-/*-
- * BSD LICENSE
- *
- * Copyright(c) 2010-2014 Intel Corporation. All rights reserved.
- * All rights reserved.
- *
- * Redistribution and use in source and binary forms, with or without
- * modification, are permitted provided that the following conditions
- * are met:
- *
- * * Redistributions of source code must retain the above copyright
- * notice, this list of conditions and the following disclaimer.
- * * Redistributions in binary form must reproduce the above copyright
- * notice, this list of conditions and the following disclaimer in
- * the documentation and/or other materials provided with the
- * distribution.
- * * Neither the name of Intel Corporation nor the names of its
- * contributors may be used to endorse or promote products derived
- * from this software without specific prior written permission.
- *
- * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
- * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
- * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
- * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
- * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
- * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
- * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
- * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
- * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
- * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
- * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
+/* SPDX-License-Identifier: BSD-3-Clause
+ * Copyright(c) 2010-2014 Intel Corporation
*/
#include <stdio.h>
#define MEMPOOL_CACHE_SZ PKT_BURST_SZ
/* Number of RX ring descriptors */
-#define NB_RXD 128
+#define NB_RXD 1024
/* Number of TX ring descriptors */
-#define NB_TXD 512
+#define NB_TXD 1024
/* Total octets in ethernet header */
#define KNI_ENET_HEADER_SIZE 14
/* Options for configuring ethernet port */
static struct rte_eth_conf port_conf = {
.rxmode = {
- .header_split = 0, /* Header Split disabled */
- .hw_ip_checksum = 0, /* IP checksum offload disabled */
- .hw_vlan_filter = 0, /* VLAN filtering disabled */
- .jumbo_frame = 0, /* Jumbo Frame Support disabled */
- .hw_strip_crc = 1, /* CRC stripped by hardware */
+ .ignore_offload_bitfield = 1,
+ .offloads = DEV_RX_OFFLOAD_CRC_STRIP,
},
.txmode = {
.mq_mode = ETH_MQ_TX_NONE,
static int kni_change_mtu(uint16_t port_id, unsigned int new_mtu);
static int kni_config_network_interface(uint16_t port_id, uint8_t if_up);
+static int kni_config_mac_address(uint16_t port_id, uint8_t mac_addr[]);
static rte_atomic32_t kni_stop = RTE_ATOMIC32_INIT(0);
int ret;
uint16_t nb_rxd = NB_RXD;
uint16_t nb_txd = NB_TXD;
+ struct rte_eth_dev_info dev_info;
+ struct rte_eth_rxconf rxq_conf;
+ struct rte_eth_txconf txq_conf;
+ struct rte_eth_conf local_port_conf = port_conf;
/* Initialise device and RX/TX queues */
RTE_LOG(INFO, APP, "Initialising port %u ...\n", (unsigned)port);
fflush(stdout);
- ret = rte_eth_dev_configure(port, 1, 1, &port_conf);
+ rte_eth_dev_info_get(port, &dev_info);
+ if (dev_info.tx_offload_capa & DEV_TX_OFFLOAD_MBUF_FAST_FREE)
+ local_port_conf.txmode.offloads |=
+ DEV_TX_OFFLOAD_MBUF_FAST_FREE;
+ ret = rte_eth_dev_configure(port, 1, 1, &local_port_conf);
if (ret < 0)
rte_exit(EXIT_FAILURE, "Could not configure port%u (%d)\n",
(unsigned)port, ret);
rte_exit(EXIT_FAILURE, "Could not adjust number of descriptors "
"for port%u (%d)\n", (unsigned)port, ret);
+ rxq_conf = dev_info.default_rxconf;
+ rxq_conf.offloads = local_port_conf.rxmode.offloads;
ret = rte_eth_rx_queue_setup(port, 0, nb_rxd,
- rte_eth_dev_socket_id(port), NULL, pktmbuf_pool);
+ rte_eth_dev_socket_id(port), &rxq_conf, pktmbuf_pool);
if (ret < 0)
rte_exit(EXIT_FAILURE, "Could not setup up RX queue for "
"port%u (%d)\n", (unsigned)port, ret);
+ txq_conf = dev_info.default_txconf;
+ txq_conf.txq_flags = ETH_TXQ_FLAGS_IGNORE;
+ txq_conf.offloads = local_port_conf.txmode.offloads;
ret = rte_eth_tx_queue_setup(port, 0, nb_txd,
- rte_eth_dev_socket_id(port), NULL);
+ rte_eth_dev_socket_id(port), &txq_conf);
if (ret < 0)
rte_exit(EXIT_FAILURE, "Could not setup up TX queue for "
"port%u (%d)\n", (unsigned)port, ret);
kni_change_mtu(uint16_t port_id, unsigned int new_mtu)
{
int ret;
+ uint16_t nb_rxd = NB_RXD;
struct rte_eth_conf conf;
+ struct rte_eth_dev_info dev_info;
+ struct rte_eth_rxconf rxq_conf;
if (port_id >= rte_eth_dev_count()) {
RTE_LOG(ERR, APP, "Invalid port id %d\n", port_id);
memcpy(&conf, &port_conf, sizeof(conf));
/* Set new MTU */
if (new_mtu > ETHER_MAX_LEN)
- conf.rxmode.jumbo_frame = 1;
+ conf.rxmode.offloads |= DEV_RX_OFFLOAD_JUMBO_FRAME;
else
- conf.rxmode.jumbo_frame = 0;
+ conf.rxmode.offloads &= ~DEV_RX_OFFLOAD_JUMBO_FRAME;
/* mtu + length of header + length of FCS = max pkt length */
conf.rxmode.max_rx_pkt_len = new_mtu + KNI_ENET_HEADER_SIZE +
return ret;
}
+ ret = rte_eth_dev_adjust_nb_rx_tx_desc(port_id, &nb_rxd, NULL);
+ if (ret < 0)
+ rte_exit(EXIT_FAILURE, "Could not adjust number of descriptors "
+ "for port%u (%d)\n", (unsigned int)port_id,
+ ret);
+
+ rte_eth_dev_info_get(port_id, &dev_info);
+ rxq_conf = dev_info.default_rxconf;
+ rxq_conf.offloads = conf.rxmode.offloads;
+ ret = rte_eth_rx_queue_setup(port_id, 0, nb_rxd,
+ rte_eth_dev_socket_id(port_id), &rxq_conf, pktmbuf_pool);
+ if (ret < 0) {
+ RTE_LOG(ERR, APP, "Fail to setup Rx queue of port %d\n",
+ port_id);
+ return ret;
+ }
+
/* Restart specific port */
ret = rte_eth_dev_start(port_id);
if (ret < 0) {
return ret;
}
+static void
+print_ethaddr(const char *name, struct ether_addr *mac_addr)
+{
+ char buf[ETHER_ADDR_FMT_SIZE];
+ ether_format_addr(buf, ETHER_ADDR_FMT_SIZE, mac_addr);
+ RTE_LOG(INFO, APP, "\t%s%s\n", name, buf);
+}
+
+/* Callback for request of configuring mac address */
+static int
+kni_config_mac_address(uint16_t port_id, uint8_t mac_addr[])
+{
+ int ret = 0;
+
+ if (port_id >= rte_eth_dev_count() || port_id >= RTE_MAX_ETHPORTS) {
+ RTE_LOG(ERR, APP, "Invalid port id %d\n", port_id);
+ return -EINVAL;
+ }
+
+ RTE_LOG(INFO, APP, "Configure mac address of %d\n", port_id);
+ print_ethaddr("Address:", (struct ether_addr *)mac_addr);
+
+ ret = rte_eth_dev_default_mac_addr_set(port_id,
+ (struct ether_addr *)mac_addr);
+ if (ret < 0)
+ RTE_LOG(ERR, APP, "Failed to config mac_addr for port %d\n",
+ port_id);
+
+ return ret;
+}
+
static int
kni_alloc(uint16_t port_id)
{
conf.addr = dev_info.pci_dev->addr;
conf.id = dev_info.pci_dev->id;
}
+ /* Get the interface default mac address */
+ rte_eth_macaddr_get(port_id,
+ (struct ether_addr *)&conf.mac_addr);
+
+ rte_eth_dev_get_mtu(port_id, &conf.mtu);
memset(&ops, 0, sizeof(ops));
ops.port_id = port_id;
ops.change_mtu = kni_change_mtu;
ops.config_network_if = kni_config_network_interface;
+ ops.config_mac_address = kni_config_mac_address;
kni = rte_kni_alloc(pktmbuf_pool, &conf, &ops);
} else
Code Review / deb_dpdk.git / blobdiff