This should reduce number of "link down" failures dramatically.
The exact mechanism is not clear, but l2xc suites do not fail that much.
Change-Id: Ie102d90a58561121695c9938679ce0d3ee6a874f
Signed-off-by: Vratko Polak <vrpolak@cisco.com>
| | ... | maximal MTU.*
| | ...
# TODO: Rework KW to set all interfaces in path UP and set MTU (including
| | ... | maximal MTU.*
| | ...
# TODO: Rework KW to set all interfaces in path UP and set MTU (including
-# software interfaces. Run KW at the end phase of VPP setup to split
+# software interfaces. Run KW at the start phase of VPP setup to split
# from other "functial" configuration. This will allow modularity of this
# library
| | ${duts}= | Get Matches | ${nodes} | DUT*
# from other "functial" configuration. This will allow modularity of this
# library
| | ${duts}= | Get Matches | ${nodes} | DUT*
| | ... | Setup L2 patch topology by cross connecting two interfaces on
| | ... | each DUT. Interfaces are brought up.
| | ...
| | ... | Setup L2 patch topology by cross connecting two interfaces on
| | ... | each DUT. Interfaces are brought up.
| | ...
+| | Set interfaces in path up
| | ${duts}= | Get Matches | ${nodes} | DUT*
| | :FOR | ${dut} | IN | @{duts}
| | | Configure L2patch | ${nodes['${dut}']} | ${${dut}_if1} | ${${dut}_if2}
| | ${duts}= | Get Matches | ${nodes} | DUT*
| | :FOR | ${dut} | IN | @{duts}
| | | Configure L2patch | ${nodes['${dut}']} | ${${dut}_if1} | ${${dut}_if2}
-| | Set interfaces in path up
| Initialize L2 xconnect in 2-node circular topology
| | [Documentation]
| Initialize L2 xconnect in 2-node circular topology
| | [Documentation]