csit-func-tc-naming-change - phase 1
[csit.git] / tests / func / telemetry / span / eth2p-ethip4-ip4base-spanrx-func.robot
@@ -36,8 +36,6 @@
 *** Variables ***
 | ${tg_to_dut_if1_ip4}= | 192.168.1.1
 | ${dut_to_tg_if1_ip4}= | 192.168.1.2
-| ${tg_to_dut_if1_ip6}= | 11::1
-| ${dut_to_tg_if1_ip6}= | 10::1
 | ${prefix}= | 24
 
 *** Test Cases ***
 | | ... | ${tg_to_dut_if1} | ${tg_to_dut_if1_mac}
 | | ... | ${dut_to_tg__if1_mac} | ${tg_to_dut_if2}
 | | ... | ${tg_to_dut_if1_ip4} | ${dut_to_tg_if1_ip4} | ICMP
-
-| TC03: DUT mirrors IPv6 packets from one interface to another
-| | [Documentation]
-| | ... | [Top] TG=DUT1
-| | ... | [Cfg] On DUT1 configure IPv6 address, add ARP entry for one TG \
-| | ... | interface and set SPAN mirroring from one DUT interface to the other.
-| | ... | [Ver] Make TG send an ICMP packet to DUT through one interface,\
-| | ... | then receive a copy of sent packet and of DUT's ICMP reply\
-| | ... | on the other interface.
-| | Given Path For 2-node Testing Is Set | ${nodes['TG']} | ${nodes['DUT1']}
-| | ... | ${nodes['TG']}
-| | And Interfaces In 2-node Path Are Up
-| | And Set interface Address | ${dut_node} | ${dut_to_tg_if1}
-| | ... | ${dut_to_tg_if1_ip6} | ${prefix}
-| | And Add ARP on DUT | ${dut_node} | ${dut_to_tg_if1} | ${tg_to_dut_if1_ip6}
-| | ... | ${tg_to_dut_if1_mac}
-| | And Set SPAN Mirroring | ${dut_node} | ${dut_to_tg_if1} | ${dut_to_tg_if2}
-| | Then Send Packet And Check Received Copies | ${tg_node}
-| | ... | ${tg_to_dut_if1} | ${tg_to_dut_if1_mac}
-| | ... | ${dut_to_tg__if1_mac} | ${tg_to_dut_if2}
-| | ... | ${tg_to_dut_if1_ip6} | ${dut_to_tg_if1_ip6} | ICMP