SUT Settings - Linux -------------------- System provisioning is done by combination of PXE boot unattented install and `Ansible `_ described in `CSIT Testbed Setup`_. Linux Boot Parameters ~~~~~~~~~~~~~~~~~~~~~ - **isolcpus=-** used for all cpu cores apart from first core of each socket used for running VPP worker threads and Qemu/LXC processes https://www.kernel.org/doc/Documentation/admin-guide/kernel-parameters.txt - **intel_pstate=disable** - [X86] Do not enable intel_pstate as the default scaling driver for the supported processors. Intel P-State driver decide what P-state (CPU core power state) to use based on requesting policy from the cpufreq core. [X86 - Either 32-bit or 64-bit x86] https://www.kernel.org/doc/Documentation/cpu-freq/intel-pstate.txt - **nohz_full=-** - [KNL,BOOT] In kernels built with CONFIG_NO_HZ_FULL=y, set the specified list of CPUs whose tick will be stopped whenever possible. The boot CPU will be forced outside the range to maintain the timekeeping. The CPUs in this range must also be included in the rcu_nocbs= set. Specifies the adaptive-ticks CPU cores, causing kernel to avoid sending scheduling-clock interrupts to listed cores as long as they have a single runnable task. [KNL - Is a kernel start-up parameter, SMP - The kernel is an SMP kernel]. https://www.kernel.org/doc/Documentation/timers/NO_HZ.txt - **rcu_nocbs** - [KNL] In kernels built with CONFIG_RCU_NOCB_CPU=y, set the specified list of CPUs to be no-callback CPUs, that never queue RCU callbacks (read-copy update). https://www.kernel.org/doc/Documentation/admin-guide/kernel-parameters.txt - **numa_balancing=disable** - [KNL,X86] Disable automatic NUMA balancing. - **intel_iommu=enable** - [DMAR] Enable Intel IOMMU driver (DMAR) option. - **iommu=on, iommu=pt** - [x86, IA-64] Disable IOMMU bypass, using IOMMU for PCI devices. - **nmi_watchdog=0** - [KNL,BUGS=X86] Debugging features for SMP kernels. Turn hardlockup detector in nmi_watchdog off. - **nosoftlockup** - [KNL] Disable the soft-lockup detector. - **tsc=reliable** - Disable clocksource stability checks for TSC. [x86] reliable: mark tsc clocksource as reliable, this disables clocksource verification at runtime, as well as the stability checks done at bootup. Used to enable high-resolution timer mode on older hardware, and in virtualized environment. - **hpet=disable** - [X86-32,HPET] Disable HPET and use PIT instead. Hugepages Configuration ~~~~~~~~~~~~~~~~~~~~~~~ Huge pages are managed via sysctl configuration located in `/etc/sysctl.d/90-csit.conf` on each testbed. Default huge page size is 2M. The exact amount of huge pages depends on testbed. All the values are defined in `Ansible inventory - hosts` files.