--- /dev/null
+# Copyright (c) 2019 Cisco and/or its affiliates.
+# Licensed under the Apache License, Version 2.0 (the "License");
+# you may not use this file except in compliance with the License.
+# You may obtain a copy of the License at:
+#
+# http://www.apache.org/licenses/LICENSE-2.0
+#
+# Unless required by applicable law or agreed to in writing, software
+# distributed under the License is distributed on an "AS IS" BASIS,
+# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+# See the License for the specific language governing permissions and
+# limitations under the License.
+
+*** Settings ***
+| Library | resources.libraries.python.InterfaceUtil
+| Library | resources.libraries.python.IPUtil
+| Library | resources.libraries.python.NodePath
+| Library | resources.libraries.python.topology.Topology
+| Library | resources.libraries.python.Trace
+| Library | resources.libraries.python.VhostUser
+| Library | resources.libraries.python.VPPUtil
+| Resource | resources/libraries/robot/ip/ip4.robot
+| Resource | resources/libraries/robot/l2/l2_bridge_domain.robot
+| Resource | resources/libraries/robot/shared/default.robot
+| Resource | resources/libraries/robot/shared/interfaces.robot
+| Resource | resources/libraries/robot/shared/testing_path.robot
+| Resource | resources/libraries/robot/shared/traffic.robot
+| Resource | resources/libraries/robot/vm/qemu.robot
+| ...
+| Force Tags | 2_NODE_SINGLE_LINK_TOPO | DEVICETEST | HW_ENV | DCR_ENV
+| ... | FUNCTEST | IP4FWD | BASE | ETH | VHOST | 1VM
+| ...
+| Test Setup | Set up VPP device test
+| ...
+| Test Teardown | Run Keywords
+| ... | Stop and clear QEMU | ${dut_node} | ${vm_node}
+| ... | AND | Tear down VPP device test
+| ...
+| Documentation | *IPv4 routing test cases with vhost user interface*
+| ...
+| ... | *[Top] Network Topologies:* TG-DUT1-TG 2-node circular topology with \
+| ... | VM and single links between nodes.
+| ... | *[Enc] Packet Encapsulations:* Eth-IPv4-ICMPv4 for IPv4 routing on \
+| ... | both links.
+| ... | *[Cfg] DUT configuration:* DUT1 is configured with IPv4 routing and \
+| ... | two static IPv4 /24 route entries. Qemu Guest is connected to VPP via \
+| ... | vhost-user interfaces. Guest is configured with linux bridge \
+| ... | interconnecting vhost-user interfaces.
+| ... | *[Ver] TG verification:* Test ICMPv4 Echo Request packets are sent in \
+| ... | one direction by TG on links to DUT1; on receive TG verifies packets \
+| ... | for correctness and their IPv4 src-addr, dst-addr and MAC addresses.
+| ... | *[Ref] Applicable standard specifications:* RFC791, RFC826, RFC792
+
+*** Variables ***
+| ${net1}= | 10.0.1.0
+| ${net3}= | 10.0.3.0
+| ${net1_ip1}= | 10.0.1.1
+| ${net1_ip2}= | 10.0.1.2
+| ${net2_ip1}= | 10.0.2.1
+| ${net2_ip2}= | 10.0.2.2
+| ${net3_ip1}= | 10.0.3.1
+| ${net3_ip2}= | 10.0.3.2
+| ${prefix_length}= | 24
+| ${fib_table_2}= | 20
+| ${sock1}= | /tmp/sock1
+| ${sock2}= | /tmp/sock2
+
+*** Test Cases ***
+| tc01-eth2p-ethip4-ip4base-eth-2vhost-1vm-device
+| | [Documentation]
+| | ... | Test uses two VRFs to route IPv4 traffic through two vhost-user \
+| | ... | interfaces. Both interfaces are configured with IP addresses from \
+| | ... | the same network. There is created linux bridge on VM to pass packet \
+| | ... | from one vhost-user interface to another one.
+| | ...
+| | Given Configure path in 2-node circular topology
+| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['TG']}
+| | And Configure interfaces in path up
+| | ${vhost1}= | And Vpp Create Vhost User Interface | ${dut_node} | ${sock1}
+| | ${vhost2}= | And Vpp Create Vhost User Interface | ${dut_node} | ${sock2}
+| | And Set Interface State | ${dut_node} | ${vhost1} | up
+| | And Set Interface State | ${dut_node} | ${vhost2} | up
+| | And Add Fib Table | ${dut_node} | ${fib_table_2}
+| | And Assign Interface To Fib Table | ${dut_node}
+| | ... | ${vhost2} | ${fib_table_2}
+| | And Assign Interface To Fib Table | ${dut_node}
+| | ... | ${dut_to_tg_if2} | ${fib_table_2}
+| | And Configure IP addresses on interfaces
+| | ... | ${dut_node} | ${dut_to_tg_if1} | ${net1_ip1} | ${prefix_length}
+| | ... | ${dut_node} | ${vhost1} | ${net2_ip1} | ${prefix_length}
+| | ... | ${dut_node} | ${vhost2} | ${net2_ip2} | ${prefix_length}
+| | ... | ${dut_node} | ${dut_to_tg_if2} | ${net3_ip1} | ${prefix_length}
+| | ${vhost2_mac}= | And Get Vhost User Mac By SW Index
+| | ... | ${dut_node} | ${vhost2}
+| | And Vpp Route Add | ${dut_node} | ${net3} | ${prefix_length} | ${net2_ip2}
+| | ... | ${vhost1} | resolve_attempts=${NONE} | count=${NONE}
+| | And Vpp Route Add | ${dut_node} | ${net1} | ${prefix_length} | ${net2_ip1}
+| | ... | ${vhost2} | resolve_attempts=${NONE} | count=${NONE}
+| | ... | vrf=${fib_table_2}
+| | Add IP Neighbor | ${dut_node} | ${vhost1} | ${net2_ip2} | ${vhost2_mac}
+| | Add IP Neighbor | ${dut_node} | ${dut_to_tg_if2} | ${net3_ip2}
+| | ... | ${tg_to_dut_if2_mac}
+| | When Configure VM for vhost L2BD forwarding
+| | ... | ${dut_node} | ${sock1} | ${sock2}
+| | Then Send packet and verify headers
+| | ... | ${tg_node} | ${net1_ip2} | ${net3_ip2}
+| | ... | ${tg_to_dut_if1} | ${tg_to_dut_if1_mac} | ${dut_to_tg_if1_mac}
+| | ... | ${tg_to_dut_if2} | ${dut_to_tg_if2_mac} | ${tg_to_dut_if2_mac}
Code Review / csit.git / blobdiff