New upstream version 17.11-rc3

[deb_dpdk.git] / doc / guides / linux_gsg / sys_reqs.rst

diff --git a/doc/guides/linux_gsg/sys_reqs.rst b/doc/guides/linux_gsg/sys_reqs.rst
index eb8442c..3e7fe63 100644 (file)
--- a/doc/guides/linux_gsg/sys_reqs.rst
+++ b/doc/guides/linux_gsg/sys_reqs.rst
@@ -228,56 +228,3 @@ The mount point can be made permanent across reboots, by adding the following li
 For 1GB pages, the page size must be specified as a mount option::
 
     nodev /mnt/huge_1GB hugetlbfs pagesize=1GB 0 0
-
-Xen Domain0 Support in the Linux Environment
-~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-
-The existing memory management implementation is based on the Linux kernel hugepage mechanism.
-On the Xen hypervisor, hugepage support for DomainU (DomU) Guests means that DPDK applications work as normal for guests.
-
-However, Domain0 (Dom0) does not support hugepages.
-To work around this limitation, a new kernel module rte_dom0_mm is added to facilitate the allocation and mapping of memory via
-**IOCTL** (allocation) and **MMAP** (mapping).
-
-Enabling Xen Dom0 Mode in the DPDK
-^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
-
-By default, Xen Dom0 mode is disabled in the DPDK build configuration files.
-To support Xen Dom0, the CONFIG_RTE_LIBRTE_XEN_DOM0 setting should be changed to “y”, which enables the Xen Dom0 mode at compile time.
-
-Furthermore, the CONFIG_RTE_EAL_ALLOW_INV_SOCKET_ID setting should also be changed to “y” in the case of the wrong socket ID being received.
-
-Loading the DPDK rte_dom0_mm Module
-^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
-
-To run any DPDK application on Xen Dom0, the ``rte_dom0_mm`` module must be loaded into the running kernel with rsv_memsize option.
-The module is found in the kmod sub-directory of the DPDK target directory.
-This module should be loaded using the insmod command as shown below (assuming that the current directory is the DPDK target directory)::
-
-    sudo insmod kmod/rte_dom0_mm.ko rsv_memsize=X
-
-The value X cannot be greater than 4096(MB).
-
-Configuring Memory for DPDK Use
-^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
-
-After the rte_dom0_mm.ko kernel module has been loaded, the user must configure the memory size for DPDK usage.
-This is done by echoing the memory size to a memsize file in the /sys/devices/ directory.
-Use the following command (assuming that 2048 MB is required)::
-
-    echo 2048 > /sys/kernel/mm/dom0-mm/memsize-mB/memsize
-
-The user can also check how much memory has already been used::
-
-    cat /sys/kernel/mm/dom0-mm/memsize-mB/memsize_rsvd
-
-Xen Domain0 does not support NUMA configuration, as a result the ``--socket-mem`` command line option is invalid for Xen Domain0.
-
-.. note::
-
-    The memsize value cannot be greater than the rsv_memsize value.
-
-Running the DPDK Application on Xen Domain0
-^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
-
-To run the DPDK application on Xen Domain0, an extra command line option ``--xen-dom0`` is required.