Remove: VIRL

[csit.git] / resources / tools / disk-image-builder / ubuntu / scripts-remote / serial-console-ubuntu-14.04.4.sh

diff --git a/resources/tools/disk-image-builder/ubuntu/scripts-remote/serial-console-ubuntu-14.04.4.sh b/resources/tools/disk-image-builder/ubuntu/scripts-remote/serial-console-ubuntu-14.04.4.sh
deleted file mode 100644 (file)
index 5287904..0000000
--- a/resources/tools/disk-image-builder/ubuntu/scripts-remote/serial-console-ubuntu-14.04.4.sh
+++ /dev/null
@@ -1,57 +0,0 @@
-#!/bin/sh -e
-
-# Copyright (c) 2016 Cisco and/or its affiliates.
-# Licensed under the Apache License, Version 2.0 (the "License");
-# you may not use this file except in compliance with the License.
-# You may obtain a copy of the License at:
-#
-#     http://www.apache.org/licenses/LICENSE-2.0
-#
-# Unless required by applicable law or agreed to in writing, software
-# distributed under the License is distributed on an "AS IS" BASIS,
-# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
-# See the License for the specific language governing permissions and
-# limitations under the License.
-
-##
-## Serial console
-##
-echo "********** CONFIGURING SERIAL CONSOLE AND DISABLING IPV6 **********"
-cat - > /etc/init/ttyS0.conf <<"_EOF"
-# ttyS0 - getty
-#
-# This service maintains a getty on ttyS0 from the point the system is
-# started until it is shut down again.
-
-start on stopped rc RUNLEVEL=[12345]
-stop on runlevel [!12345]
-
-respawn
-exec /sbin/getty -L 115200 ttyS0 vt102
-_EOF
-
-cat - > /etc/default/grub <<"_EOF"
-# If you change this file, run 'update-grub' afterwards to update
-# /boot/grub/grub.cfg.
-# For full documentation of the options in this file, see:
-#   info -f grub -n 'Simple configuration'
-
-GRUB_DEFAULT=0
-GRUB_TIMEOUT=1
-GRUB_DISTRIBUTOR=`lsb_release -i -s 2> /dev/null || echo Debian`
-GRUB_CMDLINE_LINUX="console=tty0 console=ttyS0,115200n8 ipv6.disable=1"
-
-GRUB_TERMINAL=serial
-GRUB_SERIAL_COMMAND="serial --speed=115200 --unit=0 --word=8 --parity=no --stop=1"
-
-# Uncomment if you don't want GRUB to pass "root=UUID=xxx" parameter to Linux
-#GRUB_DISABLE_LINUX_UUID=true
-
-# Uncomment to disable generation of recovery mode menu entries
-#GRUB_DISABLE_RECOVERY="true"
-
-# Uncomment to get a beep at grub start
-#GRUB_INIT_TUNE="480 440 1"
-_EOF
-
-update-grub