# Copyright (c) 2019 Cisco and/or its affiliates. # Licensed under the Apache License, Version 2.0 (the "License"); # you may not use this file except in compliance with the License. # You may obtain a copy of the License at: # # http://www.apache.org/licenses/LICENSE-2.0 # # Unless required by applicable law or agreed to in writing, software # distributed under the License is distributed on an "AS IS" BASIS, # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. # See the License for the specific language governing permissions and # limitations under the License. *** Settings *** | Library | resources.libraries.python.Classify.Classify | Library | resources.libraries.python.telemetry.IPFIXSetup | Library | resources.libraries.python.Trace | ... | Resource | resources/libraries/robot/ip/ip4.robot | Resource | resources/libraries/robot/shared/default.robot | Resource | resources/libraries/robot/shared/interfaces.robot | Resource | resources/libraries/robot/shared/testing_path.robot | Resource | resources/libraries/robot/telemetry/ipfix.robot | ... | Force Tags | HW_ENV | VM_ENV | 3_NODE_SINGLE_LINK_TOPO | ... | Test Setup | Set up functional test | ... | Test Teardown | Tear down functional test | ... | Documentation | *IPFIX ipv4 test cases* | ... | ... | IPFIX tests use 3-node topology TG - DUT1 - DUT2 - TG with | ... | one link between the nodes. DUT1 is configured with IPv4 | ... | routing and static routes. IPFIX is configured on DUT1 with | ... | DUT1->TG interface as collector. Test packets are | ... | sent from TG to DUT1. TG listens for flow report packets | ... | and verifies that they contains flow record of test packets sent. *** Variables *** | ${dut1_to_tg_ip}= | 192.168.1.1 | ${tg_to_dut1_ip}= | 192.168.1.2 | ${dut2_to_dut1_ip}= | 192.168.2.1 | ${prefix_length}= | 24 | ${ip_version}= | ip4 | ${port}= | 80 *** Test Cases *** | TC01: DUT sends IPFIX template and data packets | | [Documentation] | | ... | [Top] TG-DUT1-DUT2-TG. [Cfg] On DUT1 configure IPFIX with TG interface | | ... | address as collector and a basic classify session. | | ... | [Ver] Make TG listen for IPFIX template and data packets, verify | | ... | that packet is received and correct. No packets are sent from TG. | | ... | [Ref] RFC 7011 | | Given Configure path in 3-node circular topology | | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']} | | And Set interfaces in 3-node circular topology up | | And VPP Interface Set IP Address | ${dut1_node} | | ... | ${dut1_to_tg} | ${dut1_to_tg_ip} | ${prefix_length} | | And VPP Add IP Neighbor | ${dut1_node} | ${dut1_to_tg} | ${tg_to_dut1_ip} | | ... | ${tg_to_dut1_mac} | | ${table_index} | ${skip_n} | ${match_n}= | | ... | And VPP creates classify table L3 | ${dut1_node} | ${ip_version} | src | | And VPP configures classify session L3 | ${dut1_node} | permit | | ... | ${table_index} | ${skip_n} | ${match_n} | ${ip_version} | src | | ... | ${tg_to_dut1_ip} | | When Assign interface to flow table | ${dut1_node} | ${dut1_to_tg} | | ... | ${table_index} | ip_version=${ip_version} | | And Setup IPFIX exporter | ${dut1_node} | ${tg_to_dut1_ip} | | ... | ${dut1_to_tg_ip} | interval=5 | | And Set IPFIX stream | ${dut1_node} | ${1} | | And Assign classify table to exporter | ${dut1_node} | ${table_index} | | ... | ${ip_version} | | Then Send packets and verify IPFIX | ${tg_node} | ${dut1_node} | | ... | ${tg_to_dut1} | ${dut1_to_tg} | ${tg_to_dut1_ip} | ${dut1_to_tg_ip} | | ... | count=0 | TC02: DUT reports packet flow for traffic by source address | | [Documentation] | | ... | [Top] TG-DUT1-DUT2-TG. [Cfg] On DUT1 configure IPFIX with TG interface | | ... | address as collector and add classify session with TG source address. | | ... | [Ver] Make TG send a packet to DUT1, then listen for IPFIX template | | ... | and data packets, verify that IPFIX reported the received packet. | | ... | [Ref] RFC 7011 | | Given Configure path in 3-node circular topology | | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']} | | And Set interfaces in 3-node circular topology up | | And VPP Interface Set IP Address | ${dut1_node} | | ... | ${dut1_to_tg} | ${dut1_to_tg_ip} | ${prefix_length} | | And VPP Add IP Neighbor | ${dut1_node} | ${dut1_to_tg} | ${tg_to_dut1_ip} | | ... | ${tg_to_dut1_mac} | | ${table_index} | ${skip_n} | ${match_n}= | | ... | And VPP creates classify table L3 | ${dut1_node} | ${ip_version} | src | | And VPP configures classify session L3 | ${dut1_node} | permit | | ... | ${table_index} | ${skip_n} | ${match_n} | ${ip_version} | src | | ... | ${tg_to_dut1_ip} | | When Assign interface to flow table | ${dut1_node} | ${dut1_to_tg} | | ... | ${table_index} | ip_version=${ip_version} | | And Setup IPFIX exporter | ${dut1_node} | ${tg_to_dut1_ip} | | ... | ${dut1_to_tg_ip} | interval=5 | | And Set IPFIX stream | ${dut1_node} | ${1} | | And Assign classify table to exporter | ${dut1_node} | ${table_index} | | ... | ${ip_version} | | Then Send packets and verify IPFIX | ${tg_node} | ${dut1_node} | | ... | ${tg_to_dut1} | ${dut1_to_tg} | ${tg_to_dut1_ip} | ${dut1_to_tg_ip} | TC03: DUT reports packet flow for traffic with local destination address | | [Documentation] | | ... | [Top] TG-DUT1-DUT2-TG. [Cfg] On DUT1 configure IPFIX with TG interface | | ... | address as collector and add classify session with destination | | ... | address of DUT1. | | ... | [Ver] Make TG send a packet to DUT1, then listen for IPFIX template | | ... | and data packets, verify that IPFIX reported the received packet. | | ... | [Ref] RFC 7011 | | Given Configure path in 3-node circular topology | | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']} | | And Set interfaces in 3-node circular topology up | | And VPP Interface Set IP Address | ${dut1_node} | | ... | ${dut1_to_tg} | ${dut1_to_tg_ip} | ${prefix_length} | | And VPP Add IP Neighbor | ${dut1_node} | ${dut1_to_tg} | ${tg_to_dut1_ip} | | ... | ${tg_to_dut1_mac} | | ${table_index} | ${skip_n} | ${match_n}= | | ... | And VPP creates classify table L3 | ${dut1_node} | ${ip_version} | dst | | And VPP configures classify session L3 | ${dut1_node} | permit | | ... | ${table_index} | ${skip_n} | ${match_n} | ${ip_version} | dst | | ... | ${dut1_to_tg_ip} | | When Assign interface to flow table | ${dut1_node} | ${dut1_to_tg} | | ... | ${table_index} | ip_version=${ip_version} | | And Setup IPFIX exporter | ${dut1_node} | ${tg_to_dut1_ip} | | ... | ${dut1_to_tg_ip} | interval=5 | | And Set IPFIX stream | ${dut1_node} | ${1} | | And Assign classify table to exporter | ${dut1_node} | ${table_index} | | ... | ${ip_version} | | Then Send packets and verify IPFIX | ${tg_node} | ${dut1_node} | | ... | ${tg_to_dut1} | ${dut1_to_tg} | ${tg_to_dut1_ip} | ${dut1_to_tg_ip} | TC04: DUT reports packet flow for traffic with remote destination address | | [Documentation] | | ... | [Top] TG-DUT1-DUT2-TG. [Cfg] On DUT1 configure IPFIX with TG interface | | ... | address as collector and add classify session with destination | | ... | address of DUT2. | | ... | [Ver] Make TG send a packet to DUT2 through DUT1, then listen | | ... | for IPFIX template and data packets, verify that IPFIX reported | | ... | the received packet. | | ... | [Ref] RFC 7011 | | Given Configure path in 3-node circular topology | | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']} | | And Set interfaces in 3-node circular topology up | | And VPP Interface Set IP Address | ${dut1_node} | | ... | ${dut1_to_tg} | ${dut1_to_tg_ip} | ${prefix_length} | | And VPP Add IP Neighbor | ${dut1_node} | ${dut1_to_tg} | ${tg_to_dut1_ip} | | ... | ${tg_to_dut1_mac} | | And VPP Add IP Neighbor | ${dut1_node} | ${dut1_to_dut2} | | ... | ${dut2_to_dut1_ip} | ${dut2_to_dut1_mac} | | ${table_index} | ${skip_n} | ${match_n}= | | ... | And VPP creates classify table L3 | ${dut1_node} | ${ip_version} | dst | | And VPP configures classify session L3 | ${dut1_node} | permit | | ... | ${table_index} | ${skip_n} | ${match_n} | ${ip_version} | dst | | ... | ${dut2_to_dut1_ip} | | When Assign interface to flow table | ${dut1_node} | ${dut1_to_tg} | | ... | ${table_index} | ip_version=${ip_version} | | And Setup IPFIX exporter | ${dut1_node} | ${tg_to_dut1_ip} | | ... | ${dut1_to_tg_ip} | interval=5 | | And Set IPFIX stream | ${dut1_node} | ${1} | | And Assign classify table to exporter | ${dut1_node} | ${table_index} | | ... | ${ip_version} | | Then Send packets and verify IPFIX | ${tg_node} | ${dut1_node} | | ... | ${tg_to_dut1} | ${dut1_to_tg} | ${tg_to_dut1_ip} | ${dut2_to_dut1_ip} | TC05: DUT reports packet flow for traffic by source and destination port | | [Tags] | SKIP_VPP_PATCH | | [Documentation] | | ... | [Top] TG-DUT1-DUT2-TG. [Cfg] On DUT1 configure IPFIX with TG interface | | ... | address as collector and add classify session with TG source address | | ... | and source and destination ports. | | ... | [Ver] Make TG send a packet to DUT1, then listen for IPFIX template | | ... | and data packets, verify that IPFIX reported the received packet. | | ... | [Ref] RFC 7011 | | Given Configure path in 3-node circular topology | | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']} | | And Set interfaces in 3-node circular topology up | | And VPP Interface Set IP Address | ${dut1_node} | | ... | ${dut1_to_tg} | ${dut1_to_tg_ip} | ${prefix_length} | | And VPP Add IP Neighbor | ${dut1_node} | ${dut1_to_tg} | ${tg_to_dut1_ip} | | ... | ${tg_to_dut1_mac} | | ${table_index} | ${skip_n} | ${match_n}= | | ... | And VPP creates classify table L3 | ${dut1_node} | ${ip_version} | | ... | src proto l4 src_port dst_port | | And VPP configures classify session generic | ${dut1_node} | | ... | acl-hit-next permit | ${table_index} | ${skip_n} | ${match_n} | | ... | l3 ${ip_version} src ${tg_to_dut1_ip} | | ... | proto 6 l4 src_port ${port} dst_port ${port} | | When Assign interface to flow table | ${dut1_node} | ${dut1_to_tg} | | ... | ${table_index} | ip_version=${ip_version} | | And Setup IPFIX exporter | ${dut1_node} | ${tg_to_dut1_ip} | | ... | ${dut1_to_tg_ip} | interval=5 | | And Set IPFIX stream | ${dut1_node} | ${1} | | And Assign classify table to exporter | ${dut1_node} | ${table_index} | | ... | ${ip_version} | | Then Send packets and verify IPFIX | ${tg_node} | ${dut1_node} | | ... | ${tg_to_dut1} | ${dut1_to_tg} | ${tg_to_dut1_ip} | ${dut1_to_tg_ip} | | ... | port=${port} # TODO: DUT reports packet flow when ACL is configured with wildcards