# Copyright (c) 2022 Cisco and/or its affiliates. # Licensed under the Apache License, Version 2.0 (the "License"); # you may not use this file except in compliance with the License. # You may obtain a copy of the License at: # # http://www.apache.org/licenses/LICENSE-2.0 # # Unless required by applicable law or agreed to in writing, software # distributed under the License is distributed on an "AS IS" BASIS, # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. # See the License for the specific language governing permissions and # limitations under the License. *** Settings *** | Resource | resources/libraries/robot/shared/default.robot | Resource | resources/libraries/robot/ip/geneve.robot | | Force Tags | 2_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | NDRPDR | ... | NIC_Intel-X710 | ETH | IP4FWD | IP4BASE | UDP | ENCAP | GENEVE_L3MODE | ... | SCALE | GENEVE4_4TUN | DRV_VFIO_PCI | ... | RXQ_SIZE_0 | TXQ_SIZE_0 | ... | ethip4--ethip4udpgeneve-4tun-ip4base | | Suite Setup | Setup suite topology interfaces | performance | Suite Teardown | Tear down suite | performance | Test Setup | Setup test | performance | Test Teardown | Tear down test | performance | geneve4 | | Test Template | Local Template | | Documentation | **RFC2544: Pkt throughput GENEVE tunnel L3 mode performance \ | ... | test cases** | ... | | ... | - **[Top] Network Topologies:** TG-DUT1-TG 2-node circular topology \ | ... | with single links between nodes. | ... | | ... | - **[Enc] Packet Encapsulations:** Eth-IPv4 between TG-if1 and \ | ... | DUT1-if1 and Eth-IPv4-UDP-GENEVE-Eth-IPv4 between DUT1-if2 and TG-if2 \ | ... | for IPv4 routing over GENEVE tunnels. | ... | | ... | - **[Cfg] DUT configuration:** DUT1 is configured with IPv4 routing \ | ... | over ${n_tunnels} GENEVE tunnels and ${${4} * ${n_tunnels}} static \ | ... | IPv4 /24 route entries. DUT1 is tested with ${nic_name}. | ... | | ... | - **[Ver] TG verification:** TG finds and reports throughput NDR (Non \ | ... | Drop Rate) with zero packet loss tolerance and throughput PDR \ | ... | (Partial Drop Rate) with non-zero packet loss tolerance (LT) \ | ... | expressed in percentage of packets transmitted. NDR and PDR are \ | ... | discovered for different Ethernet L2 frame sizes using MLRsearch \ | ... | library. | ... | Test packets are generated by TG on links to DUT1. TG traffic profile \ | ... | contains two L3 flow-groups (flow-group per direction, 1 flow per \ | ... | flow-group) with all packets containing Ethernet header, IPv4 header \ | ... | with IP protocol=61 and static payload. MAC addresses are matching MAC \ | ... | addresses of the TG node interfaces. | ... | | ... | - **[Ref] Applicable standard specifications:** RFC2544, RFC791, \ | ... | RFC768 and RFC8926. *** Variables *** | @{plugins_to_enable}= | dpdk_plugin.so | perfmon_plugin.so | geneve_plugin.so | ${crypto_type}= | ${None} | ${nic_name}= | Intel-X710 | ${nic_driver}= | vfio-pci | ${nic_rxq_size}= | 0 | ${nic_txq_size}= | 0 | ${nic_pfs}= | 2 | ${nic_vfs}= | 0 | ${osi_layer}= | L3 | ${overhead}= | ${50} # IP settings | ${dut1_if1_ip4}= | 20.0.0.1 | ${dut1_if2_ip4}= | 30.0.0.1 | ${tg_if1_ip4}= | 20.0.0.2 | ${tg_if2_ip4}= | 30.0.0.2 # GENEVE settings | ${gen_mode}= | ${osi_layer} | ${n_tunnels}= | ${4} | &{gen_tunnel}= | ... | local=1.1.1.2 | remote=1.1.1.1 | vni=${1} | ... | src_ip=10.128.1.0 | dst_ip=10.0.1.0 | ip_mask=${24} | if_ip=11.0.1.2 # Traffic profile | ${traffic_profile}= | trex-stl-2n-ethip4-geneve-${n_tunnels}t *** Keywords *** | Local Template | | | | [Documentation] | | ... | - **[Cfg]** DUT runs GENEVE ${gen_mode} mode configuration. \ | | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads. | | ... | - **[Ver]** Measure NDR and PDR values using MLRsearch algorithm. | | | | ... | *Arguments:* | | ... | - frame_size - Framesize in Bytes in integer or string (IMIX_v4_1). | | ... | Type: integer, string | | ... | - phy_cores - Number of physical cores. Type: integer | | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer | | | | [Arguments] | ${frame_size} | ${phy_cores} | ${rxq}=${None} | | | | Set Test Variable | \${frame_size} | | | | Given Set Max Rate And Jumbo | | And Add worker threads to all DUTs | ${phy_cores} | ${rxq} | | And Pre-initialize layer driver | ${nic_driver} | | And Apply startup configuration on all VPP DUTs | | When Initialize layer driver | ${nic_driver} | | And Initialize layer interface | | And Initialize GENEVE L3 mode in circular topology | | Then Find NDR and PDR intervals using optimized search *** Test Cases *** | 64B-1c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | 64B | 1C | | frame_size=${64} | phy_cores=${1} | 64B-2c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | 64B | 2C | | frame_size=${64} | phy_cores=${2} | 64B-4c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | 64B | 4C | | frame_size=${64} | phy_cores=${4} | 1518B-1c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | 1518B | 1C | | frame_size=${1518} | phy_cores=${1} | 1518B-2c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | 1518B | 2C | | frame_size=${1518} | phy_cores=${2} | 1518B-4c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | 1518B | 4C | | frame_size=${1518} | phy_cores=${4} | 9000B-1c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | 9000B | 1C | | frame_size=${9000} | phy_cores=${1} | 9000B-2c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | 9000B | 2C | | frame_size=${9000} | phy_cores=${2} | 9000B-4c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | 9000B | 4C | | frame_size=${9000} | phy_cores=${4} | IMIX-1c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | IMIX | 1C | | frame_size=IMIX_v4_1 | phy_cores=${1} | IMIX-2c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | IMIX | 2C | | frame_size=IMIX_v4_1 | phy_cores=${2} | IMIX-4c-ethip4--ethip4udpgeneve-4tun-ip4base-ndrpdr | | [Tags] | IMIX | 4C | | frame_size=IMIX_v4_1 | phy_cores=${4}