Update static report content - Honeycomb

[csit.git] / docs / report / honeycomb_functional_tests / overview.rst

diff --git a/docs/report/honeycomb_functional_tests/overview.rst b/docs/report/honeycomb_functional_tests/overview.rst
index 1c992a5..493499a 100644 (file)
--- a/docs/report/honeycomb_functional_tests/overview.rst
+++ b/docs/report/honeycomb_functional_tests/overview.rst
@@ -5,13 +5,11 @@ Tested Virtual Topologies
 -------------------------
 
 CSIT Honeycomb functional tests are executed on virtualized topologies created
-using Virtual Internet Routing Lab (VIRL) simulation platform contributed by
-Cisco. VIRL runs on physical baremetal servers hosted by LF FD.io project. All
-tests are executed in two node logical test topology - Traffic Generator (TG)
-node and Systems Under Test (SUT1) node connected in a loop. Logical test
-topology is shown in the figure below.
-
-::
+using :abbr:`VIRL (Virtual Internet Routing Lab)` simulation platform
+contributed by Cisco. VIRL runs on physical baremetal servers hosted by LF FD.io
+project. All tests are executed in two node logical test topology - Traffic
+Generator (TG) node and Systems Under Test (SUT1) node connected in a loop.
+Logical test topology is shown in the figure below.::
 
                      +------------------------+
                      |                        |
@@ -107,7 +105,12 @@ with results listed in this report:
   - Configure and delete Lisp mapping as local and remote.
   - Configure and delete Lisp adjacency mapping
   - Configure and delete Lisp map resolver, proxy ITR.
-  - Test case count: 16
+  - Test case count: 18
+- **LISP GPE** - CRUD for LISP GPE mappings.
+  - Toggle Lisp GPE feature status.
+  - Configure Lisp GPE mappings.
+  - Traffic test verifying encapsulation.
+  - Test case count: 12
 - **NAT** - CRD for NAT entries, interface assignment.
   - Configure and delete up to two NAT entries.
   - Assign NAT entries to a physical interface.
@@ -148,11 +151,16 @@ with results listed in this report:
   - Configure Policing rules.
   - Assign to interface.
   - Test case count: 6
+- **Border Gateway Protocol** - CRUD and functional tests for BGP.
+  - Configure peers and routes
+  - Check interactions with another BGP peer.
+  - Test case count: 9
 - **Honeycomb Infractructure** - configuration persistence,
   - Netconf notifications for interface events,
   - Netconf negative tests aimed at specific issues
+  - Netconf/Restconf northbound over IPv6
 
-Total 173 Honeycomb functional tests in the CSIT |release|.
+Total 217 Honeycomb functional tests in the CSIT |release|.
 
 Operational data in Honeycomb should mirror configuration data at all times.
 Because of this, test cases follow this general pattern: