip4-ip4base-adlalwlistbase-ndrpdr
96 | | [Tags] | 64B | 1C
97 | | frame_size=${64} | phy_cores=${1}
98
99 | 64B-2c-ethip4-ip4base-adlalwlistbase-ndrpdr
100 | | [Tags] | 64B | 2C
101 | | frame_size=${64} | phy_cores=${2}
102
103 | 64B-4c-ethip4-ip4base-adlalwlistbase-ndrpdr
104 | | [Tags] | 64B | 4C
105 | | frame_size=${64} | phy_cores=${4}
106
107 | 1518B-1c-ethip4-ip4base-adlalwlistbase-ndrpdr
108 | | [Tags] | 1518B | 1C
109 | | frame_size=${1518} | phy_cores=${1}
110
111 | 1518B-2c-ethip4-ip4base-adlalwlistbase-ndrpdr
112 | | [Tags] | 1518B | 2C
113 | | frame_size=${1518} | phy_cores=${2}
114
115 | 1518B-4c-ethip4-ip4base-adlalwlistbase-ndrpdr
116 | | [Tags] | 1518B | 4C
117 | | frame_size=${1518} | phy_cores=${4}
118
119 | 9000B-1c-ethip4-ip4base-adlalwlistbase-ndrpdr
120 | | [Tags] | 9000B | 1C
121 | | frame_size=${9000} | phy_cores=${1}
122
123 | 9000B-2c-ethip4-ip4base-adlalwlistbase-ndrpdr
124 | | [Tags] | 9000B | 2C
125 | | frame_size=${9000} | phy_cores=${2}
126
127 | 9000B-4c-ethip4-ip4base-adlalwlistbase-ndrpdr
128 | | [Tags] | 9000B | 4C
129 | | frame_size=${9000} | phy_cores=${4}
130
131 | IMIX-1c-ethip4-ip4base-adlalwlistbase-ndrpdr
132 | | [Tags] | IMIX | 1C
133 | | frame_size=IMIX_v4_1 | phy_cores=${1}
134
135 | IMIX-2c-ethip4-ip4base-adlalwlistbase-ndrpdr
136 | | [Tags] | IMIX | 2C
137 | | frame_size=IMIX_v4_1 | phy_cores=${2}
138
139 | IMIX-4c-ethip4-ip4base-adlalwlistbase-ndrpdr
140 | | [Tags] | IMIX | 4C
141 | | frame_size=IMIX_v4_1 | phy_cores=${4}