Python3: resources and libraries
[csit.git] / tests / vpp / perf / vm_vhost / 2n1l-10ge2p1x710-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr.robot
1 # Copyright (c) 2019 Cisco and/or its affiliates.
2 # Licensed under the Apache License, Version 2.0 (the "License");
3 # you may not use this file except in compliance with the License.
4 # You may obtain a copy of the License at:
5 #
6 #     http://www.apache.org/licenses/LICENSE-2.0
7 #
8 # Unless required by applicable law or agreed to in writing, software
9 # distributed under the License is distributed on an "AS IS" BASIS,
10 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
11 # See the License for the specific language governing permissions and
12 # limitations under the License.
13
14 *** Settings ***
15 | Resource | resources/libraries/robot/shared/default.robot
16 |
17 | Force Tags | 2_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | NDRPDR
18 | ... | NIC_Intel-X710 | ETH | IP4FWD | BASE | VHOST | 1VM | VHOST_1024
19 | ... | NF_TESTPMD | DRV_VFIO_PCI
20 |
21 | Suite Setup | Setup suite single link | performance
22 | Suite Teardown | Tear down suite | performance
23 | Test Setup | Setup test
24 | Test Teardown | Tear down test | performance | vhost
25 |
26 | Test Template | Local Template
27 |
28 | Documentation | *RFC2544: Pkt throughput IPv4 test cases with vhost*
29 |
30 | ... | *[Top] Network Topologies:* TG-DUT1-TG 2-node circular topology
31 | ... | with single links between nodes.
32 | ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for IPv4 routing.
33 | ... | *[Cfg] DUT configuration:* DUT1 is configured with IPv4
34 | ... | routing and two static IPv4 /24 route entries. Qemu VNFs are connected \
35 | ... | to VPP via vhost-user interfaces. Guest is running testpmd \
36 | ... | interconnecting vhost-user interfaces, rxd/txd=1024. DUT1 is tested \
37 | ... | with ${nic_name}.
38 | ... | *[Ver] TG verification:* TG finds and reports throughput NDR (Non Drop\
39 | ... | Rate) with zero packet loss tolerance and throughput PDR (Partial Drop\
40 | ... | Rate) with non-zero packet loss tolerance (LT) expressed in percentage\
41 | ... | of packets transmitted. NDR and PDR are discovered for different\
42 | ... | Ethernet L2 frame sizes using MLRsearch library.\
43 | ... | Test packets are generated by TG on links to DUTs. TG traffic profile
44 | ... | contains two L3 flow-groups (flow-group per direction, 253 flows per
45 | ... | flow-group) with all packets containing Ethernet header, IPv4 header
46 | ... | with IP protocol=61 and static payload. MAC addresses are matching MAC
47 | ... | addresses of the TG node interfaces.
48 | ... | *[Ref] Applicable standard specifications:* RFC2544.
49
50 *** Variables ***
51 | @{plugins_to_enable}= | dpdk_plugin.so
52 | ${crypto_type}= | ${None}
53 | ${nic_name}= | Intel-X710
54 | ${nic_driver}= | vfio-pci
55 | ${osi_layer}= | L3
56 | ${overhead}= | ${0}
57 | ${nf_dtcr}= | ${1}
58 | ${nf_dtc}= | ${1}
59 | ${nf_chains}= | ${1}
60 | ${nf_nodes}= | ${1}
61 # Traffic profile:
62 | ${traffic_profile}= | trex-sl-2n-ethip4-ip4src253
63
64 *** Keywords ***
65 | Local Template
66 | | [Documentation]
67 | | ... | [Cfg] DUT runs IPv4 routing config.
68 | | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
69 | | ... | [Ver] Measure NDR and PDR values using MLRsearch algorithm.\
70 | |
71 | | ... | *Arguments:*
72 | | ... | - frame_size - Framesize in Bytes in integer or string (IMIX_v4_1).
73 | | ... | Type: integer, string
74 | | ... | - phy_cores - Number of physical cores. Type: integer
75 | | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
76 | |
77 | | [Arguments] | ${frame_size} | ${phy_cores} | ${rxq}=${None}
78 | |
79 | | Set Test Variable | \${frame_size}
80 | |
81 | | Given Set Max Rate And Jumbo
82 | | And Add worker threads to all DUTs | ${phy_cores} | ${rxq}
83 | | And Pre-initialize layer driver | ${nic_driver}
84 | | And Apply startup configuration on all VPP DUTs
85 | | When Initialize layer driver | ${nic_driver}
86 | | And Initialize layer interface
87 | | And Initialize IPv4 forwarding with vhost in 2-node circular topology
88 | | ... | nf_nodes=${nf_nodes} | testpmd_mac=${TRUE}
89 | | And Configure chains of NFs connected via vhost-user
90 | | ... | nf_chains=${nf_chains} | nf_nodes=${nf_nodes} | jumbo=${jumbo}
91 | | ... | use_tuned_cfs=${False} | auto_scale=${True} | vnf=testpmd_mac
92 | | Then Find NDR and PDR intervals using optimized search
93
94 *** Test Cases ***
95 | tc01-64B-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
96 | | [Tags] | 64B | 1C
97 | | frame_size=${64} | phy_cores=${1}
98
99 | tc02-64B-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
100 | | [Tags] | 64B | 2C
101 | | frame_size=${64} | phy_cores=${2}
102
103 | tc03-64B-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
104 | | [Tags] | 64B | 4C
105 | | frame_size=${64} | phy_cores=${4}
106
107 | tc04-1518B-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
108 | | [Tags] | 1518B | 1C
109 | | frame_size=${1518} | phy_cores=${1}
110
111 | tc05-1518B-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
112 | | [Tags] | 1518B | 2C
113 | | frame_size=${1518} | phy_cores=${2}
114
115 | tc06-1518B-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
116 | | [Tags] | 1518B | 4C
117 | | frame_size=${1518} | phy_cores=${4}
118
119 | tc07-9000B-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
120 | | [Tags] | 9000B | 1C
121 | | frame_size=${9000} | phy_cores=${1}
122
123 | tc08-9000B-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
124 | | [Tags] | 9000B | 2C
125 | | frame_size=${9000} | phy_cores=${2}
126
127 | tc09-9000B-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
128 | | [Tags] | 9000B | 4C
129 | | frame_size=${9000} | phy_cores=${4}
130
131 | tc10-IMIX-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
132 | | [Tags] | IMIX | 1C
133 | | frame_size=IMIX_v4_1 | phy_cores=${1}
134
135 | tc11-IMIX-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
136 | | [Tags] | IMIX | 2C
137 | | frame_size=IMIX_v4_1 | phy_cores=${2}
138
139 | tc12-IMIX-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
140 | | [Tags] | IMIX | 4C
141 | | frame_size=IMIX_v4_1 | phy_cores=${4}