#include <rte_ethdev_driver.h>
#include "base/ixgbe_api.h"
+#include "base/ixgbe_x550.h"
#include "ixgbe_ethdev.h"
#include "rte_pmd_ixgbe.h"
return 0;
}
+int __rte_experimental
+rte_pmd_ixgbe_upd_fctrl_sbp(uint16_t port, int enable)
+{
+ struct ixgbe_hw *hw;
+ struct rte_eth_dev *dev;
+ uint32_t fctrl;
+
+ RTE_ETH_VALID_PORTID_OR_ERR_RET(port, -ENODEV);
+ dev = &rte_eth_devices[port];
+ if (!is_ixgbe_supported(dev))
+ return -ENOTSUP;
+
+ hw = IXGBE_DEV_PRIVATE_TO_HW(dev->data->dev_private);
+ if (!hw)
+ return -ENOTSUP;
+
+ fctrl = IXGBE_READ_REG(hw, IXGBE_FCTRL);
+
+ /* If 'enable' set the SBP bit else clear it */
+ if (enable)
+ fctrl |= IXGBE_FCTRL_SBP;
+ else
+ fctrl &= ~(IXGBE_FCTRL_SBP);
+
+ IXGBE_WRITE_REG(hw, IXGBE_FCTRL, fctrl);
+ return 0;
+}
+
#ifdef RTE_LIBRTE_IXGBE_BYPASS
int
rte_pmd_ixgbe_bypass_init(uint16_t port_id)
return ixgbe_bypass_wd_reset(dev);
}
#endif
+
+/**
+ * rte_pmd_ixgbe_acquire_swfw - Acquire SWFW semaphore
+ * @hw: pointer to hardware structure
+ * @mask: Mask to specify which semaphore to acquire
+ *
+ * Acquires the SWFW semaphore and get the shared phy token as needed
+ */
+STATIC s32 rte_pmd_ixgbe_acquire_swfw(struct ixgbe_hw *hw, u32 mask)
+{
+ int retries = FW_PHY_TOKEN_RETRIES;
+ s32 status = IXGBE_SUCCESS;
+
+ while (--retries) {
+ status = ixgbe_acquire_swfw_semaphore(hw, mask);
+ if (status) {
+ PMD_DRV_LOG(ERR, "Get SWFW sem failed, Status = %d\n",
+ status);
+ return status;
+ }
+ status = ixgbe_get_phy_token(hw);
+ if (status == IXGBE_SUCCESS)
+ return IXGBE_SUCCESS;
+
+ if (status == IXGBE_ERR_TOKEN_RETRY)
+ PMD_DRV_LOG(ERR, "Get PHY token failed, Status = %d\n",
+ status);
+
+ ixgbe_release_swfw_semaphore(hw, mask);
+ if (status != IXGBE_ERR_TOKEN_RETRY) {
+ PMD_DRV_LOG(ERR,
+ "Retry get PHY token failed, Status=%d\n",
+ status);
+ return status;
+ }
+ }
+ PMD_DRV_LOG(ERR, "swfw acquisition retries failed!: PHY ID = 0x%08X\n",
+ hw->phy.id);
+ return status;
+}
+
+/**
+ * rte_pmd_ixgbe_release_swfw_sync - Release SWFW semaphore
+ * @hw: pointer to hardware structure
+ * @mask: Mask to specify which semaphore to release
+ *
+ * Releases the SWFW semaphore and puts the shared phy token as needed
+ */
+STATIC void rte_pmd_ixgbe_release_swfw(struct ixgbe_hw *hw, u32 mask)
+{
+ ixgbe_put_phy_token(hw);
+ ixgbe_release_swfw_semaphore(hw, mask);
+}
+
+int __rte_experimental
+rte_pmd_ixgbe_mdio_lock(uint16_t port)
+{
+ struct ixgbe_hw *hw;
+ struct rte_eth_dev *dev;
+ u32 swfw_mask;
+
+ RTE_ETH_VALID_PORTID_OR_ERR_RET(port, -ENODEV);
+ dev = &rte_eth_devices[port];
+ if (!is_ixgbe_supported(dev))
+ return -ENOTSUP;
+
+ hw = IXGBE_DEV_PRIVATE_TO_HW(dev->data->dev_private);
+ if (!hw)
+ return -ENOTSUP;
+
+ if (hw->bus.lan_id)
+ swfw_mask = IXGBE_GSSR_PHY1_SM;
+ else
+ swfw_mask = IXGBE_GSSR_PHY0_SM;
+
+ if (rte_pmd_ixgbe_acquire_swfw(hw, swfw_mask))
+ return IXGBE_ERR_SWFW_SYNC;
+
+ return IXGBE_SUCCESS;
+}
+
+int __rte_experimental
+rte_pmd_ixgbe_mdio_unlock(uint16_t port)
+{
+ struct rte_eth_dev *dev;
+ struct ixgbe_hw *hw;
+ u32 swfw_mask;
+
+ RTE_ETH_VALID_PORTID_OR_ERR_RET(port, -ENODEV);
+
+ dev = &rte_eth_devices[port];
+ if (!is_ixgbe_supported(dev))
+ return -ENOTSUP;
+
+ hw = IXGBE_DEV_PRIVATE_TO_HW(dev->data->dev_private);
+ if (!hw)
+ return -ENOTSUP;
+
+ if (hw->bus.lan_id)
+ swfw_mask = IXGBE_GSSR_PHY1_SM;
+ else
+ swfw_mask = IXGBE_GSSR_PHY0_SM;
+
+ rte_pmd_ixgbe_release_swfw(hw, swfw_mask);
+
+ return IXGBE_SUCCESS;
+}
+
+int __rte_experimental
+rte_pmd_ixgbe_mdio_unlocked_read(uint16_t port, uint32_t reg_addr,
+ uint32_t dev_type, uint16_t *phy_data)
+{
+ struct ixgbe_hw *hw;
+ struct rte_eth_dev *dev;
+ u32 i, data, command;
+
+ RTE_ETH_VALID_PORTID_OR_ERR_RET(port, -ENODEV);
+ dev = &rte_eth_devices[port];
+ if (!is_ixgbe_supported(dev))
+ return -ENOTSUP;
+
+ hw = IXGBE_DEV_PRIVATE_TO_HW(dev->data->dev_private);
+ if (!hw)
+ return -ENOTSUP;
+
+ /* Setup and write the read command */
+ command = (reg_addr << IXGBE_MSCA_DEV_TYPE_SHIFT) |
+ (dev_type << IXGBE_MSCA_PHY_ADDR_SHIFT) |
+ IXGBE_MSCA_OLD_PROTOCOL | IXGBE_MSCA_READ_AUTOINC |
+ IXGBE_MSCA_MDI_COMMAND;
+
+ IXGBE_WRITE_REG(hw, IXGBE_MSCA, command);
+
+ /* Check every 10 usec to see if the access completed.
+ * The MDI Command bit will clear when the operation is
+ * complete
+ */
+ for (i = 0; i < IXGBE_MDIO_COMMAND_TIMEOUT; i++) {
+ usec_delay(10);
+
+ command = IXGBE_READ_REG(hw, IXGBE_MSCA);
+ if (!(command & IXGBE_MSCA_MDI_COMMAND))
+ break;
+ }
+ if (command & IXGBE_MSCA_MDI_COMMAND)
+ return IXGBE_ERR_PHY;
+
+ /* Read operation is complete. Get the data from MSRWD */
+ data = IXGBE_READ_REG(hw, IXGBE_MSRWD);
+ data >>= IXGBE_MSRWD_READ_DATA_SHIFT;
+ *phy_data = (u16)data;
+
+ return 0;
+}
+
+int __rte_experimental
+rte_pmd_ixgbe_mdio_unlocked_write(uint16_t port, uint32_t reg_addr,
+ uint32_t dev_type, uint16_t phy_data)
+{
+ struct ixgbe_hw *hw;
+ u32 i, command;
+ struct rte_eth_dev *dev;
+
+ RTE_ETH_VALID_PORTID_OR_ERR_RET(port, -ENODEV);
+ dev = &rte_eth_devices[port];
+ if (!is_ixgbe_supported(dev))
+ return -ENOTSUP;
+
+ hw = IXGBE_DEV_PRIVATE_TO_HW(dev->data->dev_private);
+ if (!hw)
+ return -ENOTSUP;
+
+ /* Put the data in the MDI single read and write data register*/
+ IXGBE_WRITE_REG(hw, IXGBE_MSRWD, (u32)phy_data);
+
+ /* Setup and write the write command */
+ command = (reg_addr << IXGBE_MSCA_DEV_TYPE_SHIFT) |
+ (dev_type << IXGBE_MSCA_PHY_ADDR_SHIFT) |
+ IXGBE_MSCA_OLD_PROTOCOL | IXGBE_MSCA_WRITE |
+ IXGBE_MSCA_MDI_COMMAND;
+
+ IXGBE_WRITE_REG(hw, IXGBE_MSCA, command);
+
+ /* Check every 10 usec to see if the access completed.
+ * The MDI Command bit will clear when the operation is
+ * complete
+ */
+ for (i = 0; i < IXGBE_MDIO_COMMAND_TIMEOUT; i++) {
+ usec_delay(10);
+
+ command = IXGBE_READ_REG(hw, IXGBE_MSCA);
+ if (!(command & IXGBE_MSCA_MDI_COMMAND))
+ break;
+ }
+ if (command & IXGBE_MSCA_MDI_COMMAND) {
+ ERROR_REPORT1(IXGBE_ERROR_POLLING,
+ "PHY write cmd didn't complete\n");
+ return IXGBE_ERR_PHY;
+ }
+ return 0;
+}
Code Review / deb_dpdk.git / blobdiff