| Test Setup | Setup all DUTs before test
| Test Teardown | Run Keywords | Remove startup configuration of VPP from all DUTs
| ... | AND | Show vpp trace dump on all DUTs
-| Documentation | *Reference NDR throughput L2XC with dot1ad verify test cases*
+| Documentation | *Reference NDR throughput L2XC with 802.1ad verify test cases*
| ...
| ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology
| ... | with single links between nodes.
-| ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for L2 switching of IPv4.
-| ... | Dot1ad tagging is applied on link between DUT1 and DUT2 with inner 4B
+| ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for L2 xconnect.
+| ... | 802.1ad tagging is applied on link between DUT1 and DUT2 with inner 4B
| ... | vlan tag (id=100) and outer 4B vlan tag (id=200).
| ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with L2 cross-
| ... | connect. DUT1 and DUT2 tested with 2p10GE NIC X520 Niantic by Intel.
| ... | DUTs' throughput at ref-NDR (reference Non Drop Rate) with zero packet
| ... | loss tolerance. Ref-NDR value is periodically updated acording to
| ... | formula: ref-NDR = 0.9x NDR, where NDR is found in RFC2544 long
-| ... | performance tests for the same DUT confiiguration. Test packets are
+| ... | performance tests for the same DUT configuration. Test packets are
| ... | generated by TG on links to DUTs. TG traffic profile contains two L3
| ... | flow-groups (flow-group per direction, 253 flows per flow-group) with
| ... | all packets containing Ethernet header, IPv4 header with IP protocol=61
-| ... | and generated payload.
+| ... | and generated payload. MAC addresses are matching MAC addresses of the
+| ... | TG node interfaces.
| ... | *[Ref] Applicable standard specifications:* RFC2544.
*** Variables ***
| ${tag_rewrite}= | pop-2
*** Test Cases ***
-| TC01: Verify 64B ref-NDR at 2x 2.9Mpps - DUT L2XC with dot1ad - 1thread 1core 1rxq
+| TC01: Verify 64B ref-NDR at 2x 2.9Mpps - DUT L2XC with 802.1ad - 1thread 1core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 1 thread, 1 phy core, \
| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 64 Byte
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC02: Verify 1514B ref-NDR at 2x 810.635kpps - DUT L2XC with dot1ad - 1thread 1core 1rxq
+| TC02: Verify 1514B ref-NDR at 2x 810.635kpps - DUT L2XC with 802.1ad - 1thread 1core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 1 thread, 1 phy core, \
| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 1514 Byte
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC03: Verify 9000B ref-NDR at 2x 138.458kpps - DUT L2XC with dot1ad - 1thread 1core 1rxq
+| TC03: Verify 9000B ref-NDR at 2x 138.458kpps - DUT L2XC with 802.1ad - 1thread 1core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC config with 1 thread, 1 phy core, \
| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 9000 Byte
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC04: Verify 64B ref-NDR at 2x 7Mpps - DUT L2XC with dot1ad - 2thread 2core 1rxq
+| TC04: Verify 64B ref-NDR at 2x 7Mpps - DUT L2XC with 802.1ad - 2thread 2core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC switching config with 2 thread, 2 phy core, \
| | ... | 1 receive queue per NIC port. [Ver] Find PDR for 64 Byte frames
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC05: Verify 1514B ref-NDR at 2x 810.635kpps - DUT L2XC with dot1ad - 2thread 2core 1rxq
+| TC05: Verify 1514B ref-NDR at 2x 810.635kpps - DUT L2XC with 802.1ad - 2thread 2core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC switching config with 2 thread, 2 phy core, \
| | ... | 1 receive queue per NIC port. [Ver] Find PDR for 1514 Byte frames
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC06: Verify 9000B ref-NDR at 2x 138.458kpps - DUT L2XC with dot1ad - 2thread 2core 1rxq
+| TC06: Verify 9000B ref-NDR at 2x 138.458kpps - DUT L2XC with 802.1ad - 2thread 2core 1rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC switching config with 2 thread, 2 phy core, \
| | ... | 1 receive queue per NIC port. [Ver] Find PDR for 9000 Byte frames
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC07: Verify 64B ref-NDR at 2x 8Mpps - DUT L2XC with dot1ad - 4thread 4core 2rxq
+| TC07: Verify 64B ref-NDR at 2x 8Mpps - DUT L2XC with 802.1ad - 4thread 4core 2rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC switching config with 4 thread, 4 phy core, \
| | ... | 2 receive queue per NIC port. [Ver] Find PDR for 64 Byte frames
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC08: Verify 1514B ref-NDR at 2x 810.635kpps - DUT L2XC with dot1ad - 4thread 4core 2rxq
+| TC08: Verify 1514B ref-NDR at 2x 810.635kpps - DUT L2XC with 802.1ad - 4thread 4core 2rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC switching config with 4 thread, 4 phy core, \
| | ... | 2 receive queue per NIC port. [Ver] Find PDR for 1514 Byte frames
| | Then Traffic should pass with no loss | ${duration} | ${rate}
| | ... | ${framesize} | 3-node-xconnect
-| TC09: Verify 9000B ref-NDR at 2x 138.458kpps - DUT L2XC with dot1ad - 4thread 4core 2rxq
+| TC09: Verify 9000B ref-NDR at 2x 138.458kpps - DUT L2XC with 802.1ad - 4thread 4core 2rxq
| | [Documentation]
| | ... | [Cfg] DUT runs L2XC switching config with 4 thread, 4 phy core, \
| | ... | 2 receive queue per NIC port. [Ver] Find PDR for 9000 Byte frames