Add missing = to all suite Variables
[csit.git] / tests / vpp / perf / l2 / 2n1l-25ge2p1xxv710-eth-l2xcbase-mrr.robot
1 # Copyright (c) 2018 Cisco and/or its affiliates.
2 # Licensed under the Apache License, Version 2.0 (the "License");
3 # you may not use this file except in compliance with the License.
4 # You may obtain a copy of the License at:
5 #
6 #     http://www.apache.org/licenses/LICENSE-2.0
7 #
8 # Unless required by applicable law or agreed to in writing, software
9 # distributed under the License is distributed on an "AS IS" BASIS,
10 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
11 # See the License for the specific language governing permissions and
12 # limitations under the License.
13
14 *** Settings ***
15 | Resource | resources/libraries/robot/performance/performance_setup.robot
16 | ...
17 | Force Tags | 2_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | MRR
18 | ... | NIC_Intel-XXV710 | ETH | L2XCFWD | BASE | L2XCBASE
19 | ...
20 | Suite Setup | Set up 2-node performance topology with DUT's NIC model
21 | ... | L2 | Intel-XXV710
22 | ...
23 | Suite Teardown | Tear down 2-node performance topology
24 | ...
25 | Test Setup | Set up performance test
26 | ...
27 | Test Teardown | Tear down performance mrr test
28 | ...
29 | Test Template | Local Template
30 | ...
31 | Documentation | *Raw results L2XC test cases*
32 | ...
33 | ... | *[Top] Network Topologies:* TG-DUT1-TG 2-node circular topology
34 | ... | with single links between nodes.
35 | ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for L2 cross connect.
36 | ... | *[Cfg] DUT configuration:* DUT1 is configured with L2 cross-connect.
37 | ... | DUT1 tested with 2p25GE NIC XXV710 by Intel.
38 | ... | *[Ver] TG verification:* In MaxReceivedRate tests TG sends traffic
39 | ... | at line rate and reports total received/sent packets over trial period.
40 | ... | Test packets are generated by TG on links to DUTs. TG traffic profile
41 | ... | contains two L3 flow-groups (flow-group per direction, 254 flows per
42 | ... | flow-group) with all packets containing Ethernet header, IPv4 header
43 | ... | with IP protocol=61 and static payload. MAC addresses are matching MAC
44 | ... | addresses of the TG node interfaces.
45 | ... | *[Ref] Applicable standard specifications:* RFC2544.
46
47 *** Variables ***
48 # XXV710-DA2 bandwidth limit ~49Gbps/2=24.5Gbps
49 | ${s_24.5G}= | ${24500000000}
50 # XXV710-DA2 Mpps limit 37.5Mpps/2=18.75Mpps
51 | ${s_18.75Mpps}= | ${18750000}
52 # Traffic profile:
53 | ${traffic_profile}= | trex-sl-2n-ethip4-ip4src254
54
55 *** Keywords ***
56 | Local Template
57 | | [Documentation]
58 | | ... | [Cfg] DUT runs L2XC config.\
59 | | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
60 | | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
61 | | ... | trial throughput test.
62 | | ...
63 | | ... | *Arguments:*
64 | | ... | - framesize - Framesize in Bytes in integer or string (IMIX_v4_1).
65 | | ... |   Type: integer, string
66 | | ... | - phy_cores - Number of physical cores. Type: integer
67 | | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
68 | | ...
69 | | [Arguments] | ${framesize} | ${phy_cores} | ${rxq}=${None}
70 | | ...
71 | | Given Add worker threads and rxqueues to all DUTs | ${phy_cores} | ${rxq}
72 | | And Add PCI devices to all DUTs
73 | | ${max_rate} | ${jumbo} = | Get Max Rate And Jumbo And Handle Multi Seg
74 | | ... | ${s_24.5G} | ${framesize} | pps_limit=${s_18.75Mpps}
75 | | And Apply startup configuration on all VPP DUTs
76 | | And Initialize L2 xconnect in 2-node circular topology
77 | | Then Traffic should pass with maximum rate
78 | | ... | ${max_rate}pps | ${framesize} | ${traffic_profile}
79
80 *** Test Cases ***
81 | tc01-64B-1c-eth-l2xcbase-mrr
82 | | [Tags] | 64B | 1C
83 | | framesize=${64} | phy_cores=${1}
84
85 | tc02-64B-2c-eth-l2xcbase-mrr
86 | | [Tags] | 64B | 2C
87 | | framesize=${64} | phy_cores=${2}
88
89 | tc03-64B-4c-eth-l2xcbase-mrr
90 | | [Tags] | 64B | 4C
91 | | framesize=${64} | phy_cores=${4}
92
93 | tc04-1518B-1c-eth-l2xcbase-mrr
94 | | [Tags] | 1518B | 1C
95 | | framesize=${1518} | phy_cores=${1}
96
97 | tc05-1518B-2c-eth-l2xcbase-mrr
98 | | [Tags] | 1518B | 2C
99 | | framesize=${1518} | phy_cores=${2}
100
101 | tc06-1518B-4c-eth-l2xcbase-mrr
102 | | [Tags] | 1518B | 4C
103 | | framesize=${1518} | phy_cores=${4}
104
105 | tc07-9000B-1c-eth-l2xcbase-mrr
106 | | [Tags] | 9000B | 1C
107 | | framesize=${9000} | phy_cores=${1}
108
109 | tc08-9000B-2c-eth-l2xcbase-mrr
110 | | [Tags] | 9000B | 2C
111 | | framesize=${9000} | phy_cores=${2}
112
113 | tc09-9000B-4c-eth-l2xcbase-mrr
114 | | [Tags] | 9000B | 4C
115 | | framesize=${9000} | phy_cores=${4}
116
117 | tc10-IMIX-1c-eth-l2xcbase-mrr
118 | | [Tags] | IMIX | 1C
119 | | framesize=IMIX_v4_1 | phy_cores=${1}
120
121 | tc11-IMIX-2c-eth-l2xcbase-mrr
122 | | [Tags] | IMIX | 2C
123 | | framesize=IMIX_v4_1 | phy_cores=${2}
124
125 | tc12-IMIX-4c-eth-l2xcbase-mrr
126 | | [Tags] | IMIX | 4C
127 | | framesize=IMIX_v4_1 | phy_cores=${4}