Remove lbdpdk perf tests
[csit.git] / tests / vpp / perf / vm_vhost / 2n1l-25ge2p1xxv710-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr.robot
1 # Copyright (c) 2018 Cisco and/or its affiliates.
2 # Licensed under the Apache License, Version 2.0 (the "License");
3 # you may not use this file except in compliance with the License.
4 # You may obtain a copy of the License at:
5 #
6 #     http://www.apache.org/licenses/LICENSE-2.0
7 #
8 # Unless required by applicable law or agreed to in writing, software
9 # distributed under the License is distributed on an "AS IS" BASIS,
10 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
11 # See the License for the specific language governing permissions and
12 # limitations under the License.
13
14 *** Settings ***
15 | Resource | resources/libraries/robot/performance/performance_setup.robot
16 | ...
17 | Force Tags | 2_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | MRR
18 | ... | NIC_Intel-XXV710 | ETH | IP4FWD | BASE | VHOST | 1VM | VHOST_1024
19 | ...
20 | Suite Setup | Set up 2-node performance topology with DUT's NIC model
21 | ... | L3 | Intel-XXV710
22 | Suite Teardown | Tear down 2-node performance topology
23 | ...
24 | Test Setup | Set up performance test
25 | Test Teardown | Tear down performance mrr test with vhost and VM with dpdk-testpmd
26 | ... | dut1_node=${dut1} | dut1_vm_refs=${dut1_vm_refs}
27 | ...
28 | Test Template | Local Template
29 | ...
30 | Documentation | *Raw results IPv4 test cases with vhost*
31 | ...
32 | ... | *[Top] Network Topologies:* TG-DUT1-TG 2-node circular topology
33 | ... | with single links between nodes.
34 | ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for IPv4 routing.
35 | ... | *[Cfg] DUT configuration:* DUT1 is configured with IPv4
36 | ... | routing and two static IPv4 /24 route entries. Qemu Guest is connected
37 | ... | to VPP via vhost-user interfaces. Guest is running DPDK testpmd
38 | ... | interconnecting vhost-user interfaces, forwarding mode is set to mac,
39 | ... | rxd/txd=1024. DUT1 is tested with 2p25GE NIC XXV710 by Intel.
40 | ... | *[Ver] TG verification:* In MaxReceivedRate test TG sends traffic
41 | ... | at line rate and reports total received/sent packets over trial period.
42 | ... | Test packets are generated by TG on links to DUTs. TG traffic profile
43 | ... | contains two L3 flow-groups (flow-group per direction, 253 flows per
44 | ... | flow-group) with all packets containing Ethernet header, IPv4 header
45 | ... | with IP protocol=61 and static payload. MAC addresses are matching MAC
46 | ... | addresses of the TG node interfaces.
47
48 *** Variables ***
49 # XXV710-DA2 bandwidth limit ~49Gbps/2=24.5Gbps
50 | ${s_24.5G}= | ${24500000000}
51 # XXV710-DA2 Mpps limit 37.5Mpps/2=18.75Mpps
52 | ${s_18.75Mpps}= | ${18750000}
53 # Traffic profile:
54 | ${traffic_profile}= | trex-sl-2n-ethip4-ip4src253
55
56 *** Keywords ***
57 | Local Template
58 | | [Documentation]
59 | | ... | [Cfg] DUT runs IPv4 routing config.
60 | | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
61 | | ... | [Ver] Measure MaxReceivedRate for ${framesize}B frames using single\
62 | | ... | trial throughput test.
63 | | ...
64 | | ... | *Arguments:*
65 | | ... | - framesize - Framesize in Bytes in integer or string (IMIX_v4_1).
66 | | ... | Type: integer, string
67 | | ... | - phy_cores - Number of physical cores. Type: integer
68 | | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
69 | | ...
70 | | [Arguments] | ${framesize} | ${phy_cores} | ${rxq}=${None}
71 | | ...
72 | | ${dut1_vm_refs}= | Create Dictionary
73 | | Set Test Variable | ${dut1_vm_refs}
74 | | ...
75 | | Given Add worker threads and rxqueues to all DUTs | ${phy_cores} | ${rxq}
76 | | And Add PCI devices to all DUTs
77 | | ${max_rate} | ${jumbo} = | Get Max Rate And Jumbo And Handle Multi Seg
78 | | ... | ${s_24.5G} | ${framesize} | pps_limit=${s_18.75Mpps}
79 | | And Apply startup configuration on all VPP DUTs
80 | | When Initialize IPv4 forwarding with vhost in 2-node circular topology
81 | | ... | vm_count=${1}
82 | | And Configure guest VMs with dpdk-testpmd-mac connected via vhost-user
83 | | ... | vm_count=${1} | jumbo=${jumbo} | perf_qemu_qsz=${1024}
84 | | ... | use_tuned_cfs=${False}
85 | | Then Traffic should pass with maximum rate
86 | | ... | ${max_rate}pps | ${framesize} | ${traffic_profile}
87
88 *** Test Cases ***
89 | tc01-64B-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
90 | | [Tags] | 64B | 1C
91 | | framesize=${64} | phy_cores=${1}
92
93 | tc02-64B-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
94 | | [Tags] | 64B | 2C
95 | | framesize=${64} | phy_cores=${2}
96
97 | tc03-64B-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
98 | | [Tags] | 64B | 4C
99 | | framesize=${64} | phy_cores=${4}
100
101 | tc04-1518B-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
102 | | [Tags] | 1518B | 1C
103 | | framesize=${1518} | phy_cores=${1}
104
105 | tc05-1518B-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
106 | | [Tags] | 1518B | 2C
107 | | framesize=${1518} | phy_cores=${2}
108
109 | tc06-1518B-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
110 | | [Tags] | 1518B | 4C
111 | | framesize=${1518} | phy_cores=${4}
112
113 | tc07-9000B-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
114 | | [Tags] | 9000B | 1C
115 | | framesize=${9000} | phy_cores=${1}
116
117 | tc08-9000B-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
118 | | [Tags] | 9000B | 2C
119 | | framesize=${9000} | phy_cores=${2}
120
121 | tc09-9000B-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
122 | | [Tags] | 9000B | 4C
123 | | framesize=${9000} | phy_cores=${4}
124
125 | tc10-IMIX-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
126 | | [Tags] | IMIX | 1C
127 | | framesize=IMIX_v4_1 | phy_cores=${1}
128
129 | tc11-IMIX-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
130 | | [Tags] | IMIX | 2C
131 | | framesize=IMIX_v4_1 | phy_cores=${2}
132
133 | tc12-IMIX-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-mrr
134 | | [Tags] | IMIX | 4C
135 | | framesize=IMIX_v4_1 | phy_cores=${4}