-CSIT Release Notes\r
-==================\r
-\r
-Changes in CSIT |release|\r
--------------------------\r
-\r
-#. **VPP performance tests**\r
-\r
- - *MRR tests* - New Maximum Receive Rate tests measure the packet\r
- forwarding rate under the maximum load offered by traffic\r
- generator over a set trial duration, regardless of packet loss.\r
- MRR tests are used for continuous performance trending and for\r
- comparison between releases.\r
-\r
- - *Service Chaining with SRv6* - New SRv6 (Segment Routing IPv6) proxy\r
- tests measure performance of SRv6 Endpoint fronting SR-unaware\r
- appliance via masquerading (End.AM), dynamic proxy (End.AD) or\r
- static proxy (End.AS) SR functions.\r
-\r
-#. **Presentation and Analytics Layer**\r
-\r
- - *Performance trending* - Added continuous performance trending and\r
- analysis. New Performance Trending and Performance Analysis jobs\r
- executed regular throughput tests, with results being subsequently\r
- analysed and trend and anomalies summarized and presented in VPP\r
- Performance Dashboard and trendline graphs.\r
-\r
-#. **Test Framework Optimizations**\r
-\r
- - *Performance tests efficiency* - Qemu build/install optimizations,\r
- warmup phase handling, vpp restart handling. Resulted in improved\r
- stability and reduced total execution time by 30% for single pkt\r
- size e.g. 64B/78B.\r
-\r
- - *General code housekeeping* - ongoing RF keywords optimizations,\r
- removal of redundant RF keywords.\r
-\r
-Performance Changes\r
--------------------\r
-\r
-Relative performance changes in measured packet throughput in CSIT\r
-|release| are calculated against the results from CSIT |release-1|\r
-report. Listed mean and standard deviation values are computed based on\r
-a series of the same tests executed against respective VPP releases to\r
-verify test results repeatibility, with percentage change calculated for\r
-mean values. Note that the standard deviation is quite high for a small\r
-number of packet throughput tests, what indicates poor test results\r
-repeatability and makes the relative change of mean throughput value not\r
-fully representative for these tests. The root causes behind poor\r
-results repeatibility vary between the test cases.\r
-\r
-NDR Changes\r
-~~~~~~~~~~~\r
-\r
-NDR small packet throughput changes between releases are available in a\r
-CSV and pretty ASCII formats:\r
-\r
- - `csv format for 1t1c <../_static/vpp/performance-changes-ndr-1t1c-full.csv>`_,\r
- - `csv format for 2t2c <../_static/vpp/performance-changes-ndr-2t2c-full.csv>`_,\r
- - `pretty ASCII format for 1t1c <../_static/vpp/performance-changes-ndr-1t1c-full.txt>`_,\r
- - `pretty ASCII format for 2t2c <../_static/vpp/performance-changes-ndr-2t2c-full.txt>`_.\r
-\r
-PDR Changes\r
-~~~~~~~~~~~\r
-\r
-NDR small packet throughput changes between releases are available in a\r
-CSV and pretty ASCII formats:\r
-\r
- - `csv format for 1t1c <../_static/vpp/performance-changes-pdr-1t1c-full.csv>`_,\r
- - `csv format for 2t2c <../_static/vpp/performance-changes-pdr-2t2c-full.csv>`_,\r
- - `pretty ASCII format for 1t1c <../_static/vpp/performance-changes-pdr-1t1c-full.txt>`_,\r
- - `pretty ASCII format for 2t2c <../_static/vpp/performance-changes-pdr-2t2c-full.txt>`_.\r
-\r
-MRR Changes\r
-~~~~~~~~~~~\r
-\r
-MRR small packet throughput changes between releases are available in a\r
-CSV and pretty ASCII formats:\r
-\r
- - `csv format for 1t1c <../_static/vpp/performance-changes-mrr-1t1c-full.csv>`_,\r
- - `csv format for 2t2c <../_static/vpp/performance-changes-mrr-2t2c-full.csv>`_,\r
- - `csv format for 4t4c <../_static/vpp/performance-changes-mrr-4t4c-full.csv>`_,\r
- - `pretty ASCII format for 1t1c <../_static/vpp/performance-changes-mrr-1t1c-full.txt>`_,\r
- - `pretty ASCII format for 2t2c <../_static/vpp/performance-changes-mrr-2t2c-full.txt>`_,\r
- - `pretty ASCII format for 4t4c <../_static/vpp/performance-changes-mrr-4t4c-full.txt>`_.\r
-\r
-Throughput Trending\r
--------------------\r
-\r
-In addition to reporting throughput changes between VPP releases, CSIT\r
-provides continuous performance trending for VPP master branch:\r
-\r
-#. `VPP Performance Dashboard <https://docs.fd.io/csit/master/trending/introduction/index.html>`_\r
- - per VPP test case throughput trend, trend compliance and summary of\r
- detected anomalies.\r
-\r
-#. `Trending Methodology <https://docs.fd.io/csit/master/trending/methodology/index.html>`_\r
- - throughput test metrics, trend calculations and anomaly\r
- classification (progression, regression, outlier).\r
-\r
-#. `Trendline Graphs <https://docs.fd.io/csit/master/trending/trending/index.html>`_\r
- - per VPP build MRR throughput measurements against the trendline\r
- with anomaly highlights, with associated CSIT test jobs.\r
-\r
-Known Issues\r
-------------\r
-\r
-List of known issues in CSIT |release| for VPP performance tests:\r
-\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
-| # | Issue | Jira ID | Description |\r
-+===+=================================================+============+=================================================================+\r
-| 1 | Sporadic (1 in 200) NDR discovery test failures | CSIT-570 | DPDK reporting rx-errors, indicating L1 issue. Suspected issue |\r
-| | on x520. | | with HW combination of X710-X520 in LF testbeds. Not observed |\r
-| | | | outside of LF testbeds. |\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
-| 2 | Lower than expected NDR throughput of DPDK | CSIT-571 | Suspected NIC firmware or DPDK driver issue affecting NDR and |\r
-| | testpmd and VPP L2 path NDR throughput with | | PDR throughput on XL710 and X710 NICs. |\r
-| | xl710 and x710 NICs, compared to x520 NICs. | | |\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
-| 3 | Tagged Ethernet dot1q and dot1ad L2 path | CSIT-1066 | Tagged Ethernet dot1q and dot1ad L2 path throughput regression: |\r
-| | throughput regression. | | NDR -2%..-5%, PDR -2%..-6%, MRR. Affects l2xc and l2bd |\r
-| | | | performance tests. |\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
-| 4 | IPSec (software, no QAT HW) throughput | CSIT-1064 | IPSec throughput regression: NDR -3%..-8%, PDR -2%..-8%, MRR |\r
-| | regression. | | -3%..-7%. Affects IPSec SW tests, QAT HW tests not affected. |\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
-| 5 | High failure rate of creating working container | CSIT-1065 | Orchestrated container topology tests failing data plane |\r
-| | topologies with K8s/Ligato orchestration. | | verification indicating configuration issue. Suspected issue |\r
-| | | | with Ligato vpp-agent. |\r
-+---+-------------------------------------------------+------------+-----------------------------------------------------------------+\r
+Release Notes
+=============
+
+Changes in |csit-release|
+-------------------------
+
+#. VPP PERFORMANCE TESTS
+
+ - **Service density 2n-skx tests**: Added higher NF density tests with two
+ NFs' data-plane threads sharing a physical core. VPP IPv4 routing is now
+ used as a VNF payload similar to CNF tests.
+
+ - **Soak Tests**: Optimized performamce soak tests framework
+ code for extended time duration tests and throughput discovery
+ at given PLR and at give total test time e.g. minutes, hours,
+ days, weeks. See updated
+ :ref:`test_methodology` section for more details.
+
+#. TEST FRAMEWORK
+
+ - **Qemu code refactor**: Complete code refactor of the key components of
+ QemuUtil.py and QemuManager.py (L1 and L2 KW counterparts). Added
+ implementation of kernel-image-kvm based VM replacing the previously used
+ NestedVM images. Added ability to run VPP as a payload in VNF.
+
+ - **CSIT PAPI Support**: Continued conversion of CSIT VAT L1 keywords to
+ PAPI L1 KWs in CSIT using VPP Python bindings. Redesign of key components
+ of PAPI Executor and PAPI history.
+
+ - **General Code Housekeeping**: Ongoing RF keywords optimizations,
+ removal of redundant RF keywords.
+
+ - **Test suite generator**: Added capability to generate suites for
+ different NIC models as well as throughput search algorithm types. Uses
+ base tests suites as source.
+
+ - **TOX verification**: Added verifications for test suite generator.
+
+#. PRESENTATION AND ANALYTICS LAYER
+
+ - **Graphs Layout Improvements**: Improved performance graphs layout
+ for better readibility and maintenance: test grouping, axis
+ labels, descriptions, other informative decoration.
+
+..
+ #. MISCELLANEOUS
+
+ - **2n-dnv Tests (3rd Party)**: Published performance tests for 2n-
+ dnv (2-Node Atom Denverton) from 3rd party testbeds running FD.io
+ |csit-release| automated testing code.
+ Only graphs for Packet Throughput and Speedup Multi-core and not
+ for Packet Latency were published as there are no results for Packet
+ Latency available.
+
+.. raw:: latex
+
+ \clearpage
+
+.. _vpp_known_issues:
+
+Known Issues
+------------
+
+List of known issues in |csit-release| for VPP performance tests:
+
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
+| # | JiraID | Issue Description |
++====+=========================================+==========================================================================================================+
+| 1 | `CSIT-570 | Sporadic (1 in 200) NDR discovery test failures on x520. DPDK reporting rx-errors, indicating L1 issue. |
+| | <https://jira.fd.io/browse/CSIT-570>`_ | Suspected issue with HW combination of X710-X520 in LF testbeds. Not observed outside of LF testbeds. |
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
+| 2 | `CSIT-1503 | [`TRex-519 <https://trex-tgn.cisco.com/youtrack/issue/trex-519>`_] XL710/XXV710 with FW 6.0.1 will have |
+| | <https://jira.fd.io/browse/CSIT-1503>`_ | Rx drop rate of 27MPPS. |
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
+| 3 | `CSIT-1501 | Sporadic crypto backend fails loading `VPP-1670 <https://jira.fd.io/browse/VPP-1670>`_ |
+| | <https://jira.fd.io/browse/CSIT-1501>`_ | |
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
+| 4 | `CSIT-1427 | Sporadic HW aes-128-cbc-sha1 tunnel-interface tests are failing. |
+| | <https://jira.fd.io/browse/CSIT-1427>`_ | `VPP-1671 <https://jira.fd.io/browse/VPP-1671>`_ |
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
+| 5 | `CSIT-1498 | Memif tests are sporadically failing on initialization of memif connection. |
+| | <https://jira.fd.io/browse/CSIT-1498>`_ | |
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
+| 6 | `CSIT-1499 | AVF tests are sporadically failing on initialization of AVF interface. |
+| | <https://jira.fd.io/browse/CSIT-1499>`_ | |
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
+| 7 | `VPP-1676 | 9000B ip4 memif errors - ip4-input: ip4 length > l2 length. |
+| | <https://jira.fd.io/browse/VPP-1676>`_ | IP4 jumbo frames (9000B) are dropped in case of tests with memif. |
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
+| 8 | `VPP-1677 | 9000B ip4 nat44: VPP crash + coredump. |
+| | <https://jira.fd.io/browse/VPP-1677>`_ | VPP crashes very often in case that NAT44 is configured and it has to process IP4 jumbo frames (9000B). |
++----+-----------------------------------------+----------------------------------------------------------------------------------------------------------+
Code Review / csit.git / blobdiff