--- /dev/null
+# Copyright (c) 2016 Cisco and/or its affiliates.
+# Licensed under the Apache License, Version 2.0 (the "License");
+# you may not use this file except in compliance with the License.
+# You may obtain a copy of the License at:
+#
+# http://www.apache.org/licenses/LICENSE-2.0
+#
+# Unless required by applicable law or agreed to in writing, software
+# distributed under the License is distributed on an "AS IS" BASIS,
+# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+# See the License for the specific language governing permissions and
+# limitations under the License.
+
+*** Settings ***
+| Resource | resources/libraries/robot/default.robot
+| Resource | resources/libraries/robot/counters.robot
+| Resource | resources/libraries/robot/interfaces.robot
+| Resource | resources/libraries/robot/iacl.robot
+| Resource | resources/libraries/robot/ipv6.robot
+| Resource | resources/libraries/robot/l2_xconnect.robot
+| Resource | resources/libraries/robot/traffic.robot
+| Library | resources.libraries.python.Classify.Classify
+| Library | resources.libraries.python.Trace
+
+| Force Tags | HW_ENV | VM_ENV | 3_NODE_SINGLE_LINK_TOPO
+| Suite Setup | Run Keywords | Setup all TGs before traffic script
+| ... | AND | Update All Interface Data On All Nodes | ${nodes}
+| Test Setup | Setup all DUTs before test
+| Test Teardown | Show packet trace on all DUTs | ${nodes}
+
+*** Variables ***
+| ${dut1_if1_ip}= | 3ffe:62::1
+| ${dut1_if2_ip}= | 3ffe:63::1
+| ${dut1_if2_ip_GW}= | 3ffe:63::2
+| ${dut2_if1_ip}= | 3ffe:72::1
+| ${dut2_if2_ip}= | 3ffe:73::1
+| ${test_dst_ip}= | 3ffe:64::1
+| ${test_src_ip}= | 3ffe:61::1
+| ${prefix_length}= | 64
+
+*** Test Cases ***
+| VPP drops packets based on IPv6 source addresses
+| | [Documentation] | Create classify table on VPP, add source IP address
+| | ... | of traffic into table and setup 'deny' traffic
+| | ... | and check if traffic is dropped.
+| | Given Node path computed for 3-node topology
+| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']}
+| | And Interfaces in path are up
+| | And IPv6 Addresses set on the node interfaces
+| | ... | ${dut1_node} | ${dut1_if1} | ${dut1_if1_ip} | ${dut1_if2}
+| | ... | ${dut1_if2_ip} | ${prefix_length}
+| | ${table_index} | ${skip_n} | ${match_n}= | When Vpp Create Classify Table
+| | ... | ${dut1_node} | ip6 | src
+| | And Vpp Configure Classify Session
+| | ... | ${dut1_node} | deny | ${table_index} | ${skip_n} | ${match_n}
+| | ... | ip6 | src | ${test_src_ip}
+| | And Vpp Enable Input Acl Interface
+| | ... | ${dut1_node} | ${dut1_if1} | ip6 | ${table_index}
+| | And Add Ip Neighbor
+| | ... | ${dut1_node} | ${dut1_if2} | ${dut1_if2_ip_GW} | ${tg_if2_mac}
+| | And Vpp Route Add
+| | ... | ${dut1_node} | ${test_dst_ip} | ${prefix_length} | ${dut1_if2_ip_GW}
+| | ... | ${dut1_if2}
+| | And L2 setup xconnect on DUT | ${dut2_node} | ${dut2_if1} | ${dut2_if2}
+| | Then Send packet from Port to Port should failed | ${tg_node} |
+| | ... | ${test_src_ip} | ${test_dst_ip} | ${tg_if1} | ${tg_if1_mac} |
+| | ... | ${dut1_if1_mac} | ${tg_if2} | ${dut1_if2_mac} | ${tg_if2_mac}
+
+
+| VPP drops packets based on IPv6 destination addresses
+| | [Documentation] | Create classify table on VPP, add destination IP address
+| | ... | of traffic into table and setup 'deny' traffic
+| | ... | and check if traffic is dropped.
+| | Given Node path computed for 3-node topology
+| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']}
+| | And Interfaces in path are up
+| | And IPv6 Addresses set on the node interfaces
+| | ... | ${dut1_node} | ${dut1_if1} | ${dut1_if1_ip} | ${dut1_if2}
+| | ... | ${dut1_if2_ip} | ${prefix_length}
+| | ${table_index} | ${skip_n} | ${match_n}= | When Vpp Create Classify Table
+| | ... | ${dut1_node} | ip6 | dst
+| | And Vpp Configure Classify Session
+| | ... | ${dut1_node} | deny | ${table_index} | ${skip_n} | ${match_n}
+| | ... | ip6 | dst | ${test_dst_ip}
+| | And Vpp Enable Input Acl Interface
+| | ... | ${dut1_node} | ${dut1_if1} | ip6 | ${table_index}
+| | And Add Ip Neighbor
+| | ... | ${dut1_node} | ${dut1_if2} | ${dut1_if2_ip_GW} | ${tg_if2_mac}
+| | And Vpp Route Add
+| | ... | ${dut1_node} | ${test_dst_ip} | ${prefix_length} | ${dut1_if2_ip_GW}
+| | ... | ${dut1_if2}
+| | And L2 setup xconnect on DUT | ${dut2_node} | ${dut2_if1} | ${dut2_if2}
+| | Then Send packet from Port to Port should failed | ${tg_node} |
+| | ... | ${test_src_ip} | ${test_dst_ip} | ${tg_if1} | ${tg_if1_mac} |
+| | ... | ${dut1_if1_mac} | ${tg_if2} | ${dut1_if2_mac} | ${tg_if2_mac}
+
+
+| VPP drops packets based on IPv6 src-addr and dst-addr
+| | [Documentation] | Create classify table on VPP, add source and destination
+| | ... | IP address of traffic into table and setup 'deny' traffic
+| | ... | and check if traffic is dropped.
+| | Given Node path computed for 3-node topology
+| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']}
+| | And Interfaces in path are up
+| | And IPv6 Addresses set on the node interfaces
+| | ... | ${dut1_node} | ${dut1_if1} | ${dut1_if1_ip} | ${dut1_if2}
+| | ... | ${dut1_if2_ip} | ${prefix_length}
+| | ${table_index_1} | ${skip_n_1} | ${match_n_1}=
+| | ... | When Vpp Create Classify Table | ${dut1_node} | ip6 | src
+| | ${table_index_2} | ${skip_n_2} | ${match_n_2}=
+| | ... | When Vpp Create Classify Table | ${dut1_node} | ip6 | dst
+| | And Vpp Configure Classify Session
+| | ... | ${dut1_node} | deny | ${table_index_1} | ${skip_n_1} | ${match_n_2}
+| | ... | ip6 | src | ${test_src_ip}
+| | And Vpp Configure Classify Session
+| | ... | ${dut1_node} | deny | ${table_index_2} | ${skip_n_2} | ${match_n_2}
+| | ... | ip6 | dst | ${test_dst_ip}
+| | And Vpp Enable Input Acl Interface
+| | ... | ${dut1_node} | ${dut1_if1} | ip6 | ${table_index_1}
+| | And Vpp Enable Input Acl Interface
+| | ... | ${dut1_node} | ${dut1_if1} | ip6 | ${table_index_2}
+| | And Add Ip Neighbor
+| | ... | ${dut1_node} | ${dut1_if2} | ${dut1_if2_ip_GW} | ${tg_if2_mac}
+| | And Vpp Route Add
+| | ... | ${dut1_node} | ${test_dst_ip} | ${prefix_length} | ${dut1_if2_ip_GW}
+| | ... | ${dut1_if2}
+| | And L2 setup xconnect on DUT | ${dut2_node} | ${dut2_if1} | ${dut2_if2}
+| | Then Send packet from Port to Port should failed | ${tg_node} |
+| | ... | ${test_src_ip} | ${test_dst_ip} | ${tg_if1} | ${tg_if1_mac} |
+| | ... | ${dut1_if1_mac} | ${tg_if2} | ${dut1_if2_mac} | ${tg_if2_mac}
Code Review / csit.git / blobdiff