-*** Test Cases ***
-| tc01-eth2p-ethicmpv4-ip4base-dev_tap-no-namespace
-| | [Documentation]
-| | ... | [Cfg] On DUT1 configure two interface addresses with IPv4 of which\
-| | ... | one is TAP interface (dut_to_tg_if and TAP) and one is linux-TAP.
-| | ... | [Ver] Packet sent from TG gets to the destination and ICMP-reply is\
-| | ... | received on TG.
-| | ...
-| | Set Test Variable | ${frame_size} | ${42}
-| | Set Test Variable | ${rxq_count_int} | ${1}
-| | ...
-| | Given Add PCI devices to all DUTs
-| | And Set Max Rate And Jumbo And Handle Multi Seg
-| | And Apply startup configuration on all VPP DUTs
-| | And VPP Enable Traces On All Duts | ${nodes}
-| | When Set interfaces in path up
-| | ${int1}= | And Add Tap Interface | ${dut1} | tap0
-| | And VPP Interface Set IP Address
-| | ... | ${dut1} | ${int1} | ${tap1_VPP_ip} | ${prefix}
-| | And VPP Interface Set IP Address
-| | ... | ${dut1} | ${dut1_if1} | ${dut_ip_address} | ${prefix}
-| | And Set Interface State | ${dut1} | ${int1} | up
-| | And Set Linux Interface MAC | ${dut1} | tap0 | ${tap1_NM_mac}
-| | And Set Linux Interface IP | ${dut1} | tap0 | ${tap1_NM_ip} | ${prefix}
-| | And Add Linux Route
-| | ... | ${dut1} | ${tg_ip_address_GW} | ${prefix} | ${tap1_VPP_ip}
-| | And VPP Add IP Neighbor
-| | ... | ${dut1} | ${dut1_if1} | ${tg_ip_address} | ${tg_if1_mac}
-| | And VPP Add IP Neighbor
-| | ... | ${dut1} | ${int1} | ${tap1_NM_ip} | ${tap1_NM_mac}
-| | Then Send ICMP echo request and verify answer
-| | ... | ${tg} | ${tg_if1} | ${dut1_if1_mac} | ${tg_if1_mac}
-| | ... | ${tap1_NM_ip} | ${tg_ip_address}
-
-| tc02-eth2p-ethicmpv4-ip4base-dev_tap-namespace