# Copyright (c) 2016 Cisco and/or its affiliates. # Licensed under the Apache License, Version 2.0 (the "License"); # you may not use this file except in compliance with the License. # You may obtain a copy of the License at: # # http://www.apache.org/licenses/LICENSE-2.0 # # Unless required by applicable law or agreed to in writing, software # distributed under the License is distributed on an "AS IS" BASIS, # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. # See the License for the specific language governing permissions and # limitations under the License. *** Settings *** | Documentation | Check if VPP sends ARP request to unknown destinations. | Resource | resources/libraries/robot/default.robot | Resource | resources/libraries/robot/counters.robot | Resource | resources/libraries/robot/interfaces.robot | Resource | resources/libraries/robot/testing_path.robot | Resource | resources/libraries/robot/ipv4.robot | Resource | resources/libraries/robot/l2_xconnect.robot | Resource | resources/libraries/robot/traffic.robot | Library | resources.libraries.python.Trace | Force Tags | HW_ENV | VM_ENV | 3_NODE_SINGLE_LINK_TOPO | Suite Setup | Run Keywords | Setup all TGs before traffic script | ... | AND | Update All Interface Data On All Nodes | ${nodes} | Test Setup | Setup all DUTs before test | Test Teardown | Show packet trace on all DUTs | ${nodes} *** Variables *** | ${dut1_to_tg_ip}= | 192.168.1.1 | ${dut1_to_dut2_ip}= | 192.168.2.1 | ${dut1_to_dut2_ip_GW}= | 192.168.2.2 | ${test_dst_ip}= | 32.0.0.1 | ${test_src_ip}= | 16.0.0.1 | ${prefix_length}= | 24 *** Test Cases *** | VPP sends ARP requests for unknown destinations | | [Documentation] | Setup IP addresses and route. | | ... | Send ICMP packet and check if VPP sends ARP request. | | Given Path for 3-node testing is set | | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']} | | And Interfaces in 3-node path are up | | And L2 setup xconnect on DUT | | ... | ${dut2_node} | ${dut2_to_dut1} | ${dut2_to_tg} | | When Set Interface Address | ${dut1_node} | | ... | ${dut1_to_tg} | ${dut1_to_tg_ip} | ${prefix_length} | | And Set Interface Address | ${dut1_node} | | ... | ${dut1_to_dut2} | ${dut1_to_dut2_ip} | ${prefix_length} | | And Vpp Route Add | | ... | ${dut1_node} | ${test_dst_ip} | ${prefix_length} | | ... | ${dut1_to_dut2_ip_GW} | ${dut1_to_dut2} | | Then Send Packet And Check ARP Request | ${tg_node} | | ... | ${test_src_ip} | ${test_dst_ip} | ${tg_to_dut1} | | ... | ${tg_to_dut2_mac} | ${tg_to_dut2} | ${dut1_to_dut2_mac} | | ... | ${dut1_to_dut2_ip} | ${dut1_to_dut2_ip_GW}