.. raw:: latex \clearpage .. _dpdk_test_environment: .. include:: ../introduction/test_environment_intro.rst .. include:: ../introduction/test_environment_sut_calib_skx.rst .. include:: ../introduction/test_environment_sut_calib_clx.rst .. include:: ../introduction/test_environment_sut_calib_hsw.rst .. include:: ../introduction/test_environment_sut_calib_dnv.rst .. include:: ../introduction/test_environment_sut_calib_tsh.rst .. include:: ../introduction/test_environment_sut_conf_1.rst DUT Settings - DPDK ------------------- DPDK Version ~~~~~~~~~~~~ |dpdk-release| DPDK Compile Parameters ~~~~~~~~~~~~~~~~~~~~~~~ .. code-block:: bash make install T=-native-linuxapp-gcc -j Testpmd Startup Configuration ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Testpmd startup configuration changes per test case with different settings for `$$CORES`, `$$RXQ` and max-pkt-len parameter if test is sending jumbo frames. Startup command template: .. code-block:: bash testpmd -c $$CORE_MASK -n 4 -- --numa --nb-ports=2 --portmask=0x3 --nb-cores=$$CORES [--max-pkt-len=9000] --txqflags=0 --forward-mode=io --rxq=$$RXQ --txq=$$TXQ --burst=64 --rxd=1024 --txd=1024 --disable-link-check --auto-start L3FWD Startup Configuration ~~~~~~~~~~~~~~~~~~~~~~~~~~~ L3FWD startup configuration changes per test case with different settings for `$$CORES` and enable-jumbo parameter if test is sending jumbo frames. Startup command template: .. code-block:: bash l3fwd -l $$CORE_LIST -n 4 -- -P -L -p 0x3 --config='${port_config}' [--enable-jumbo --max-pkt-len=9000] --eth-dest=0,${adj_mac0} --eth-dest=1,${adj_mac1} --parse-ptype .. include:: ../introduction/test_environment_tg.rst