* @cliexend
*
* Example of how to enable range checking on TX:
- * @cliexcmd{set interface ip source-and-port-range-check GigabitEthernet2/0/0 udp-in-vrf 7}
+ * @cliexcmd{set interface ip source-and-port-range-check GigabitEthernet2/0/0
+ * udp-in-vrf 7}
*
* Example of graph node after range checking is enabled:
* @cliexstart{show vlib graph ip4-source-and-port-range-check-tx}
* interface-output [1]
* @cliexend
*
- * Example of how to display the features enabed on an interface:
+ * Example of how to display the features enabled on an interface:
* @cliexstart{show ip interface features GigabitEthernet2/0/0}
* IP feature paths configured on GigabitEthernet2/0/0...
*
* @cliexstart{show ip source-and-port-range-check vrf 7 172.16.2.0}
* 172.16.2.0: 23 - 101
* @cliexend
- * Example of how to test to determine of a given Pv4 address and port
+ * Example of how to test to determine of a given iPv4 address and port
* are being validated:
* @cliexstart{show ip source-and-port-range-check vrf 7 172.16.2.2 port 23}
* 172.16.2.2 port 23 PASS