X-Git-Url: https://gerrit.fd.io/r/gitweb?p=csit.git;a=blobdiff_plain;f=docs%2Freport%2Fvpp_performance_tests%2Fcsit_release_notes.rst;h=233bf4545a2b4d434d6a5e6c419b27bb22145ee8;hp=27b87c50e84164da3544b62a820d3a6461bbeab2;hb=0546e1656070b734ec57a4d8f732392bcafee0df;hpb=93907196951677ebaa47b9a384eee118cc2fad45 diff --git a/docs/report/vpp_performance_tests/csit_release_notes.rst b/docs/report/vpp_performance_tests/csit_release_notes.rst index 27b87c50e8..233bf4545a 100644 --- a/docs/report/vpp_performance_tests/csit_release_notes.rst +++ b/docs/report/vpp_performance_tests/csit_release_notes.rst @@ -1,226 +1,85 @@ -CSIT Release Notes -================== - -Changes in CSIT |release| -------------------------- - -#. Added VPP performance tests - - - **Container Topologies Orchestrated by K8s with VPP memif tests** - - - Added tests with VPP in L2 Cross-Connect and Bridge-Domain - configurations containers, with service chain topologies orchestrated by - Kubernetes. Added following forwarding topologies: i) "Parallel" with - packets flowing from NIC via VPP to container and back to VPP and NIC; - ii) "Chained" a.k.a. "Snake" with packets flowing via VPP to container, - back to VPP, to next container, back to VPP and so on until the last - container in chain, then back to VPP and NIC; iii) "Horizontal" with - packets flowing via VPP to container, then via "horizontal" memif to - next container, and so on until the last container, then back to VPP and - NIC;. - - - **VPP TCP/IP stack** - - - Added tests for VPP TCP/IP stack using VPP built-in HTTP server. - WRK traffic generator is used as a client-side; - - - **SRv6 tests** - - - Initial SRv6 (Segment Routing IPv6) tests verifying performance of - IPv6 and SRH (Segment Routing Header) encapsulation, decapsulation, - lookups and rewrites based on configured End and End.DX6 SRv6 egress - functions; - - - **IPSecSW tests** - - - SW computed IPSec encryption with AES-GCM, CBC-SHA1 ciphers, in - combination with IPv4 routed-forwarding; - -#. Presentation and Analytics Layer - - - Added throughput speedup analysis for multi-core and multi-thread - VPP tests into Presentation and Analytics Layer (PAL) for automated - CSIT test results analysis; - -#. Other improvements - - - **Framework optimizations** - - - Ability to run CSIT framework on ARM architecture; - - - Overall stability improvements; - -Performance Improvements ------------------------- - -Substantial improvements in measured packet throughput have been observed in a -number of CSIT |release| tests listed below, with relative increase of -double-digit percentage points. Relative improvements for this release are -calculated against the test results listed in CSIT |release-1| report. The -comparison is calculated between the mean values based on collected and -archived test results' samples for involved VPP releases. Standard deviation -has been also listed for CSIT |release|. Performance numbers since release -VPP-16.09 are provided for reference. - -NDR Throughput -~~~~~~~~~~~~~~ - -Non-Drop Rate Throughput discovery tests: - -.. only:: html - - .. csv-table:: - :align: center - :file: performance_improvements/performance_improvements_ndr_top.csv - -.. only:: latex - - .. raw:: latex - - \makeatletter - \csvset{ - perfimprovements column width/.style={after head=\csv@pretable\begin{longtable}{ m{1.5cm} m{4cm} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1}}\csv@tablehead}, - } - \makeatother - - {\tiny - \csvautobooklongtable[separator=comma, - respect all, - no check column count, - perfimprovements column width=1cm, - late after line={\\\hline}, - late after last line={\end{longtable}} - ]{../_tmp/src/vpp_performance_tests/performance_improvements/performance_improvements_ndr_top.csv} - } - - -PDR Throughput -~~~~~~~~~~~~~~ - -Partial Drop Rate thoughput discovery tests with packet Loss Tolerance of 0.5%: - -.. only:: html - - .. csv-table:: - :align: center - :file: performance_improvements/performance_improvements_pdr_top.csv - -.. only:: latex - - .. raw:: latex - - \makeatletter - \csvset{ - perfimprovements column width/.style={after head=\csv@pretable\begin{longtable}{ m{1.5cm} m{4cm} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1}}\csv@tablehead}, - } - \makeatother - - {\tiny - \csvautobooklongtable[separator=comma, - respect all, - no check column count, - perfimprovements column width=1cm, - late after line={\\\hline}, - late after last line={\end{longtable}} - ]{../_tmp/src/vpp_performance_tests/performance_improvements/performance_improvements_pdr_top.csv} - } - - -Measured improvements are in line with VPP code optimizations listed in -`VPP-17.10 release notes -`_. - -Other Performance Changes -------------------------- - -Other changes in measured packet throughput, with either minor relative increase -or decrease, have been observed in a number of CSIT |release| tests listed -below. Relative changes are calculated against the test results listed in CSIT -|release-1| report. - -NDR Throughput -~~~~~~~~~~~~~~ - -Non-Drop Rate Throughput discovery tests: - -.. only:: html - - .. csv-table:: - :align: center - :file: performance_improvements/performance_improvements_ndr_low.csv - -.. only:: latex - - .. raw:: latex - - \makeatletter - \csvset{ - perfimprovements column width/.style={after head=\csv@pretable\begin{longtable}{ m{1.5cm} m{4cm} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1}}\csv@tablehead}, - } - \makeatother - - {\tiny - \csvautobooklongtable[separator=comma, - respect all, - no check column count, - perfimprovements column width=1cm, - late after line={\\\hline}, - late after last line={\end{longtable}} - ]{../_tmp/src/vpp_performance_tests/performance_improvements/performance_improvements_ndr_low.csv} - } - - -PDR Throughput -~~~~~~~~~~~~~~ - -Partial Drop Rate thoughput discovery tests with packet Loss Tolerance of 0.5%: - -.. only:: html - - .. csv-table:: - :align: center - :file: performance_improvements/performance_improvements_pdr_low.csv - -.. only:: latex - - .. raw:: latex - - \makeatletter - \csvset{ - perfimprovements column width/.style={after head=\csv@pretable\begin{longtable}{ m{1.5cm} m{4cm} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1} m{#1}}\csv@tablehead}, - } - \makeatother - - {\tiny - \csvautobooklongtable[separator=comma, - respect all, - no check column count, - perfimprovements column width=1cm, - late after line={\\\hline}, - late after last line={\end{longtable}} - ]{../_tmp/src/vpp_performance_tests/performance_improvements/performance_improvements_pdr_low.csv} - } - - -Known Issues ------------- - -Here is the list of known issues in CSIT |release| for VPP performance tests: - -+---+-------------------------------------------------+------------+-----------------------------------------------------------------+ -| # | Issue | Jira ID | Description | -+---+-------------------------------------------------+------------+-----------------------------------------------------------------+ -| 1 | Vic1385 and Vic1227 low performance. | VPP-664 | Low NDR performance. | -| | | | | -+---+-------------------------------------------------+------------+-----------------------------------------------------------------+ -| 2 | Sporadic NDR discovery test failures on x520. | CSIT-750 | Suspected issue with HW combination of X710-X520 in LF | -| | | | infrastructure. Issue can't be replicated outside LF. | -+---+-------------------------------------------------+------------+-----------------------------------------------------------------+ -| 3 | VPP in 2t2c setups - large variation | CSIT-568 | Suspected NIC firmware or DPDK driver issue affecting NDR | -| | of discovered NDR throughput values across | | throughput. Applies to XL710 and X710 NICs, x520 NICs are fine. | -| | multiple test runs with xl710 and x710 NICs. | | | -+---+-------------------------------------------------+------------+-----------------------------------------------------------------+ -| 4 | Lower than expected NDR throughput with | CSIT-569 | Suspected NIC firmware or DPDK driver issue affecting NDR and | -| | xl710 and x710 NICs, compared to x520 NICs. | | PDR throughput. Applies to XL710 and X710 NICs. | -+---+-------------------------------------------------+------------+-----------------------------------------------------------------+ - +Release Notes +============= + +Changes in |csit-release| +------------------------- + +#. VPP PERFORMANCE TESTS + + - **MRR Throughput**: MRR (Maximum Receive Rate) test code has now + configurable trial duration and number of consecutive executions. + Coverage of MRR tests has been extended across more test + scenarios. MRR tests are used for continuous performance trending + and for comparison between VPP releases. + + - **MLRsearch Throughput**: MLRsearch algorithm has been introduced + for all NDR and PDR throughput tests. All tests that previously + used binary search got converted to MLRsearch. Coverage of NDR/PDR + tests has been extended across more test scenarios. + + - **L2patch Tests**: Tests measure performance of VPP L2patch, the + fastest L2 forwarding path implemented in VPP, that cross-links + RX and TX of two physical interfaces. + + - **2-Node Tests**: A new baseline set of 2-node tests covering base + ip4, ip6, l2patch, l2bd, l2xc, running on new Xeon Skylake + testbeds. + + - **Generated tests**: Simplified and unified test structure, semi- + autogenerated by generator script. Test generator is currently + able to create test combinations with various frame size and + cores combinations. All existing test cases were converted to new + format. + + - **Simultaneous Multi-Threading**: SMT-aware detection of server + processor operation mode (HyperThreading enabled/disabled) with + associated compute resource configuration including thread + affinity, number of Rx queues and DPDK I/O mbufs. Tests are + automatically tagged during execution to indicate executed thread + configuration. + + - **Intel Xeon Skylake Support**: Support for 2-Node and 3-Node + physical testbed topologies based on the new SuperMirco servers + each with two Intel Xeon Skylake Platinum processors. Full + Ansible playbooks refactor for quick server (re)installation and + reference pointers of configuration. + +#. PRESENTATION AND ANALYTICS LAYER + + - **Performance trending**: Further improvements of continuous + performance trending, anomaly detection and analysis. + +#. TEST FRAMEWORK OPTIMIZATIONS + + - **General Code Housekeeping**: Ongoing RF keywords optimizations, + removal of redundant RF keywords. + +Known Issues +------------ + +List of known issues in |csit-release| for VPP performance tests: + ++---+-----------------------------------------+---------------------------------------------------------------------------------------------------------------------------------+ +| # | JiraID | Issue Description | ++===+=========================================+=================================================================================================================================+ +| 1 | `CSIT-570 | Sporadic (1 in 200) NDR discovery test failures on x520. DPDK reporting rx-errors, indicating L1 issue. | +| | `_ | Suspected issue with HW combination of X710-X520 in LF testbeds. Not observed outside of LF testbeds. | ++---+-----------------------------------------+---------------------------------------------------------------------------------------------------------------------------------+ +| 2 | `VPP-1361 | High failure rate of api call sw_interface_set_flags [admin-up|link-up]. | +| | `_ | Failure rate: 30-40% of tests failing due to interfaces not in link-up state after API call sw_interface_set_flags. | ++---+-----------------------------------------+---------------------------------------------------------------------------------------------------------------------------------+ +| 3 | `CSIT-1234 | VPP IPSecHW scale interface mode 1core, low NDR and PDR 64B throughput in 3n-hsw testbeds, in CSIT-18.07 vs. CSIT-18.04. | +| | `_ | ip4ipsecscale1000tnl-ip4base-int 1core CSIT-18.07/18.04 relative change: NDR -31%, PDR -32%, MRR -38%. | ++---+-----------------------------------------+---------------------------------------------------------------------------------------------------------------------------------+ +| 4 | `CSIT-1242 | VPP xl710 ip4base test 1core, low NDR and PDR 64B throughput in 3n-hsw testbeds, in CSIT-18.07 vs. CSIT-18.04. | +| | `_ | xl710 ip4base 1core CSIT-18.07/18.04 relative change: NDR -29%, high stdev. | ++---+-----------------------------------------+---------------------------------------------------------------------------------------------------------------------------------+ +| 5 | `CSIT-1243 | VPP nat44 base test 2core, low NDR and PDR 64B throughput in 3n-skx testbeds, compared to 3n-hsw testbeds. | +| | `_ | ip4base-nat44 2core 3n-skx/3n-hsw relative change: NDR -19%, PDR -22%. | ++---+-----------------------------------------+---------------------------------------------------------------------------------------------------------------------------------+ +| 6 | `CSIT-1244 | VPP lispip4 base test 2core, low NDR and PDR 64B throughput in 3n-skx testbeds, compared to 3n-hsw testbeds. | +| | `_ | ip4lispip4-ip4base 2core 3n-skx/3n-hsw relative change: NDR -11%, PDR -18%. | ++---+-----------------------------------------+---------------------------------------------------------------------------------------------------------------------------------+ +| 7 | `CSIT-1245 | VPP srv6proxy-stat and srv6proxy-masq, much higher NDR and PDR 78B throughput in 3n-hsw testbeds, in CSIT-18.07 vs. CSIT-18.04. | +| | `_ | Due to wrong test suite configuration in dynamic-proxy mode. Artefact of suite code refactoring. | ++---+-----------------------------------------+---------------------------------------------------------------------------------------------------------------------------------+