tests/vpp/perf/l2/10ge2p1x520-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr.robot

   1 # Copyright (c) 2018 Cisco and/or its affiliates.
   2 # Licensed under the Apache License, Version 2.0 (the "License");
   3 # you may not use this file except in compliance with the License.
   4 # You may obtain a copy of the License at:
   5 #
   6 #     http://www.apache.org/licenses/LICENSE-2.0
   7 #
   8 # Unless required by applicable law or agreed to in writing, software
   9 # distributed under the License is distributed on an "AS IS" BASIS,
  10 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
  11 # See the License for the specific language governing permissions and
  12 # limitations under the License.
  13
  14 *** Settings ***
  15 | Resource | resources/libraries/robot/performance/performance_setup.robot
  16 | ...
  17 | Force Tags | 3_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | MRR
  18 | ... | NIC_Intel-X520-DA2 | ETH | L2BDMACLRN | FEATURE | MACIP | ACL_STATELESS
  19 | ... | IACL | ACL1 | 100k_FLOWS
  20 | ...
  21 | Suite Setup | Run Keywords
  22 | ... | Set up 3-node performance topology with DUT's NIC model | L2
  23 | ... | Intel-X520-DA2
  24 | ... | AND | Set up performance test suite with ACL
  25 | ...
  26 | Suite Teardown | Tear down 3-node performance topology
  27 | ...
  28 | Test Setup | Set up performance test
  29 | ...
  30 | Test Teardown | Tear down mrr test with MACIP ACL
  31 | ...
  32 | Test Template | Local Template
  33 | ...
  34 | Documentation | *Raw results L2BD test cases with ACL*
  35 | ...
  36 | ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology\
  37 | ... | with single links between nodes.
  38 | ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for L2 switching of IPv4.
  39 | ... | *[Cfg] DUT configuration:* DUT1 is configured with L2 bridge domain\
  40 | ... | and MAC learning enabled. DUT2 is configured with L2 cross-connects.\
  41 | ... | Required MACIP ACL rules are applied to input paths of both DUT1\
  42 | ... | interfaces. DUT1 and DUT2 are tested with 2p10GE NIC X520 Niantic by\
  43 | ... | Intel.
  44 | ... | *[Ver] TG verification:* In MaxReceivedRate test TG sends traffic
  45 | ... | at line rate and reports total received/sent packets over trial period.
  46 | ... | Test packets are generated by TG on\
  47 | ... | links to DUTs. TG traffic profile contains two L3 flow-groups\
  48 | ... | (flow-group per direction, ${flows_per_dir} flows per flow-group) with\
  49 | ... | all packets containing Ethernet header, IPv4 header with IP protocol=61\
  50 | ... | and static payload. MAC addresses are matching MAC addresses of the TG\
  51 | ... | node interfaces.
  52 | ... | *[Ref] Applicable standard specifications:* RFC2544.
  53
  54 *** Variables ***
  55 # X520-DA2 bandwidth limit
  56 | ${s_limit}= | ${10000000000}
  57
  58 # ACL test setup
  59 | ${acl_action}= | permit
  60 | ${no_hit_aces_number}= | 1
  61 | ${flows_per_dir}= | 100k
  62
  63 # starting points for non-hitting ACLs
  64 | ${src_ip_start}= | 30.30.30.1
  65 | ${ip_step}= | ${1}
  66 | ${src_mac_start}= | 01:02:03:04:05:06
  67 | ${src_mac_step}= | ${1000}
  68 | ${src_mac_mask}= | 00:00:00:00:00:00
  69 | ${tg_stream1_mac}= | ca:fe:00:00:00:00
  70 | ${tg_stream2_mac}= | fa:ce:00:00:00:00
  71 | ${tg_mac_mask}= | ff:ff:ff:fe:00:00
  72 | ${tg_stream1_subnet}= | 10.0.0.0/15
  73 | ${tg_stream2_subnet}= | 20.0.0.0/15
  74
  75 # traffic profile
  76 | ${traffic_profile}= | trex-sl-3n-ethip4-macsrc100kip4src100k
  77
  78 *** Keywords ***
  79 | Local Template
  80 | | [Documentation] | FIXME.
  81 | | [Arguments] | ${framesize} | ${phy_cores} | ${rxq}=${None}
  82 | | ...
  83 | | Given Add worker threads and rxqueues to all DUTs | ${phy_cores} | ${rxq}
  84 | | And Add PCI devices to all DUTs
  85 | | ${max_rate} | ${jumbo} = | Get Max Rate And Jumbo And Handle Multi Seg
  86 | | ... | ${s_limit} | ${framesize}
  87 | | And Apply startup configuration on all VPP DUTs
  88 | | When Initialize L2 bridge domain with MACIP ACLs on DUT1 in 3-node circular topology
  89 | | Then Traffic should pass with maximum rate
  90 | | ... | ${max_rate}pps | ${framesize} | ${traffic_profile}
  91
  92 *** Test Cases ***
  93 | tc01-64B-1c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
  94 | | [Tags] | 64B | 1C
  95 | | framesize=${64} | phy_cores=${1}
  96
  97 | tc02-64B-2c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
  98 | | [Tags] | 64B | 2C
  99 | | framesize=${64} | phy_cores=${2}
 100
 101 | tc03-64B-4c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
 102 | | [Tags] | 64B | 4C
 103 | | framesize=${64} | phy_cores=${4}
 104
 105 | tc04-1518B-1c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
 106 | | [Tags] | 1518B | 1C
 107 | | framesize=${1518} | phy_cores=${1}
 108
 109 | tc05-1518B-2c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
 110 | | [Tags] | 1518B | 2C
 111 | | framesize=${1518} | phy_cores=${2}
 112
 113 | tc06-1518B-4c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
 114 | | [Tags] | 1518B | 4C
 115 | | framesize=${1518} | phy_cores=${4}
 116
 117 | tc07-9000B-1c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
 118 | | [Tags] | 9000B | 1C
 119 | | framesize=${9000} | phy_cores=${1}
 120
 121 | tc08-9000B-2c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
 122 | | [Tags] | 9000B | 2C
 123 | | framesize=${9000} | phy_cores=${2}
 124
 125 | tc09-9000B-4c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
 126 | | [Tags] | 9000B | 4C
 127 | | framesize=${9000} | phy_cores=${4}
 128
 129 | tc10-IMIX-1c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
 130 | | [Tags] | IMIX | 1C
 131 | | framesize=IMIX_v4_1 | phy_cores=${1}
 132
 133 | tc11-IMIX-2c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
 134 | | [Tags] | IMIX | 2C
 135 | | framesize=IMIX_v4_1 | phy_cores=${2}
 136
 137 | tc12-IMIX-4c-eth-l2bdbasemaclrn-macip-iacl1sl-100kflows-mrr
 138 | | [Tags] | IMIX | 4C
 139 | | framesize=IMIX_v4_1 | phy_cores=${4}